normal displacement 中文意思是什麼

normal displacement 解釋
法向位移
  • normal : adj 1 正常的，平常的，普通的；平均的。2 正規的，標準的，額定的，規定的。3 智力正常的，精神健全的...
  • displacement : n 1 轉位，移動；取代，置換；（人的）流離失所。2 撤換，免職。3 【機械工程】（活塞）排氣量；【航海...
  1. The vertical displacement =1mm is normal to the bars ab and bc and hence does not affect their length.

    豎向位移1mm垂直於AB和BC，故不影響它們的長度。
  2. In this thesis, four types of steel beam - rectangular cfst column connections, including normal welded flange plate ( wfp ) connection, bolted flange plate ( bfp ) connection, stiffened end plate ( sep ) connection and double split - tee plate ( dst ) connection, were designed based on the configuration of steel frame connection. total 8 models, 2 models of each kind of connections were tested under low - reversed cyclic loading at the end of cfst columns. the relationships between force and displacement at the end of columns, the relationships between the moment and rotation of the joints, degradations of strength and stiffness, ductility, failure mechanism and failure characteristics of these four connections under different axial - compression ratios were presented

    本文借鑒鋼框架節點構造，設計了四種類型矩形鋼管混凝土柱與鋼梁連接節點，包括常規栓焊（ wfp ）節點、翼緣全螺栓連接（ bfp ）節點、雙t板連接（ dst ）節點以及加勁端板連接（ sep ）節點，進行了四類節點8個模型試件在柱端低周反復荷載作用下的抗震性能試驗研究，比較了不同軸壓比下節點的滯回性能、強度與剛度退化、延性、破壞機理與破壞特徵，主要結論有： 1 、節點的位移滯回曲線與轉角滯回曲線為塊型分佈，沒有或略有捏攏現象，耗能能力強； 2 、軸壓比對節點滯回曲線有顯著影響，全部節點都有顯著的剛度退化； 3 、位移與轉角骨架曲線在峰值荷載後有較長的水平或下降段，具有良好的延性性能； 4 、從整體抗震性能上看，翼緣全螺栓連接節點、雙t板連接與加勁端板連接節點都優于常規栓焊節點，可在實際工程中加以推廣。
  3. The normal displacement was calculated to be just over 29, 000 tons.

    正常排水量剛剛超過29，000噸。
  4. Sudden rupture and displacement occurs with normal, reverse, strike-slip, or oblique-slip faulting.

    突然破裂和位移伴隨正、逆、走向滑動或斜向滑動斷層作用而發生。
  5. The numerical example shows that if we use the correct guess integral, this method will give right answer. it has good performance for both p - version and hybrid stress fem. last, a hybrid stress finite element with second stress completion is presented, which keeps the virtue of normal hybrid finite element, especially good for incompressble material, because it can avoid the self lock of displacement and instability of stress results

    第一部分還首次提出了一個滿足二次應力完備的雜交應力單元，它的應力滿足二次應力完備，而且通過巧妙的應力插值函數，避免了一般雜交應力元的矩陣求逆過程，而通常這個求逆過程都是很耗時的，這個二次應力完備雜交元保持了一般雜交元的優點，對于不可壓縮問題具有較好的性能。
  6. The relation between deformation of bar under normal force and node displacement is analyzed and applied to setting up compatibility equations of deformation for statically indeterminate problems

    摘要分析了軸向拉壓桿件的變形與桿端結點位移之間的關系，並將其應用於拉壓超靜定問題變形協調方程的建立。
  7. By it, the temperature and axial displacement on axes around the blades of the turbine can be measured. the advanced circuits monitor their change. if the temperature and displacement go beyond the normal range, the alert will be sent out, and they can be stopped and repaired " at that time

    渦輪機的工作環境惡劣，為克服環境給測量帶來的困難，採用非接觸式測量方法對渦輪機軸的溫度和渦輪機軸的軸向位移進行測量，採用精確的電路監控溫度和位移的變化，若溫度和位移超出其正常工作范圍，立刻發出警報，停止其工作以進行及時的修理。
  8. By means of chemical - displacement and orthogonal test method, the various technological parameters of the colorant for steel at normal temperature are determined. and simultaneously their effect regulation for steel of various state and constituent on coloring film quality are also discussed in detail. a new bronze - colored treating solution and technology for steel at normal temperature has been developed with stable and high quality performance

    運用化學置換法和正交試驗法測定常溫著色液的溫度、酸度、成分、含量等參數及其對不同狀態及成分的鋼鐵色膜質量的影響規律，研製出了一種性能優良的鋼鐵常溫古銅色處理液及處理新工藝。
  9. Abstract : by means of chemical - displacement and orthogonal test method, the various technological parameters of the colorant for steel at normal temperature are determined. and simultaneously their effect regulation for steel of various state and constituent on coloring film quality are also discussed in detail. a new bronze - colored treating solution and technology for steel at normal temperature has been developed with stable and high quality performance

    文摘:運用化學置換法和正交試驗法測定常溫著色液的溫度、酸度、成分、含量等參數及其對不同狀態及成分的鋼鐵色膜質量的影響規律，研製出了一種性能優良的鋼鐵常溫古銅色處理液及處理新工藝。
  10. The water displacement experiment of carboniferous gas showed that under normal pressure natural gas in subsurface reservoir is difficult to migrate into minor pores and displaced water out the pores in reservoir

