outlet conditions 中文意思是什麼

outlet conditions 解釋
出口條件
  • outlet : n. 1. 出口，出路；排水口；通風口。2. 【商業】銷路。3. 批發商店。4. 發泄（情感）的方法；排遣。5. 地方廣播電臺[電視臺]。
  • conditions : （旅遊合同中）條件或服務項目
  1. In low mass flux and high outlet quality conditions, experiments have been performed using vertical heated tube, cooled by water, to determine chf value for a uniformly heated section

    針對低流量高含汽量工況，本論文試驗在長度為2 . 1m ，管徑為0 . 014m的均勻受熱圓管中得到93組chf數據。
  2. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  3. In the design, the construction measures such as application of shrinkage - compensating concrete, arrangement of spacing layer between the foundation rock and the bottom slab, adding outside waterproof layer, flexible connection between outlet pipe with side - wall, integerated concrete placement of pump seat with bottom slab and design of reinforcement with application of advanced calculation theory are used according to the characteristics of lager span, larger volume and complex loading conditions of the understructure

    針對下部結構跨度大、體積大、受力復雜的特點，在設計中採取多種措施，包括採用補償收縮混凝土、基巖與底板間設隔離層、增設外防水層、出水管與邊墻採用柔性連接、機座與底板整體澆注、採用先進計算理論指導配筋。
  4. The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments

    對歧管式單通道熱沉流動特性的研究結果表明，微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外，選用十二烷基硫酸鈉（ sodiumdodecylsulphate ， sds ）以及烷基多糖苷（ alkylpolyglycoside ， apg ）作為減阻添加劑，研究了表面活性劑添加對微通道流動特性的影響。
  5. Under the difficult conditions of " broader inlet " and " smaller outlet ", in order to find good chances of obtaining employment, the graduates have to set up the ideas of market economy, changing the sense of employment, adopting diversified ways of obtaining employment, opening up the ways of obtaining employment, trying to gain the initiative employment

    高校畢業生在「入口」不斷拓寬， 「出口」不暢的背景下，要想擺脫就業難的尷尬境地，必須樹立市場意識轉變就業觀念，採取多種方式就業，廣拓就業渠道，爭取就業主動權。
  6. Displacement ventilation also has higher energy using ration than other supply air systems, ie it has higher temperature effectiveness, and that displacement ventilation system always has part quantity of heat lying upside area of room, air supply outlet lies at low side, supply air direct come into workaround, and only absorb heat and humid of workaround, assure satisfaction of the design conditions of workaround

    對于置換通風其節能性也優于其它的送風方式，即其溫度效率高，而且置換通風總有部分熱量處于房間上部區域，送風口設在低部，送入空氣直接進入工作區，只是吸收了工作區的熱、濕量，保證工作區的氣象參數滿足要求。
  7. Then author discusses the writing and debugging of the program. the ventilation of a typical chamber with a stable fixed pollutant emission is studied by founding different boundary conditions ( here, they are the both up inlet and outlet on opposite side, the up - inlet and down - outlet on opposite side and the up - inlet and down - outlet on the same side. ). and accordingly dividing different grids. using the program, the velocity values and the pollution concentration values of the chamber are worked out

    對所研究的具有單個固定污染源的典型房間的室內通風，通過對異側上送上排、上送下排以及同側上送下排等幾種方式下，建立相應的邊界條件並劃分網格，運用編制的程序對它們進行數值模擬，所得的計算結果再用excel軟體分別進行顯示與處理，得到相應條件下的流場、濃度場，而後再算出相應的通風效率。
  8. As for the various problems in the process of the development of the private economy, we should solve them by changing development principle, strengthening the independent and creative ability, strongly developing the servicing business, opening widely the margin outlet and thoroughly enhancing personnel quality, etc., thus realize the fast development of the private economy in national regions to creative conditions for the overall economic development in national regions

    對於民族地區民營經濟發展過程中存在的種種問題，要採取較變發展理念、增強自主創新能力、大力發展服務業、拓寬融資渠道和全面提高人員素質等措施予以解決，從而實現民族地區民營經濟的快速發展，為民族地區經濟的全面發展創造條件。
  9. The effects of combustion conditions on ethanol fueled homogeneous charge compression ignition ( hcci ) combustion were thoroughly described in this paper. the experimental engine was established from ca6110 prototype diesel engine. first the inlet and outlet manifolds of 6th cylinder were separated from the other 5 cylinders in order to realize unattached air - intake, air - outlet and fuel supply

    給出了以過量空氣系數和廢氣再循環率表示的hcci工作范圍以及以轉速和平均指示壓力表示的hcci工作區域，並且研究了兩種hcci工作區域內發動機的動力性、經濟性和排放性能。
  10. Temperature process lines with tidal cycles of multi engineering conditions of characteristic sections are obtained, the relationship between temperature distribution and velocity field is established, the inner mechanism change of temperature process lines is investigated, the interrelation between water intake and outlet is analyzed, the relation between the ratio of dimensionless temperature rise span of the plant intake and the ratio of river discharge volume and plant cooling water intake volume is obtained

    得到了特徵斷面多種工況隨潮周期變化的溫度過程線，建立了溫度場與流速場的相關關系，研究了溫度過程線的變化機理，分析了取排水口對溫度場的相互影響關系，探討了無量綱溫升時長比與無量綱來取流量比的相關關系。
  11. Check pressure drop ( inlet - outlet ) to insure that desired outlet pressure is above the recommended lowest outlet setting to avoid cavitation conditions

    止回壓降（進口-出口）確保所需的出口壓力處于推薦的最低出口設置點上，以避免空穴現象發生。
  12. Then, only a given curve satisfied by the conditions of import and outlet of vane wheel as its modular curve will neglect the middle varying processes of in vane wheel, which reflect microscope properties in some degree - flow properties in boundary layer. leading into the velocity - coefficient unifies the boundary layer and eular theory in the design process of vane, which extends the area of selection of vane ' s curves and provides a valuable object function for the optimization design of vane

    那麼，僅憑一條預先給定的滿足葉輪出入口條件的曲線去來作為葉輪的型線，它必將忽略了這種除了葉輪出入口之外的中間變化過程，而這種中間變化在某種程度來說又反映出微觀特性? ?邊界層流動特性；速度系數的引入，它使邊界層理論和歐拉理論在泵的葉輪設計過程中得到統一；它使選擇葉片曲線的域圍拓寬；它也為葉輪的優化設計提供了一個很有參考價值的目標函數。
  13. The micro jet experiment is under conditions of 3 different heights, 2mm, 3mm and 5mm of 2d ( 2 dimensional ) rectangle jet outlet and the width of each is same, 20mm. 5 reynolds numbers vary from 20, 000 to 55, 000. the experiment characters tell that compared with that of the normal scaled jet flow, the dilution power of this micro jet becomes weaker

    微射流實驗在出口寬度固定為20mm情況下，選取了3種不同出口高度: 2mm ， 3mm和5mm ，並通過改變速度使出口高度雷諾數在約20000到約55000之間改變，實驗得到了流動圖譜和微射流數學模型。
分享友人
分享到 Line

分享到臉書