micro-x-ray diffraction 中文意思是什麼

micro-x-ray diffraction 解釋
微焦x射線衍射
  • micro : n. ,adj. 〈美口〉1. 微型電腦(的)。2. 特超短裙(的)。
  • x : X2= (羅馬數字)10 XX = 20 IX = 9 XV = 15 XL = 40 LX = 60 XC = 90 DXL = 540 MX = 1010 =...
  • ray : n 雷〈姓氏,男子名, Raymond 的昵稱〉。n 1 光線,射線,熱線;〈詩〉光輝,閃爍,曙光,一線光明。2 ...
  • diffraction : 分解
  1. Four kinds of c / c composites with different preparation techniques were graphitized at 2400 - 2880. the relations between magneto - resistance and orientation ( the angle between surface of samples and magnetic field ), measure temperature, the intensity of magnetic field ( b ) were studied for each sample. the micro - structure and x - ray diffraction pattem were investigated too

    本論文在對制備工藝不同的四種碳/碳復合材料樣品進行2400 2880的石墨化處理后,應用ppms ( physicalpropertymeasurementsystem )研究了測試位向(試樣某特定面和磁場方向夾角) 、測量溫度以及外加磁強對材料磁電阻特性的影響,同時研究了各試樣的微觀結構和x射線衍射譜圖。
  2. Dsc and x - ray diffraction results show that after pan - milling, the crystallinity and the size of micro crystals of pa6 decrease. melting point increases and crystallization temperature decreases

    表現為結晶度降低,微晶尺寸減小;熔融溫度降低,結晶溫度升高;球晶尺寸減小。
  3. Through experimental detection methods of macro inspection, chemical composition analyzing, mechanic performance testing, micro metallography analyzing and x ray diffraction, the blowout reasons of low - temperature superheater tube were analyzed in the process of boiler operation

    摘要通過宏觀檢查,化學成分分析,機械性能測試,金相檢驗和x射線衍射等試驗檢測方法,對鍋爐運行過程中低溫段過熱器管爆裂原因進行了分析。
  4. In the second chapter, during the study of compound x - ray refractive lenses, diffraction function of compound lens is derived in the light of refraction and absorption effect and the design theory of x - ray is deduced using diffraction theory in connection with the characteristic of x - ray band. the structure design of this device and micro - machined technique are also discussed

    在第二章x射線聚焦組合透鏡的研究中,針對x射線波段的特性,綜合考慮折射和吸收效應得出組合透鏡的衍射屏函數,利用衍射理論推導出x射線聚焦組合透鏡的設計理論並進行結構設計與微細加工製作技術研究。
  5. Our experiments emphasized the correlation between micro structures and some properties of the coatings and tried to obtain the protective coatings with the comprehensively good properties, in which auger electron spectroscopy ( aes ), scanning electron microscope ( sem ), and x - ray diffraction ( xrd ) were employed to investigate the composition, microstructure and crystal phase of the coatings respectively, and the properties test was primarily considered with the wear resistance and corrosion resistance of the coatings

    本論文主要採用pvd技術中的磁控濺射鍍膜( ms或rms )及部分用等離子噴塗( ps )和熱氧化( to )表面處理技術研究了鈾的具有代表性的三種防腐保護鍍層,即單質al 、氧化物al _ 2o _ 3和合金al - zn鍍層。實驗力圖在制備技術、工藝參數及鍍層的微結構和性能之間找到一些內在的聯系,探索綜合性能較好的防腐蝕鍍層。
  6. Powder x - ray diffraction analysis and micro - raman spectra were used to study the mineral composition of chinese freshwater cultured pearls from zhuji, zhejiang province

    摘要採用粉末x射線衍射分析及顯微激光拉曼光譜對三角帆蚌養殖珍珠的礦物組成進行了研究。
  7. In the present research, scanning electron microscope ( sem ), laser raman spectroscopy ( lrs ), x - ray photoelectron spectroscopy ( xrs ), x - ray diffraction ( xrd ) and electron probe micro analysis ( epma ) were utilized to investigate the difference in micro - structure and elements distribution between domestic and foreign pdcs. combined with analysis on current manufacturing process, the mechanism for the difference was discussed. scanning electron microscope ( sem ), laser granularity analysis, atom emission spectroscopy ( aes ) and plasma emission spectroscopy ( icpaes ) are also utilized to investigate the grain shape and impurities of key material - diamond power

