passive load 中文意思是什麼

passive load 解釋
無源負載
  • passive : adj （opp active）1 被動的；守勢的。2 不抵抗的；默從的；消極的。3 【語法】被動語態的；被動式的 （...
  • load : n 1 裝載，擔子；負擔；工作（負荷）量。2 （車船等的）裝載量；一馱，一車，一飛機。3 【電、機】（機...
  1. The retaining wall reclining on the slight slope built on soft foundation is usually used in protecting the shore of river, the contradiction between the lack of impartiality in stress of the base and the small stress allowed by the foundation as well as the lack of stabilization of the breast wall is a hard nut to crack in the engineering. in the paper, a tenon - base is added under the base of the retaining wall, on the study of the choice of the parameters and formulas used in calculation and the research of theory used in calculation, method used to deal with the load, etc, the writer gives a way to crack the nut mentioned above paragraphs and presents a qualitative and quantitative analysis about them, such as the equivalent inner friction - angle ( d ) and the passive press of the clay ( ep ), etc. in the end of the paper, using modern optimization method, a design of the retaining wall reclining on the slight slope built on soft foundation is done, the result is economical, and accords with the fact

    軟基上的仰斜式擋土墻在水利工程河道護岸中經常遇到，仰斜式擋土墻基底偏心應力較大和軟基土地基容許承載力偏小的矛盾以及擋土墻抗滑穩定不足是工程中難以解決的難題。本文在對仰斜式擋土墻設計中有關計算參數的選擇、公式的選用應該注意的問題進行了研究，對河道護岸軟基礎上的仰斜式擋土墻採用凸榫基礎處理的方法，就其計算理論、設計驗算中各荷載的具體處理方法進行了較為細致的研究，提出了解決軟基礎上的水工仰斜式擋土墻難以解決的難題的方法，並對有水情況下粘土等效內摩擦角_ d 、凸榫被動土壓力e _ p等在計算中的取值提出了定性和定量的分析。最後利用現代優化方法對軟基礎上的水工仰斜式擋土墻進行了結構優化設計，得出了符合實際的結果，與其它重力式擋土墻形式進行比較，取得了明顯的經濟效益。
  2. On the other hand the research about dry friction system response calculation method is limited in passive control system. in this article, the precise solution to the linear quadratic optimal control system with load is analyzed firstly, and then a gradually deduced response solution method of lq control dry friction system is brought forward

    另外人們對干摩擦系統響應計算方法的研究大都局限於不受外載的控制系統，本文在研究外載作用下lq控制系統riccati方程精確解法的基礎上，也提出了干摩擦lq控制系統響應計算的遞推求解方法。
  3. Asas ( automatic self - allocating server ), invented by shiyao jin who is a professor of computer science department in national university of defense technology, changes the former architecture by changing the passive mode into active mode. it distributes the load evaluation onto all executive server, which greatly decreasing the load of dispatcher, improving the accurate of evaluation and preventing the occurrence of “ live lock ”, thus making the huge improvement of clusters ’ overall performance. this thesis mainly focuses on the research of and development for capacity analysis software for executive server base on asas

    由國防科大計算機學院金士堯教授發明的主動自調度集群（ asas : automaticself - allocatingserver ）改變了以前的架構，改被動為主動，將負載評估分佈到各執行服務器，大大減輕了集中器的負載，提高了評估的準確性，防止了「活鎖」現象的出現，從而使得集群的整體性能得到了很大的提高。
  4. To put into operation a large amount of non - linear load, make in harmony wave of rural power grids serious becoming in pollution, pass to rural local electric wire netting main in harmony analysis of wave source, put forward in order to restrain from insert rural power grids in harmony wave source voltage total in harmony wave distortion rate and the containing rate change last device number pulsating for increase of goal, increase the pulse of the current change device and install light specified value electricity active wave filter mix with passive wave filter near the harmonics source to control the wave in harmony

    摘要大量非線性負荷的投運，使農村電網的諧波污染日趨嚴重，通過對農村地方電網主要諧波源的分析，最終提出了以限制接入農村電網的諧波源的電壓總諧波畸變率和各次諧波電壓含有率為目標的增加換流裝置脈動數，以及在諧波源附近裝設小額定值的電力有源濾波器配以無源濾波器的混合型電力濾波方式，以進行諧波治理。
  5. Passive suspension, pid control semi - active suspension and neural network control semi - active suspension are researched by simulation. white noise, sine wave and sawtooth wave are used for excitation. the root mean square value of vehicle body acceleration, suspension displacement and vehicle wheel load are analyzed

    在模擬研究中，路面激勵取為白噪聲、正弦波和鋸齒波，懸架類型採用被動懸架、 pid控制半主動懸架、神經網路控制半主動懸架三種。
  6. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - tests - static shear load

    光纖互聯裝置和無源部件.基本試驗和測量程序.試驗.靜剪切強度試驗
  7. Fibre optic interconnecting devices and passive components - basic test and measurement procedures part 2 - 3 : tests - static shear load

    纖維光學互連器件和無源器件基本試驗和測量程序第2 - 3部分:試驗靜態剪切力
  8. The electro - hydraulic load simulator is a typical kind of passive force control system. it ’ s applied to simulate all kinds of loads on rudder under laboratory conditions, thus tradition all - objective experiments will be replaced by half - objective forecasting ones in the lab, so that the performances of rudder can be test conveniently on the ground

    電液負載模擬器是典型的被動式力伺服系統，主要用於在實驗室條件下復現舵面所受各種負載，將傳統的實物實驗變為實驗室條件下的預測實驗，從而達到在地面檢測舵機性能的目的。
  9. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - tests - static side load for connectors

    纖維光學互連器件和無源元件.基本試驗和測量程序.試驗.連接器靜態側向負荷
  10. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 2 - 42 : tests - static side load for connectors

    光纖互聯裝置和無源部件.基本試驗和測量步驟.第2 - 42部分:連接件靜態邊負載
  11. Fibre optic interconnecting devices and passive components - basic test and measurement procedures - part 2 - 42 : tests - static side load for connectors iec 61300 - 2 - 42 : 2005 ; german version en 61300 - 2 - 42 : 2005

    光纖互連設備和無源元件.基本試驗和測量程序.第2 - 42部
  12. Abstract ： conventional ups systems operate to protect against such harmonic distortion brought by nonlinear load using complex filtering schemes, often employing large passive components

    摘要：對于非線性負載所引起的諧波失真，傳統的逆變系統通常採用復雜的大規模無源元件濾波方案來濾除。
分享友人
分享到 Line

分享到臉書