measuring repeatability 中文意思是什麼

measuring repeatability 解釋
測量重復性
  1. At last, the testing experiments are done to check out the testing system. the result of the experiments indicates that the measuring accuracy grade is b to the gjb3370 - 98 standard. and the non - repeatability errors of the amplitude wide and the phase wide are both less than 10 %

    分析結果表明:測試系統達到gjb3370 - 98的測量精度b級要求;動態性能測試中幅頻寬和相頻寬的測量不重復性誤差小於10 % ，滿足測試系統提出的要求。
  2. The impulse mode can efficiently reduce the coil heat and measurement error. two measuring methods for the micro - displacement are explored in this paper, and the conclusion is drew that the lever measurement can remarkably improve the result precision. the maximal displacement output of the fabricated actuator is 30 - 40 ju m, the displacement resolution is better than 30nm and the repeatability is nm,

    所研製磁致伸縮型納米微位移致動器，其最大位移輸出范圍： 30 ? 40 m ；最小位移解析度： 30nm ；重復精度： 2nm ，而且整個致動器省棄了復雜的水冷裝置，簡化了結構，縮小了尺寸，顯示了良好的應用前景。
  3. The measurement of dielectric loss and volume resistivity is effective preventive tests to judge insulating oil isolation status of polluted and aging, and it ' s important method of ensuring the safe operation of transformer and oil - filled circuit breaker, etc. however, the measuring systems of insulating oil dielectric loss and volume resistivity used at present exist the shortcoming of low accuracy, weak repeatability, inconvenience, and its thermostatic control system ca n ' t meet the challenge

    絕緣油的介質損耗因數、體積電阻率測量，是判斷絕緣油的劣化與污染程度的有效預防性試驗，是保障變壓器、油斷路器等充油電力設備安全運行的重要手段。然而，目前所使用的絕緣油介質損耗因數、體積電阻率測試系統存在著測量精度低、測量結果重復性不好、控溫系統不能滿足控溫要求、操作不便等缺陷，針對這一現狀，本文對絕緣油介損及體積電阻率一體化測試系統進行了研究。
  4. The contactless hall effect - based measuring principle gives the pressure switch extremely good repeatability and longevity, even with extremely high load change frequencies. the adjusting screws allow the switching points of the magswitch

    符合無觸點霍耳效應測量原理使得這種壓力開關即使在極高負載變化頻率條件下也具有卓越的可重復性和壽命。
分享友人
分享到 Line

分享到臉書