    本課題採用掃描電鏡、拉曼光譜、光電子能譜、 x -射線衍射分析、電子探針等方法分析了國內外聚晶金剛石-硬質合金復合片在微觀組織結構、元素成分分佈方面的差異,結合對現有燒結工藝的分析,研討了造成這些差異的機理;採用掃描電子顯微鏡、激光粒度分析、原子發射光譜、等離子發射光譜等方法對關鍵原材料-金剛石微粉的晶形、雜質含量進行了比較分析測試。
  8. During the research, we used the diffraction of x - ray. sem ( scanning electron microscope ), electron micro - probe, petrographic analysis, cements physical performance test, adiabatic test, concrete test and so on, also, we gave explanations to all kinds of expansion phenomenon

    本課題在研究過程中採用了x ?射線衍射掃描電子顯微鏡、電子探針、 x ?熒光分析、巖相分析、水泥物理性能試驗、絕熱試驗、混凝土試驗等手段,對各種膨脹現象作出了解釋。
  9. Supported financially by the national natural science foundation of china, employing the testing techniques such as optical metallography analysis, scanning electron microscope ( sem ), electron microprobe scanning microscope ( emsm ), transmission electron microscope ( tem ), x - ray diffraction ( xrd ) and mechanical performance measurements ( including micro - yield strength mys ) etc., this research has worked comprehensively and deeply on a very important issue ? the micro - yielding behavior and mechanism of beryllium material for inertial guidance instruments and optical mirrors ? which has been paid more attention to by designers since the 8th even the 7th five - year plan

    在國家自然科學基金資助下,本研究採用光學金相顯微鏡,掃描電鏡( sem ) 、電子探針( emsm ) 、透射電鏡( tem ) 、 x射線衍射( xrd ) 、力學性能(包括微屈服強度_ ( mys ) )等測試技術,較詳盡和深入地研究了「七五」 、 「八五」計劃期間用戶一直希望解決的慣性導航和光學鏡體鈹材一個十分重要的問題:微屈服行為及機理。
  10. Based on these results, main attentions are paid to the microstructure of nacre according to the study of x - ray diffraction m scanning electron microscopy, transmission electron microscopy and micro - raman spectra, and attentions also to the organic matrix especially the carotenoids in nacre according to in situ study of resonance raman spectra

    在此基礎上,重點採用x -射線衍射、掃描電子顯微鏡、透射電子顯微鏡及顯微拉曼光譜等對珍珠層的微結構進行了較詳細的研究,同時採用拉曼光譜對珍珠層中的有機質特徵進行了原位分析研究。
  11. Abstract : the microstructure of as - cast high cr injection micro - alloying martensitic cast iron and the substructure of martensite in it have been observed under sem and tem. the alloying element distribution related to phase formation, as well as the various types of branch and distortion of carbide in the martensitic cast iron have been explored by using x - ray diffraction and electron probe analysis

    文摘:應用掃描電鏡和透射電鏡研究了噴射微合金化的鑄態馬氏體高鉻鑄鐵顯微組織及馬氏體的亞結構,並藉助x射線衍射與電子探針分析探討了合金元素的分佈與相形成的關系,以及碳化物的不同形式分枝與畸變。
  12. The physical properties were measured using x ray diffraction analyzing, sem observing, fracture toughness and fracture strength measuring, micro - hardening and density detection etc. the results display that the relative densities are above 98 % for all the samples, especially reaches 99. 8 % for the sample added 2vol % sic nano - particles

    在sic加入量為2vol %時,由於分散比較均勻,對樣品燒結性能影響不大,相對密度可達99 . 8 % 。在未加sic時,四方zro2的含量最高為50 . 5vol % 。隨sic加入量的增加,四方相zro2的含量呈下降趨勢。
分享友人