oil water ratio 中文意思是什麼

oil water ratio 解釋
油水比
  • oil : n 1 油；油類；油狀物〈一般是不可數名詞，表示種類時則用 pl 如：vegetable and animal oils 植物油和...
  • water : n 1 水；雨水；露；〈常作 pl 〉 礦泉，溫泉；藥水。2 〈常 pl 〉水體；水域；水道；海；湖；河；海域；...
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. Cleanup corrosive substance in pipe such as internal water, clean oil, methane hydrate, ferric oxide, carbide dust, carbon bisulfide, hydrosulphurice acide, etc. ; reduce corrosion damages to inner wall of pipeline caused by corrosive substance ; clarify pipe route again ; inspect pipe deformation ; check perfectness ratio of valves along pipe ; decrease working backpressure

    清除管線內部積水、輕質油、甲烷水合物、氧化鐵、碳化物粉塵、二硫化碳、氫硫酸等腐蝕性物質；降低腐蝕性物質對管道內壁的腐蝕損傷；重新明確管線走向；檢測管線變形；檢查沿線閥門完好率；減小工作回壓。
  2. And the adsorbability of this novel adso rbent for ldl was determined. in order to prepare the solid supports in accordance with with the request of adsorbent for ldl, paam beads were synthesized by inverse suspension polymerization. the composition of the polymerization system is shown as follows : the concentration of monomer and dispersant are 12 % and 0. 65 % respectively, the volume ratio of oil / water isl : 3, the mole ratio of aam and mba is 18 : 1

    本文用反相懸浮聚合法合成符合ldl吸附劑載體要求的聚丙烯酰胺微珠，經實驗篩選出反應體系所需的最佳單體濃度（ 12 ） 、最佳分散劑用量（ 0 . 65 ） 、最佳油水比值（ 1 ： 3 ） 、最佳單體（ aam ）與交聯劑（ mba ）的物質的量之比（ 18 ： 1 ） 。
  3. The oil arising from oil water separation must be able to meet certain quality specifications before it can be mixed with bunker c fuel at a ratio of 9 to 1 by volume to form recycled fuel oil

    油水分隔處理后得出的油品，其品質必須符合一定的規格，才可以九比一的比例與Ｃ級重油混和，產生再造燃油。
  4. Because of the high ratio of sandstone in the shallow water and high ratio of mudstone in the deep water area, the hydrocarbon scattered into the sandstone more easily in the shallow water area, so large oil & gas fields appear to form more easily in the deep water area

    由於淺水區砂巖百分比含量高，砂體連通性好，油氣聚集比較分散，比較而言深水區油氣在扇體里富集程度較高，更有利於形成大油氣田。
  5. Based on physical simulation and numerical simulation, the conversion of hot water slug flooding with nitrogen foam is presented and some injection indices are optimized, including foam concentration, gas - liquid ratio, injection rate, temperature of water, slug length. from reservoir research and oilfield development, studying disadvantageous factors, the paper will have guilding value for heavy oil reservoir development of leng 43 block

    對熱水+氮氣泡沫段塞驅的關鍵技術指標，包括泡沫劑濃度、氣液比、注入速度、注水溫度和段塞長度等重要參數進行了優選，提出了注水速度80 100t d 、氣液比1 ： 1 、注水溫度95 100 、溶劑濃度0 . 5的推薦方案。
  6. South high temperature and wet climate easily leads asphalt pavement to water damage, this writer participated in the guangdong meihe highway asphalt pavement construction, mainly through the asphalt mixture marshall immersion test, splitting freeze - thaw test anylyze asphalt mixture types and asphalt content ' s influences to the water stability, and gives the linear fitting relationship about the soaking remnants stability and freeze - thaw splitting strength and oil - stone ratio. and water stable indicators and the oil - stone ratio ' s second linear fitting relationship, finally stressed asphalt and asphalt amount significance to water stability

    摘要通過瀝青混合料的浸水馬歇爾試驗、凍融劈裂試驗分析了瀝青類型及瀝青用量對瀝青混合料水穩定性的影響，並給出了浸水殘留穩定度與凍融劈裂強度與油石比的線性擬合函數關系，以及水穩性指標與油石比的二次函數關系，最後指出改性瀝青和瀝青用量對混合料水穩定性的意義。
  7. The theoretical study of the recovery percent vs. water cut of thin and bottom water reservoir in luliang oilfield is based on developing its geologic and flow models, obtaining oil - thickness ratio, oil - water viscosity ratio, relative permeability curve parameter and chart of effect of bottom water toning, etc., on water - yielding pattern of the reservoir

    摘要在建立了陸梁薄層底水藏地質及滲流模型基礎上，採用理論研究的方法，研究了薄層底水油藏采出程度與含水率關系式，並獲得了油厚比、油水粘度比、相滲曲線特徵參數以及底水錐進等對油藏產水規律的影響關系圖版。
  8. To meet the requirements of engineering and after reviewing the previous results, the author deeply researches measurement of water ratio in oil - water two phases system based on the principles to analyze two phases fluid. with present mature computer technology a system to measure water ratio in oil - water two phases is successfully developed and the procedure is worth introducing here according to the data from relative experiments

