ni-hand 中文意思是什麼

ni-hand 解釋
鎳硬（鑄鐵）
  • ni : 【化學】＝nickel 鎳。
  • hand : n 漢德〈姓氏〉。n 1 手；（猴子等的）腳；（一般四足獸的）前腳。2 （鐘表的）指針，（工具等的）把，...
  1. Nr ni vl satt ett coins bet nummer, kommer maskinen att anvnda detta vrde fr varje hand tills ni ndrar till ett nytt vrde

    若您的機器硬幣面值設置為5 ，您一次玩5個硬幣，就是一手牌下注25 。
  2. For the other hand, la2o3 additives can improve the activation process and discharge capacity obviously for zinc electrode. the appropriate content of la2o3 additives in zinc electrode can increase the electrochemical properties of the zinc electrode. zn / ni battery with the zinc electrode containing calcium additive showed better discharge capacity and charge - discharge cycling life

    以鋅酸鈣為活性物質的鋅電極能得到更高的鋅利用率，且以鋅酸鈣為活性物質的鋅鎳電池的循環壽命明顯優于以氧化鋅為活性物質的鋅鎳電池；兩層隔膜的鋅鎳電池的放電容量高於一層隔膜的鋅鎳電池，容量衰減速度也明顯小於後者。
  3. It was found that the interfacial bonding of 93w - ofc was both the joining action of ofc / w grains and that of ofc / ni - fe binders, whereas the joining of ofc to tc4 could be seen as the mutual intense diffusion effect between ofc / tc4 and as a result cu - ti intermetallic compounds were formed at the joint. the joining of tc4 - a1 and a1 - mb2 were also attributed to the result of diffusion between elements ti - al and al - mg respectively. on the other hand, residual thermal stress and stress - induced distortion were produced at the joint simultaneously due to the difference in thermal expansion coefficient of different welding " materials

    研究表明， 93w與ofc的界面連接是ofc與93w中w晶粒的連接以及ofc與93w中ni - fe粘接劑的連接共同作用的結果； ofc與tc _ 4連接界面的形成是由於ofc與tc _ 4之間發生反應擴散，並由此在二者接頭處生成了cu - ti金屬間化合物的中間相； tc _ 4 - al的連接與al - mb _ 2的連接則分別是其基體元素ti 、 al之間和al 、 mg之間元素互擴散的結果，另外，由於熱膨脹系數的差異，擴散焊接后在不同焊件的接頭處存在殘余熱應力並由此引起接頭的形變。
  4. As a result, the young ' s modulus of the composites decreased a little during the heating process, which indicated that ceramics were thermal stable. on the other hand, it decreased from ~ 280gpa to ~ 220gpa as ni - fe content was increased from 0 to 19vol. %. this is reasonable considering that the young ' s modulus of ni - fe is much lower than the matrix

    結果顯示，材料的楊氏模量隨溫度的升高而不斷減小，但減小的幅度很小，表明陶瓷材料穩定性很好；不同復合材料的楊氏模量隨ni - fe含量增加自280gpa減小到220gpa ，這應該是因為ni - fe合金的楊氏模量比基體氧化鋁的要小的緣故。
分享友人
分享到 Line

分享到臉書