oxidation heat 中文意思是什麼

oxidation heat 解釋
氧化法測晶粒度
  • oxidation : n. 【化學】氧化（作用），正化。
  • heat : n 1 熱；熱力；熱度；熱量。2 體溫；發燒。3 （氣候的）高溫，暑氣。4 【冶金】熔煉的爐次；裝爐量；一...
  1. Connect 2 oxidation sulfur shi rui to try juice, if do not heat, after is litmus erubescent whether change by oneself a primary colors

    將二氧化硫通入石蕊試液，若不加熱，石蕊變紅后能否自行變回原色
  2. Increscent weight of oxidation, graphic and micrographic were explored, meanwhile, the mechanism of anti - erosion and wear - resistant of new coating material are also studied. at last, a program applied to calculate the temperature distribution and heat transmission between water wall tubes with sprayed coatings and metal anti - erosion tile was developed by use of visual basic

    文中最後採用vb6語言計算機編程，計算了不同材料塗層對鍋爐水冷壁管的傳熱效果及徑向溫度梯度的影響，同時與加裝了防護瓦和未加任何防護的水冷壁管進行了比較。
  3. Abstract : through analysis on the character and use of geothermal water, expatiate the mechanism of iron removal from geothermal water, adopt the iron removal and manganese removal technology of aeration full oxygen and savageness manganese grit osculate oxidation, and control the intention and time of inverse flush, these make the treated geothermal water reach the standard of iron and manganese chroma, moreover, it won ' t increase bad component or decrease good component it is a perfect iron removal and manganese removal technology that can save installation investment, need low operating cost and reduce the heat losing

    文摘:通過對地熱水的特點及其用途的分析，闡述了地熱水除鐵除錳機理，採用曝氣充氧、天然錳砂接觸氧化的除鐵除錳工藝，並適當控制反沖洗強度和時間，使處理后地熱水含鐵、錳濃度達到標準，且不增加有害成分或減少有益成分.設備投資省、運行成本低，熱損失小，是一種理想的地熱水除鐵工藝
  4. It is designed according to electrical stove or microwave oven request. heating pipe adopts high temperature resistance mgo powder as the insulation medium and the stainless steel case is passed oxidation deal through the advanced web band protection oven 1050c in order to become the a special oxidation layer and improve the high temperature oxidation and bittern corrosive performance of the heating pipe. the heating tube has high power density and strong heat radion. this product with good safe performance can work normally after 3000hrs life test

    加熱管選用耐高溫氧化鎂作絕緣介質，不銹鋼外殼經過先進的網帶氣體保護爐1050的氧化處理，形成一種特殊的氧化層，提高電熱管的抗高溫氧化及鹽鹵的腐蝕性能。電熱管的功率密度較高，熱輻射能力強。產品經長達3000h的壽命試驗后，仍能正常工作，安全性能好。
  5. Practice proves that the shell residuum gasifier with a waste heat boiler based on the partial oxidation process can not only use residuum as its feedstock but also use asphalt, a feedstock of poorer quality, thereby opening up a new feedstock route for the shell gasification process

    實踐證明，謝爾渣油部分氧化工藝氣化爐帶廢鍋流程不但可以以渣油為原料，而且能夠以質量更差的瀝青為原料，為謝爾工藝制氣技術開辟了新的原料路線。
  6. Zro2 fibrous cloths are characterized by their high melting point ( 2600 ), high - temperature resistance ( 2200 ), oxidation - corrosion resistance, quick absorbing alkaline, high alkaline absorption, and low heat - conductivity and resistivity, etc. zroi fibrous cloths that can be used as the nickel - hydrogen battery separators were first developed by using precursor process at home

    氧化鋯纖維布具有熔點高（ 2600 ） 、耐高溫（ 2200 ） 、抗氧化、耐腐蝕、熱傳導率低、吸堿速度快、吸堿率高、面電阻小等特點。
  7. Adopt advanced technic of f4 whole cold - press to moulding and heat melt to process to make, let the lining no slot to link withal cheek by jowl connect with exterior metalpipes wall, in the state of allowwing to work keep to distort in - phase, thereby to enhance using - life of lining in the working status of opposite high temperature high vacuum, stop the ecumenic pad fluorin pipes using in condition of cold and heat alternate and minus tension to come into being the matter of padding fluorin floor shrivel to jam the flowway and plastic rip, its perfect choice use to transport medium of strong corrosive strong oxidation by modern chemical - industry corporation

    採用氟塑料f4整體冷壓成型及熱熔加工等先進技術製造，使內襯層無縫搭接且與外層金屬管壁緊密粘接，在允許工作狀態下能夠保持同步變形，從而提高了襯里層在相對高溫高真空度的工況下的使用壽命，杜絕了一般襯氟管在冷熱交替，及負壓的條件下使用易產生襯塑層鼓癟阻塞流道及塑料拉裂的問題，是現代化工企業在輸送強腐蝕強氧化介質理想的選擇。
  8. Fuel cells are devices capable of converting chemical energy into heat and dc electric energy by means of the oxidation of a fuel, usually hydrogen

    燃料電池就是把化學反應的化學能直接轉化為電能的裝置。與火力發電相比，關鍵區別在於燃料電池的能量轉變過程是直接方式。
  9. The main products of our company are as follows : powder - painting equipments, electrophoresis equipments, aluminum - oxidation equipments, transportation and decontaminates and so on enamel equipments heat - welding powder painting equipments

