nanocomposite 中文意思是什麼

The main points of this thesis are summarized as follows : 1. a new nanocomposite was developed by combination of prussian blue ( pb ) nanoparticles and multiwalled carbon nanotubes ( mwnts ) in the matrix of biopolymer chitosan ( chit )

本文開展的具體研究工作如下: 1 .將普魯士藍（ pb ）納米顆粒和mwnts分散在殼聚糖（ chit ）基底中，形成了一種新的納米復合材料。

Glucose biosensors were then constructed by these nanocomposites, and their electrochemical properties had been explored. secondly, the self - assembled nanocomposite was formed by mwnts and biopolymer, and was used to study the electrochemical properties of nadh. and finally, the modified electrode which was formed by immobilizing small molecular onto electrode surface, was used to detect dsdna in the solution

本論文首先，將多壁碳納米管（ mwnts ）與納米顆粒相結合，制備的納米復合材料用於構建葡萄糖生物傳感器，並研究了它的電化學性質;然後，將mwnts與生物聚合物自組裝制備的納米復合材料用於研究nadh的電化學性質;最後，本文還將小分子自組裝固定在電極表面，用於測定溶液中的dsdna 。

3. studies of photovoltage properties about semiconductor nanoparticles in atmosphere and ethanol we have successfully synthesized a - fe2o3 nanoparticles and a - fe2o3 / sno2 nanocomposite oxide with sol - gel method

3 .空氣氣氛、真空條件下半導體納米材料的光伏性質研究採用溶膠一凝膠法制備了a一fez仇納米粒子以及sno :和。

Studies of photoelectric property about nanocomposite oxide with sno2 and a - fe2o3 using sol - gel method we prepared nanocomposite oxide with sno2 and a - fe2o3, we analyzed it ' s property with xrd uv spectra surface photo voltage spectra ( sps ) and field induced surface photovoltage spectra ( fisps )

一fez仇復合氧化物納米粒子，並用xrd 、紫外可見吸收光譜、表面光電壓譜（ sps ）以及場誘導表面光電壓譜（ fisps ）進行了分析和表徵。

Study on thermal stability pmma montmorillonite nanocomposite

2復合介質陶瓷微波性能影響的研究

Photocatalytic degradation of p - nitroaniline over zno - sno2 nanocomposite oxide photocatalyst

2納米復合氧化物光催化劑催化降解對硝基苯胺

Fourth, the electrorheoldgical fluids composed of pan / batio3 nanocomposite and chlorated paraffin oil are prepared and the relationship between dielectric performance and electrorheological effect are discussed. fifth, the advantage and disadvantage of electrorheological fluids composed of different structure pan - batio3 nanocomposite are compared, which put a favorable basis for farther design and prepare electrorheological fluid with high performance

研究結果表明：鈦酸鋇納米粉末在900處理時為最佳，隨熱處理溫度的升高，粒徑長大，而其介電常數隨著粒徑長大，逐漸降低，在相同條件下，隨溫度的升高，鈦酸鋇納米粉末的介電常數在120出現最大值。

Nanocomposite nd - fe - b magnets a new trend of permanent magnets

磁體永磁材料發展新方向

The xrd results confirmed that the nanocomposite oxide has two kinds of material with sno2 and a - fe2o3 ; the uv spectra has more variety with the proportion changing of the two kinds oxide ; the fisps indicated that photoelectric property increased with the adding positive electricity field, and the biggest strength could reach 50 ~ 60 times. with an increment for negative electricity field, the photoelectric property reduced largely

Xrd結果證實了所制備的納米粒子為兩種材料的復合氧化物;紫外可見吸收隨兩種氧化物復合比例的改變有較大的變化; fisps表明復合材料的光伏響應強度隨所加正電場的增加而增加，最大強度可增加50 ~ 60倍，隨所加負電場的增加而大大減弱。

Preparation and characterization of sio2 prussian blue nanocomposite microspheres

普魯藍酶在木薯粉酒精生產中的應用研究

The results from x - ray diffraction demonstrated that pp / mmtome was a fully intercalated nanocomposite, pp / mmtom and pp / ommt were partly intercalated nanocomposites, but the intercalation effect of pp / mmtom nanocomposite was better ; the crystallization characteristics of pure pp and pp / mmt nanocomposites were investigated by dsc, waxd and pom. the result of these testing showed that mmt nano - layers acted as nucleating agents for the crystallization of pp, the addition of mmt had effect on the crystallization process, leading the increasing of crystallization temperature crystallization rate and crystallinity, but also the dimension of spherulite reduced. but the formation of pp crystal did n ' t change, the formation of pp crystal in three pp / mmt nanocomposites and pure pp were a - form on the whole ; influences of three sorts of mmt on mechanical properties of pp / mmt nanocomposites were studied, as a result, the addition of mmt comprehensively improved mechanical properties of pp : notched impact strength, tensile strength and flexural properties were all increasing, but the extent of increasing were n ' t large

