noise figure characteristics 中文意思是什麼

noise figure characteristics 解釋
噪聲因數特性
  • noise : n 1 聲音,聲響。2 叫喊;嘈雜聲,噪音;喧鬧聲;吵鬧,騷動,騷擾。3 〈古語〉謠言,風聲。4 〈美國〉...
  • figure : n 1 外形,形狀,外觀;姿態。2 畫像,塑像。3 圖形,圖案;插圖;圖表。4 人影,人形;人物。5 風度,...
  • characteristics : 產品性能描述
  1. In order to measure the characteristics of such semiconductor optical amplifier, we adopted a set of measurement system. this measurement system can be used to measure the characteristics of all kinds of active or inactive optical passive components. such device presents good polarization insensitivity ( < 0. 9db ), wide 3db bandwidth ( > 33nm ) at 0 - 200ma and different input signal light wavelength and power, the maximum fiber - to - fiber gain of 10db, lossless operation current of 50 - 75ma for different input signal light wavelength and power, large extinction ratio ( > 50db ) and lower noise figure ( nf ) ( < 8db )

    與張瑞英博士一起,首次利用該種有源區結構制備出偏振不靈敏半導體光放大器,並在0 - 200ma注入電流范圍內獲得33nm的3db帶寬,在不同信號波長,不同信號功率0 - 200ma的注入電流范圍內,偏振相關損耗均《 0 . 9db ,在耦合差損為7db / facet的條件下,最大fiber - to - fiher增益達10db ,無損操作電流為50 - 70ma ,消光比達50db以上,而噪聲指數則低於8db ,最小可達4 . 6db 。
  2. A novel method based on a map of noise figure and gain is proposed to analyze efficiently the dependence of the noise figure and gain for edfas on the edf length and the pump power. the characteristics of various edfas are studied and compared. secondly, some important parameters are introduced to describe the characteristics of edfas

    文中從理論上系統分析設計了結構參數對各種edfa性能的影響,最後通過實驗驗證;第四,針對波分復用系統要求edfa必須具備增益鎖定功能,提出採用單根光纖光柵的方法來箝制l - bandedfa的增益。
  3. The methods and the experimental setups for measuring the gain and noise figure of an edfa are emphasized. we introduce how to measure the characteristics of each component of an edfa, especially the gain and absorption coefficient of an erbium doped fiber ( edf ). thirdly, four types of simple and novel l - band edfa structures with low noise, high gain and low gain ripple are proposed to satisfy the requirement of a dwdm system

    基於考慮自發輻射噪聲( ase )的giles模型,建浙江大學博士學位論文立了這種edfa的全光增益箱制理論模型;理論和實驗分析了四種可能的光路結構、泵浦波長、光纖光柵反射波長和反射率、泵浦功率以及摻餌光纖長度等參t對其箱制特性的影響。
分享友人