    本公司專業產品有：粉末噴塗設備、浸塑設備、電泳設備、鋁氧化設備、曲面披覆設備、油漆塗裝設備、全自動前處理設備、輸送機設備、空氣凈化設備、搪瓷設備、熱熔結粉末噴塗設備。
  10. It is very difficult to analyze flame radiation in the cylinder of a diesel engine by theoretical method since flame radiation is a function of many parameters, such as the combustion process, the geometrical description of the chamber, the soot formation and oxidation processes, the soot radiant temperature and soot absorption coefficient. the radiant property of the flame in a cylinder is dependent on the combustion process. but the thermodynamic state of real engine cycles can be analyzed from the pressure - volume diagrams in the cylinder. thus a new thermodynamic computational model is set up for the flame radiation in the cylinder of a diesel engine based on the indirect relationship between the flame radiation and the pressure - volume diagram of the combustion process in this paper. the flame radiant heat flux in the cylinder of a di diesel engine is calculated with the variation of crank angle by this model. compared with measured values, the result of the computational values shows the model is available to represent the effects of flame radiation

    柴油機缸內的火焰輻射受諸多因素的影響，用理論分析法來確定它是相當困難的，由於柴油機缸內火焰輻射特性依賴于缸內的燃燒過程，而燃燒過程中的實際熱力狀態又可用示功圖來分析，因此藉助於火焰輻射與缸內熱力參數之間的這種間接關系，建立了一種計算柴油機缸內火焰輻射傳熱的新模型，利用該模型對一臺直噴柴油機缸內火焰輻射熱流量隨曲軸轉角的變化情況進行了計算，將計算結果與實測結果進行了比較，表明該模型能較好預測缸內火焰輻射傳熱量。
  11. Bell type furnace is mainly used to steel strips, steel plantes, copper strips, copper plates and other metal parts for bright anneal and normal anneal heat treatments. according to the technics, the process of preevacuation. heating, protecting atmosphere gew or non oxidation heating, air cooling, fast colling and slow cooling treaments can be executed

    罩式爐主要是用於鋼帶、鋼盤圓、銅帶、銅盤圓及其它金屬材料及零件的光亮退火和一般退火工藝，根據熱處理工藝的要求，可對熱處理工件進行預抽真空、加熱、保護氣氛少無氧化加熱、空冷、快冷及緩冷處理。
  12. In addition, the particles ' tough ceramic armor coating ensures that output stays high because it protects against energy - dissipating heat, oxidation and corrosion

    獨創的陶瓷膜金屬磁性微粒與確保磁帶準確、低摩擦走帶的背層新設計，無論是嚴酷的戶外錄制或是長時間的靜楨狀態都具有非凡的耐久性與可靠性。
  13. The main results are : grinding is favorable to improve surface smooth degree, while nitrided and slow deposition makes sic granules fine ; the width of coatings gap increased in order of grinding, nitrided and vacuum heat treatment, but gap defects in multilayer coatings could be removed by slow deposition ; temperature of maximum weight loss could be decrease to 600 by grinding, vacuum heat treatment or slow deposition, but it will increased to 800 after nitrided ; oxidation kinetics curves all varied with the coating modifications

    主要有：磨削改性有利於提高塗層表面平整度，氮化和慢沉積使塗層表面顆粒細化。塗層間隙寬度按磨削改性、高溫氮化、真空熱處理依次增大，而慢沉積可獲得無面缺陷的多層塗層。磨削改性、真空熱處理及慢沉積均使最大氧化失重溫度點提前至600 ，而高溫氮化則使最大失重點后移至800 。
  14. The process of oxidation in human body gives off heat slowly and regularly

    人體內的氧化過程緩慢而又有規則地放出熱量。
  15. Aluminium and aluminium alloys - anodizing - determination of the comparative fastness to ultra - violet light and heat of coloured anodic oxidation coatings

    鋁和鋁合金.陽極氧化.有色陽極氧化鍍層對紫外光和熱的比較牢固度測定
  16. Abstract : analysis is made on types and performances of protective atmospheres of the steel tube heat treatment furnace with protective atmosphere, and also dynamic analysis on the non - oxidation equilibrium conditions of the chemical process of atmosphere of the said furnace is made

    文摘:分析了鋼管保護氣氛熱處理爐的保護氣氛類型及性能，對鋼管保護氣氛熱處理爐內氣氛的化學過程動態分析了無氧化的平衡條件。
  17. In order to improve the formation and distribution of carbides and the resistance to oxidation of high speed steel during the procession of heat treatment, the content of w and mo should be limited and the content of v and nb should be en

    4 m復合變質處理的高速鋼fe衛ce v斗mo 5ocr刁0wi 5onb ，其熱處理組織中分佈著大量細小彌散的粒狀碳化物，碳化物網基本上得到消除。
  18. Oxidation resistant property of austenite heat - resistant steel replacing ni by mn and n

    奧氏體耐熱鋼的高溫氧化
  19. Emmed 32 has an excellent thermal stability, resisting to oxidation and thermal cracking at high temperatures, hence avoiding the formation of oxidation sludge ' s which may affect efficient heat - transfer

    Emmed 32具有極其優異的熱穩定性，可在高溫下抗氧化與抗熱劣化，不會生成淤渣影響傳熱效率。
  20. This model does improve the models of fuel spray and atomization, soot formation and oxidation, heat transfer of substance in cylinder is also considered

    此模型改進了燃油噴射模型以及碳煙的生成與氧化模型，考慮了燃燒區的區間傳熱和缸內工質的對流輻射傳熱，由此對一臺高壓共軌柴油機進行了模擬計算。
分享友人
分享到 Line

分享到臉書