    石炭系儲層氣驅水實驗表明，巖石滲透率與驅替后殘余水飽和度呈負相關指數關系。
  11. The angular displacement and angular velocity of the upper limb during elbow extension activities in spinal cord injury patients and normal individuals

    6脊髓損傷患者與正常人在伸肘活動中上肢的角位移及角速度比較
  12. Then, by analyzing the extensive test data of load - displacement and bear - curvature, we can conclude that the crack resistance, bearing capacity of normal section and short - dated rigidity will be improved a lot when the strength of concrete is not so low

    然後，通過對各組試件的荷載-撓度曲線的進一步分析表明：對于混凝土強度等級高於c15的鋼筋混凝土梁，採用這種粘角鋼加固法能有效提高鋼筋混凝土梁的正截面承載力和短期剛度。
  13. No bad effect on concrete strength is found within a certain range of amplitude. the ultimate loads of vibration members are not lower than those of normal ones am, when vibration frequency is below 40hz and maximum vertical displacement is within 0. 2mm

    在一定的振幅范圍內，對混凝土強度沒有不利影響，當激振頻率在40hz以下，最大豎向位移振幅在0 . 2mm以內，受振與非振構件相比較，其破壞荷載值沒有降低。
  14. Gram - schmidt method for zernike polynomials fit and singular value decomposition ( svd ) are concerned. the direction question for zernike polynomials fit is discussed and the surface error in the normal direction is deduced. to solve - the coupling and mixture of zernike polynomials fit method, rigid - body displacement is removed with coordinate transformation and then fitted with zernike polynomials

    介紹了zernike擬合的gram - schmidt以及奇異值分解兩種方法；論述了zernike擬合時的方向問題，計算了法線方向的面形誤差；針對zernike擬合時的藕合與混淆，採用先用齊次坐標變換去除剛體位移，再用奇異值分解進行zernike擬合。
  15. Since the common loads had little effects to the relative displacement of top floor in cshbb, so it was unnecessary to considering them in normal use ultimate state. thermal effects had no influence to the resist compression bearing capacity and resist shear bearing capacity, but had great

    溫度作用對砌體結構的抗壓和抗剪承載能力沒有影響，但對砌體結構的頂層山墻和外縱墻的彎曲抗拉承載能力起控製作用，需要考慮溫度作用和荷載的組合問題。
  16. At present the main product includes ： the resistance should the variant, the proliferation silicon, the ceramics and so on three big kind of high temperatures, center warm, the normal temperature table press, certainly press, sensor and so on negative pressure, fluid position, difference pressure, current capacity, name is heavy, measures strength, torque, displacement, temperature / changes delivering and the necessary control measuring appliance

    目前主要產品有：電阻應變式、擴散硅、陶瓷等三大類的高溫、中溫、常溫的表壓、絕壓、負壓、液位、差壓、流量、稱重、測力、扭矩、位移、溫度等傳感器/變送器和配套控制儀表。
  17. In this paper, three - tower building with name of oriental tunes square in xiamen is analyzed by the international current program sap2000, considering seismic action in two directions. by structural modeling and calculation, the characteristic of vibration of the multi - tower structure is analyzed, the influences of the rigid ratio of the enlarged base to top tower and translation - torsion coupled effects among several towers are investigated, the inter - story displacement, displacement of the top tower and deformation of tower ' s base floor in x and y major orientation under earthquake action are contrasted with those under wind load. at last, the distributing characteristics of stress of transfer plate and of the normal, shearing stress of mostly vertical elements under earthquake action are studied

    本文以具有3個塔樓的廈門東方時代廣場為分析對象，採用國際通用有限元分析軟體sap2000進行結構建模和分析，考慮雙向地震動輸入，研究結構的振動特性，分析底盤與塔樓剛度比對結構的影響以及多塔之間的扭轉效應和平扭耦聯作用，對比風荷載和地震作用下塔樓在兩個結構主軸方向的層間位移、頂點位移以及塔樓底層的變形，分析地震作用下轉換層樓板的應力分佈特點及主要豎向構件的正應力和剪應力分佈特點。
  18. Abstract : a previously proposed approximate quasi - static theoretical method is employed herein to examine the deformation and perforation of a simply - supported circular plate struck by a flat - faced projectile at normal incidence. based on the principle of virtual work, static load - displacement relationships are first obtained and then used to predict the energy - absorbing capacity of the plate subjected to relatively low speed impact. it is shown that good agreement is obtained between the theoretical predictions and the available experimental data, provided that adiabatic shear plugging failure does not occur, but the influence of strain rate sensitivity is taken into account

    文摘:採用準靜態近似理論方法分析簡支圓板在平頭彈丸正撞下的變形和穿透.首先基於虛功原理得到了靜態荷載位移關系，並將其用於預測低速沖擊下圓板的能量吸收能力.當考慮了材料的應變率敏感性，並且不發生絕熱剪切沖塞破壞的前提下，理論預測和實驗結果吻合良好
分享友人
分享到 Line

分享到臉書