peak resistance 中文意思是什麼

peak resistance 解釋
巔值電阻
  • peak : vi 1 瘦弱；消瘦，憔悴。2 減少，縮小 （out）。n 1 山峰，山頂；孤山。2 （胡須等的）尖兒；尖端。3 最...
  • resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
  1. The model considers peak value of lightning current, tower grounding resistance, tower style, line surge impedance, power frequency voltage and distance between towers

    模型中考慮了雷電流幅值、桿塔沖擊接地電阻、桿塔具體形狀、尺寸、桿塔波阻抗、工頻電壓及檔距等因素的影響。
  2. In the egg laying industry, the bodies of laying birds often suffer from deteriorated resistance to disease, short duration of the peak period of egg laying time and low rate of egg production due to the laying houses incomplete disinfection, poor sanitation, low - intensity light and lacking ventilation

    在蛋禽飼養中，由於禽舍消毒不徹底，環境衛生較差，光線不足，通風不暢等原因，導致蛋禽機體抗病能力較差，產蛋高峰期持續時間較短，產蛋率降低。
  3. Abstract : based on the results obtained from seismic safety evaluation of 128 engineerng sites in china, statistics and analysis of relevant intensities with differient probability levels and peak acceleration are made to provide parameters of probability levels of earthquake resistance in the seismic design code

    文摘:以全國范圍內128項工程場地地震安全性評價結果為基礎，對不同概率水平相應的地震烈度和加速度峰值進行統計分析，為合理確定抗震設計規范中設防地震的概率水平提供了依據。
  4. Changing the grading of sic particles not only affects the strength and pile density, but also modifies the phase compositions and microstructure of the material. with the reducing of sic particles, the strength of the material increases obviously. the nitrification scheme has the greatest influence on phase compositions and microstructure " of si3n4 ( si2on2 ) - sic, after two continuous nitrification reacting peak and short - time high - temperature treating, the best properties can be obtained ; and the residual strength of the composite is much higher after the thermal shock resistance test, which shows that the material possesses excellent thermal shock resistance

    本論文較全面地探討促進強度和顯微結構良好的si _ 3n _ 4 （ si _ 2on _ 2 ）結合相的實驗條件，實驗數據顯示：引入適量的燒結助劑能夠促進si _ 3n _ 4 （ si _ 2on _ 2 ）的生成和晶粒的長大，而過量時，其促進作用反而下降；隨著si粉加入量增加，生成的結合相明顯增多，復合材料的性能顯著提高；改變sic顆粒級配不僅影響復合材料的強度與堆積密度，而且對復合材料的物相與顯微結構也有影響，隨著顆粒逐漸細化，材料的強度有較大的提高；對復合材料的強度、物相與顯微結構影響最大的是氮化制度，經過兩個氮化高峰連續的反應和短時間的高溫后處理得到的復合材料性能最好；通過抗熱震性能實驗后復合材料的殘余強度較高，顯示出較好的抗熱震性能。
  5. Different distribution of power loss can be worked out by mathcad software based on the formula reasoning. the result of calculation is consistent with that of the experiment, which proves that this method is right. it is pointed out through the analysis of calculating data that the key to improve efficiency at the same output power is to decrease the peak current and rms current of power switches or the on - resistance of mosfet and windings

    由推導可得損耗計算公式，利用數學計算軟體計算出電路輸出從空載到410w阻性負載時損耗分佈變化，該結果與實驗數據基本相吻合，證實了這種方法的正確性；通過對計算數據的分析，指出了進一步提高效率的關鍵在於輸出相同功率時降低功率管的電流峰值和有效值，減小繞組和mosfet的導通電阻。
  6. The results that increasing of bias current and shunted resistance and lowing critical current and connected inductance can decrease the transmission time are shown ; ( 4 ) a new type of circuit, ladder shape multiplayer jtl. structure is provided by author, thus output signal of rsfq circuits can be amplified before transfer to room temperature electronics system. it has highly gain of amplify relatively and the double peak structure are avoided through decreasing parasitic capacitance

    （ 4 ）針對目前超導與室溫介面電路的電壓放大器存在的「雙峰」和放大增益效率較低的不足，提出了一種全新的階梯式多層jtl電壓放大電路結構，較好的解決了以上的問題，通過初步的模擬分析證實，該電路的構思極負有創新性。
  7. The hardness and corrosion resistance were evaluated by, the anticorrosion mechanism was also discussed by xps as well. the composited content of particles in coating was high when 0. 5 % super - 3900 was added into al2o3 suspention before plating the composited content increased with the increase of al2o3 concentration in plating solution and the time of stirring before plating and increased as a peak curve with plating temperature, cathodic current density and ph value

    超分散劑super - 3900加入量為0 . 5 % ，對al2o3懸浮液分散后加入時，獲得的鍍層復合al2o3含量高，並隨著鍍液中al2o3含量、鍍前攪拌時間增加而增加，鍍層中al2o3含量隨著施鍍溫度、陰極電流密度、 ph值的增加呈先增加后減少的變化。
  8. As a result, optimum technological approaches exist for discriminating user requests precision, robustness, long - term stability, pressure peak resistance etc.

    從而對于不同的用戶需求精度，魯棒性，長期穩定性，防止壓力峰值等等都有最合適的技術途徑。
  9. When the parameters and resonant conditions are equal, nonlinear inductance can change the topology structure of response curves. changing the nonlinear resistance and the nonlinear inductance can control peak value of response curves. changing other parameters, amplitudes of response curves will change correspondingly, but the responses are different, one modal could be controlled by the other

    2的情況下，改變了響應曲線的拓撲結構;無論是電阻非線性還是電感非線性，都會抑制兩個模態的振動;改變系統參數，振幅和共振區的大小會發生相應的變化，但兩個模態對參數變化的響應程度是不一樣的，可以通過一個模態控制另一個模態。
分享友人
分享到 Line

分享到臉書