    本文從實際工程需要出發，查閱並繼承了前人研究的理論成果，運用兩相流動基本分析方法，進一步對油品含水測量進行深入研究，結合當前成熟的計算機技術，成功研製出將油品含水率測量系統。
  9. Abandonment water oil ratio

    廢棄水油比
  10. In the anaphase of development, the water content ratio is high in the reservoir, the microcosmic distributions among the formations are different. in order to get the situation of the remaining oil, the author applied fine numerical simulation methods to study every small layers about tuo28 down reservoir. because the characters about geology and liquid are different from past time, the change have been considered

    為進一步搞清坨28斷塊下油組各單元特高含水開發後期剩餘油在層間、層內的微觀分佈，本文重點介紹了精細數值模擬方法對下油組各小層的研究，與以往數值模擬研究不同的是，本次研究充分考慮了坨28斷塊的地質特點和流體特徵隨時間的變化，結合不同開發階段，建立了不同的模型，從而使研究結果更接近地下油藏實際。
  11. Abstract : the transformation of the flowmeter and the control valve for water and oil phase flow, the control devices for oil - water phase ratio and blast hole charge and other control devices has eliminated the distinct dificiencies in the quality control of on - site mixed loading car of emulsified explosive and realized its automatic control so as to improve the quality of the products of emulsion and emulsified explosive and their blasting effect

    文摘:從水相和油相流量的流量計、控制水相油相流量的流量控制閥、控制油相水相配比的配比控制裝置、炮孔裝藥量控制裝置以及其他控制裝置的改造入手，改變原有乳化炸藥現場混裝車質量控制上存在的明顯不足之處，實現乳化炸藥現場混裝車的自動控制，提高了生產乳膠及乳化炸藥的質量和爆破效果。
  12. The development of mass transfer in the system of vapor - liquid - liquid three - phase distillation from trays was introduced, the effects of the hydrodynamic conditions e. g. vapor velocity and ratio of liquid to vapor loading and physical properties of liquid phase, including surface tension, interfacial tension, viscosity or dispersion viscosity, density, relative volatility etc. and the volume ratio of oil to water on mass transfer were discussed systematically, the influence of the second liquid on mass transfer efficiency was also investigated, a gnat deal of viewpoints and suggestions having been put forward in this paper are significant important for optimizing design of distillation tower

    摘要介紹了氣液液三相精餾塔板傳質性能研究的進展情況，討論了氣速、液氣比等操作條件，表面張力、界面張力、液體的粘度或分散粘度、密度和相對揮發度等物系性質以及油水體積比等多種參數對傳質效率的影響，探討了第二液相的存在對傳質的影響，文中的許多觀點獲和建議對于優化精餾塔的設計具有重要的指導意義。
  13. The optimal preparing conditions were found to be as follows : the initial viscosity of cellulose xanthate ranging from 5, 000 to 8, 000 cst, the mixture of pump oil and chlorobenzene with a 6 : 1 mass ratio as disperse phase, the mass ratio of disperse phase to water phase at 6 : 1, the mixing speed at 350 ~ 400 rpm

    詳細研究了一些影響復合微球形成的因素，得到較優的工藝條件為：纖維素黃原酸酯粘膠粘度為5000 8000cst ，分散相為6 : 1 （ w w ）泵油和氯苯混合物，攪拌速度為350 400rpm 。
  14. 4. to have researched the dielectric constant changing rule of oil - water mixture when the ratio of oil - water changing and the design principle and mechanical design of capacitor sensor with dielectric constant changing

    4 、研究了油、水混合物介電常數隨油、水體積百分比的變化規律，以及變介電常數式電容傳感器設計原理及機械設計。
  15. Following are included in this thesis : 1. a brief introduction to the history, presentation and significance of measurement of water ratio in oil - water two phases system 2

    本文的主要內容包括： 1 、介紹了油品含水率測量手段的歷史、現狀，闡述了油品含水率測量意義。
  16. Taked ratio of joined water on emulsions, quantify on emulsification and different emulsified technics as factor, 10 %, 20 %, 30 % and 40 % ratio of joined water, 0. 5 % and 1 % quantify on emulsification, two kind of emulsified technics of diesel oil added emulsification and water added emulsification as level, emulsion of eight kind different mixing ratio that are performed through rig test and smoke test is prepared by using the method of orthogonal array

    以乳化油的摻水比例、乳化劑的添加量和不同的乳化工藝方法為因素，分別選擇10 、 20 、 30和40的摻水比例， 0 . 5和1的乳化劑添加量以及油+乳化劑和水+乳化劑兩種工藝方法為水平，採用正交試驗設計方案，配製了8種不同比例的乳化油，進行發動機臺架性能試驗和煙度檢測。
分享友人
分享到 Line

分享到臉書