optimization control 中文意思是什麼
optimization control
解釋
優化控制- optimization : n. 最佳化，最優化。
- control : n 1 支配，管理，管制，統制，控制；監督。2 抑制（力）；壓制，節制，拘束；【農業】防治。3 檢查；核...
-
Third, this thesis analyzes the angle - control theory based on half bridge converter, and proposes a new way to find the optimized angle. simulation is performed to verify the results. then, this thesis introduces the hardware and software design of the digital control system of doubly salient electro - magnetic motor, which mainly discusses the speed and current loops and angle optimization control
再次，本文介紹了角度控制與電機轉向的關系，並對基於半橋變換器的電勵磁雙凸極電動機換相角與相電流及輸出轉矩的關系進行了理論分析和模擬驗證，提出了優化電勵磁雙凸極電機換相角的方法。 -
Also, the author ’ s design strategy and creativity has been given in this paper. specifically, it includes : based on the feasibility analysis of the fit selection of control parameters in the aeration process, the aeration process of wastewater treatment of the joint - constructional complete - mixed activated sludge process has been aimed at in this paper. then, the state equations of the aeration process have been proposed in this paper, which is on the base of dissolved oxygen concentration ( do ) and discharge quantity of sludge ( qw ) as control variables, the concentration of bod and sludge as state variables. based on the present study on optimization control of wastewater treatment, the multivariable optimal control model with restriction factor has been presented in the paper with introducing modern control theory and system analysis into the field of activated sludge wastewater treatment,
具體包括:以完全混合、表面曝氣合建式活性污泥工藝的污水處理曝氣過程為研究對象，在闡述了曝氣過程式控制制參數選取可行性的基礎上，建立了以溶解氧濃度do和活性污泥排放量qw為控制變量，以曝氣池中有機物濃度s和微生物濃度x為狀態變量的活性污泥曝氣過程的基本狀態方程;運用現代控制理論的觀點和污水處理理論，在現有關于污水處理最優控制問題研究的基礎上，建立了有約束條件多變量能耗最小數學模型，該數學模型是以有機物排放總量和狀態變量的末值條件作為約束條件，曝氣過程的能耗最小作為目標泛函;採用增廣拉格朗日乘子法對最優控制問題進行轉化，並對應用極大值原理求解能耗最小這一最優控制問題進行了詳細的解析;引入約束運算元，應用具有控制約束的共軛梯度演算法對能耗最小這一最優控制問題進行求解，並進行模擬實驗驗證。 -
Intelligent optimization control of grate process centring on permeability
以透氣性為中心的鏈篦機過程智能優化控制 -
The hybrid genetic algorithms are employed to get the better optimization control law, and the problem of limited torque is solved by individual representation operation
為了獲得最優擺起控制序列，採用混合遺傳演算法進行優化計算，通過編碼操作解決控制力矩受限問題。 -
Simulation of these models is conducted and energy optimization control strategy to attain the goal that the parking equipment runs with low energy consumption and high efficiency is proposed
由此給出了車庫運行能耗的最優化控制決策，為車庫的低能耗運行提供了科學依據。 -
This new fuzzy optimization control method was applied to a superheated steam temperature control system, and simulation results verify the satisfactory closed - loop performance of the proposed fuzzy control system
將這種新型模糊優化控制方法應用於過熱汽溫控制系統進行模擬，結果表明可以獲得非常滿意的閉環控制效果。 -
In the third chapter, the measurement and control system are designed according the characteristics of the infrared drying instrument, can realize the temperature measurement and control of the infrared drying instrument. then, in view of the respective characteristic of the time optimization control, the pid control and the fuzzy control, a kind of control method based on complex is designed
第3章首先根據紅外乾燥箱的特點設計了其測控系統，可實現對紅外乾燥箱的溫度測量與控制;然後給出了溫度控制的方法，針對時間最優控制、 pid控制和模糊控制各自的特點，設計了一種基於時間最優模糊pid控制方法。 -
The integrated automation system based on intelligent technology was proposed innovatively, which consists of three layers : intelligent optimization control, process control and process management
針對上述問題，提出了基於生料漿工藝指標優化的配料過程綜合自動化系統。 -