通過xrd分析比較這三種pp mmt納米復合材料微觀結構得到， pp mmt _ （ ome ）屬于完全插層， pp mmt _ （ om ）與pp ommt的插層程度相近，但是pp mmt _ （ om ）相對較好；通過對純pp和三種pp mmt納米復合材料的結晶性能研究發現，蒙脫土納米片層對pp結晶產生明顯的異相成核作用，結晶能力增強，使pp的結晶溫度和結晶速率提高，結晶度增加，球晶晶粒細化，但是沒有改變pp的結晶形態，三種pp mmt納米復合材料的結晶形態都屬于晶；通過對pp mmt納米復合材料的力學性能測試得知，蒙脫土的加入全面提高了pp的力學性能，缺口沖擊強度、拉伸強度和彎曲性能都有一定程度的提高，浙江{ _業大學碩十學位論文摘要但是提高幅度都不是很大，不過ommt 、 mmtom和mmtc ） me三種蒙脫土對pp力學性能有著不同的改性作用，其中pp / mmtom最好， pp月邊mto崛次之， pp / ommt最低，這種情況主要是由蒙脫土對pp結晶性能的影響和蒙脫土的納米改性作用造成的。

Tem images revealed that the phase morphology of pls composites were influenced by the interaction among the matrix, the compatibilizer and organo - mmt. hence, a novel mesophase " " silicate sheet cluster " was also found in ldpe / eaa / mmt nanocomposite. the mechanical, barrier and thermal properties results of ldpe / mmt composites indicated that,

對ldpe mmt納米復合材料的力學性能、透氣性能以及熱力學性能的研究結果表明，插層型或剝離型pls納米復合材料的力學性能取決于基體、相容劑在硅酸鹽片層表面的相容性。

The results show that the dynamic elastic modulus, loss modulus and complex viscosity of the nanocomposite are higher than those of pp, while the loss factor is lower, that the complex viscosity of the nanocomposites is more sensitive to temperature, and that the flow activation energy and the crystallization temperature increase respectively by 15 % and 10k as compared with pp, which may contribute to the enhanced interfacial interaction between pp and ommt resulting from the addition of tmpp

結果表明：與純聚丙烯相比，納米復合材料具有較高的動態彈性模量、損耗模量和復合粘度，力學損耗因子則降低，納米復合材料的復合粘度對溫度的敏感性略高於聚丙烯；界面改性劑的加入增強了有機蒙脫土與聚丙烯的界面作用，與聚丙烯相比，納米復合材料的流動活化能提高約15 % ，結晶峰溫度提高10k左右。

A new nanocomposite material for construction of glucose biosensor was proposed

組裝的多層膜用於研究nadh的電催化氧化。

Texture and magnetic domain of nanocomposite ndfeb permanent magnetic alloys

納米雙相釹鐵硼永磁合金的織構及磁疇

Isothermal and non - isothermal crystallization experiments conducted for the nanocomposite showed that addition of graphite nanosheets significantly changes the crystallization behaviors of the nylon 6 resin

復合材料體系的等溫及非等溫結晶實驗顯示，石墨納米薄片的加入顯著改變了尼龍6的結晶行為及結晶機理。

Results of the dsc analysis show that the addition of mcm - 41 do increase the rate of crystallization of pet. the crystallinity of pet / mcm - 41 nanocomposite is much higher compared with other fillers

實驗發現，介孔分子篩mcm對烈5o的填加量與pet共混后可明顯地增加pet的結晶速度。

At the existence of batio3, the pan / batio3 nanocomposite are prepared by in situ complex technology. the shape of complex is not regular and their mean size is in the range of 1 ~ 2 u m there are chemical bond between pan and batio3 in pan / batio3 nanocomposites, for the complex mechanism of pan with batio3 nanoparticles, first, there are complex between pan and batio3 nanoparticles. pan have the function of cohering batio3 nanoparticles

乃o3納米粒子的原位復合過程中，首先是an單體與batio3納米粒子相互作用，由於鈦酸鋇權于的存在，苯胺單體首先吸附在鈦酸鋇粒子表面，當過硫酸鉸加入溶液中時，聚合過程首先在這些氧化物的表面進行，這導致了聚合物對鈦酸鋇粒子的吸附及圍繞鈦酸鋇粒子的受限生長。

The influence of tmpp on the dynamic rheological behavior of the nanocomposite and the relationship between the rheological behavior and temperature were also investigated

用透射電鏡表徵了納米復合材料的結構，研究了接枝物對納米復合材料動態流變行為的影響，以及流變行為與溫度的關系。

Thermosetting resin / org - mmt nanocomposite, including exopy resin / org - mmt and phenolic resin / org - mmt, were prepared by in situ intercalation polymerization, and the intercalation and exfloliation behaviour of them were characterized by x - ray diffraction ( xrd ), dynamic mechanical thermal analysis ( dmta ), and different scanning calorimetry ( dsc )

採用原位插層聚合法通過澆模固化成型制備了熱固性樹脂蒙脫土納米復合材料，並用xrd ， dmta ， dsc等手段研究了熱固性樹脂與有機蒙脫土的插層與剝離行為，並對固化過程進行了理論預估。