non-uniform stress 中文意思是什麼

non-uniform stress 解釋
不均勻應力
  • non : adv 〈拉丁語〉非，不是 （＝not）。 non assumpsit 【法律】被告否認契約的答辯。 non compos mentis ...
  • uniform : adj 1 （形狀、性質等）一樣的，同一的；一致的；相同的。2 一貫不變的；始終如一的。3 規格一致的，均...
  • stress : n 1 壓力，壓迫，緊迫，緊張。2 【語音】重音；重讀；【詩】揚音；語勢，著重點。3 重要（性），重點，...
  1. In the end, the mechanism of explosive accidents of lpg vessel under high temperature is analyzed. the major inducements of lpg vessel under high temperature are as follows : 1 ) sudden falling of pressure on valve opening ; 2 ) material strength falling of vessel wall, which is caused by high temperature of vessel wall ; 3 ) thermal stress that is caused by non - uniform temperature of vessel wall

    武漢理工大學碩士學位論文? ?論文最後分析了高溫環境下液化氣容器爆炸的事故機理，即高溫環境下液化氣容器爆炸的主要誘因為： 1 ）閥門打開時的壓力驟降； 2 ）容器壁溫度過高，導致容器壁的材料強度降低； 3 ）容器壁的溫度不均勻引起的熱應力。
  2. The stress and working pressure on teeth of the staged nut in screw presses has been studied by fem method which proves that using staged nut in screw presses is helpful for improving the non - uniform distribution of stress and working pressure on the teeth and extending the working life of the screw

    摘要採用了有限元法對滑動螺旋壓力機的階梯式螺母進行了受力分析，研究了螺母螺牙應力及螺牙工作面的接觸壓力，並將階梯式螺母與普通螺母進行對比，認為螺旋壓力機中使用階梯式螺母有利於改善螺牙牙根應力軸向應力分佈不均和螺牙工作面的接觸壓力分佈不均的情況，從而提高螺旋工作壽命。
  3. As for non - uniform horizontal ground stress, it is realized generally by applying non - uniform pressure load on the lateral boundary / boundaries of the calculation model

    對于非均勻的水平地應力，一般是在計算模型的側面邊界上施加非均勻荷載來實現。
  4. The influence of shearing deformation causes the non - uniform stress in the wing plate of the box girder, especially the cantilever box girder

    摘要剪切變形的影響使得箱形梁的翼板中出現應力不均勻現象，尤其是懸臂箱形梁剪力滯現象。
  5. Based on unified strength theory, the boundary line equation of surrounding rock mass plastic zone under non - uniform stress field was deduced, and it can be used to pre - estimate the dimensions and shapes of underground tunnel ' s plastic zone with different coefficients of horizontal pressure

    摘要基於統一強度理論，推導出非均勻應力場的巷道圍巖塑性區邊界線方程式，可用於預測不同側壓系數時地下深埋隧洞的塑性區大小及形狀。
  6. Stress calculation and stress distribution analysis of non - uniform beams

    變截面梁的應力計算及其分佈規律研究
  7. The contrasting analysis is carried out against approximate calculation, numerical simulation and the real measuring result of flow - in direction stress along the die - entrance in the rectangular drawing. it is considered that in the condition of non - uniform solution, part calculation has credibility to some extend

    摘要針對矩形盒拉深中凹模口流人方向應力的近似計算、數值計算和實際測量結果進行了比較分析，認為在尚未得到統一解的情況下，分割計算具有一定的可信度。
  8. ( 4 ) research on considering stress history and lateral deformation in 1 - d method for embankment settlement calculation. for av e ~ p method, the modification coefficient m, from influence of soil stress history is put forward. then, aimed at the e ~ lgp method and so on, by lots of nonlinear fem calculation, the different settlement revised formulas m2 are given for uniform and non - uniform roadbed cases

    針對以a _ v 、 e p法等，提出了可考慮土體應力歷史影響的修正系數m _ 1式子；接著，針對e - lgp法或進行了應力歷史影響修正後的a _ v 、 e p等，通過大量非線性有限元計算，分別給出均質路基和非均質路基的考慮土體側向變形影響的沉降修正系數m _ 2式子。
  9. However, it is found that there is a certain relationship between simulated result of non - uniform horizontal ground stress and geometrical shape of calculation model : the greater the width to height ratio of the calculation model is, the more unsatisfactory the simulation validity is and the greater the difference between practical ground stress and simulated stress is

    通過簡單模型的模擬試驗，發現採用這種應力邊界條件對水平地應力的模擬效果與計算模型的幾何形狀之間有一定的關系：計算模型的寬高比越大，模擬效果越不理想，與實際的地應力狀況相差越大。
  10. The tensile stress - strain curves of composites were also simulated. based on the energy equivalence principle, the formula that could predict the modulus of elasticity of sfrmmc was educed by considering the effects of thermal residual stresses and fiber ' s orientation. calculating and analysis indicate that the thermal residual stresses in sfrmmc are spatially non - uniform

    計算和分析表明，金屬基復合材料中熱殘余應力的分佈是空間不均勻的，對復合材料的力學行為產生明顯的影響，與不考慮熱殘余應力相比，其模擬的復合材料應力?應變曲線與實驗曲線吻合得較好。
  11. 3 ) based on the bond stress distribution function at the concrete - steel interface, a stress - strain relationship for cracked reinforced concrete tensile members is derived, and thereby an analytical model is proposed. by introducing a crack strength expression, the influence of non - uniform distribution of concrete stress in transverse and longitudinal directions in a reinforced concrete tensile member on concrete cracking is taken into account

    3 ）基於鋼筋混凝土間的粘結應力分佈函數，推導了開裂后的鋼筋混凝土軸拉構件的應力應變關系，建立了開裂分析模型，並通過引入鋼筋混凝土構件開裂強度表達式，考慮了混凝土應力在構件縱、橫兩個方向不均勻分佈對鋼筋混凝土構件開裂的影響。
分享友人
分享到 Line

分享到臉書