This dissertation is devoted to the study on permanent magnet synchronous motor ( pmsm ) drive system in electric vehicle ( ev ) application aided by the state " 863 plan " and the science and technology items of liaoning province. four parts are included as follows : first of all, an efficiency - optimization control strategy for pmsm system used in ev is presented in order to extend road haul per charge
在國家863計劃「九五」重大項目「釹鐵硼電機應用產品開發」 、遼寧省科學技術計劃項目「高性能釹鐵硼永磁電機的研製」及沈陽市「十五」科技攻關項目資助下，本文研究工作圍繞電動汽車用永磁同步電動機（ pmsm ）傳動控制系統展開，研究內容分為以下四個部分：首先，為提高電動汽車一次充電續行里程，提出電動汽車用pmsm系統的效率優化控制策略。 -
Then according to the essential trial of electric drive system in electric vehicles ( evs ), it is built that the simulation model of induction motor drive system of evs in efficiency optimization control ( eoc ), which suits different motors for simulation and research concerning the running condition of evs. taking nonlinear saturation problem into consideration, simulation study on eoc is proceeded by using an actual motor acting as an example, comparison of eoc with classical u / f control mode is completed at the same time. it is analysed that the variation of losses and their distribution causing by eoc
聯系實際的應用背景，提出了電動車的最大效率控制問題。然後，從電動車電驅動系統的基本特性出發，建立了電動車工況下最大效率控制的感應電機驅動系統模擬模型，通過實例在飽和非線性的條件下進行了最大效率控制的模擬計算。針對感應電機損耗將最大效率控制產生的損耗變化及分佈規律進行了研究，對鐵心損耗的影響進行了分析。 -
What ' s main research of the thesis is to make some research, based on the basic thought of the satisfactory control, into some problems of satisfactory optimization control with fuzzy objective and fuzzy constrains in the complex industry process
本文基於滿意優化的基本思想，對復雜工業環境中存在模糊目標和模糊約束時的滿意優化控制問題進行了探索和研究。 -
The paper adopts the first advance scheme to realize the fuzzy optimization control of oil feeding pump system and eliminates the turbulence generated by changing control ways
最後採用第一種改進方案，實現了輸油泵系統的模糊優化控制，並且消除系統切換時的擾動。 -
In view of the operation characters of pmsm for ev application, a novel efficiency - optimization control strategy is presented to meet the demand of rapidity after analyzing the defect of efficiency - optimization control strategy of pmsm system with minimum input power in ordinary application. on the basis of ordinary efficiency - optimization control strategy with minimum input power, the new strategy adopts fuzzy logic control method and torque compensation strategy to accelerate convergence in process of optimizing controlled parameter
針對電動汽車的運行特點，在分析了一般應用的pmsm系統輸入功率最小效率優化策略不足的基礎上，為滿足電動汽車用pmsm系統效率優化的快速性要求，提出新的效率優化控制策略，其核心是在輸入功率最小效率優化方法基礎上應用模糊邏輯控制並採用轉矩補償策略加速系統控制變量尋優過程的收斂速度。 -
Dynamic optimization control of the effect on environment of tunnelling
隧道工程環境影響的動態優化控制 -
The multi - microcomputer control system and optimization control for nc of folding machine
數控折疊線多微機控制系統與優化控制 -
A kind of adaptive recursive optimization control algorithm of weighted generalized predictive control
一種加權廣義預測自適應遞推優化控制演算法 -
Study of efficiency optimization control of permanent magnet synchronous motor drives for electric vehicle
電動汽車驅動用永磁同步電動機系統效率優化控制研究 -
Provide hardware and software platform for fermentation process modeling and optimization control
為發酵過程建模及其優化控制的進一步研究提供了硬、軟體平臺。 -
The solution of the optimization control problem can be approached by a fuzzy control algorithm based on the pareto rule base
該多目標控制問題的最優解即最優控制函數，可利用基於該規則基的模糊控制演算法進行逼近。 -
For the design, operational analysis, optimization, control, and improvement of piping, it is necessary to combine the consideration of technology, energy and economy. in order to improve thermoecomomy of piping system, i. e
對于管網系統的設計、運行分析、運行優化與控制、以及改造等，必然涉及著管網系統的技術性、節能性和經濟性的綜合問題。
分享友人