phase error 中文意思是什麼
phase error
解釋
相位誤差-
We mainly discuss the methods of gmti, location, and the measure of velocity, the decrease of false alarm probability and the compensation for phase error
主要研究mcarm數據動目標的檢測、定位和測速的方法，利用定位和測速信息進一步降低虛警概率的方法和相位誤差補償方法。 -
3. with comprehensive improvement of transponder including structural adjustment to lna ; optimization of ( phase locked loop ) pll filter ; structural adjustment to the transmitter and phase error adjustment to the intermediate frequency demodulation circuit, we have successfully enhanced sensitivity, expanded dynamic range, increased transmitting power and improved the spectrum purity ; decreased capture time for pll ; improved the signal quality after demodulation ; reduced its volume and power consumption. 4
3 、對通信機的全面改進，包括lna結構的調整、鎖相環環路濾波器的優化、發射部分結構的調整以及中頻解調電路的相差調整，提高了系統的接收靈敏度、改善了本振的頻譜純度、減少了鎖相環的鎖定時間、使中頻解調后的信號質量大為提高，同時還減少了體積、節約了系統的功耗。 -
Fuzzy monitoring control of phase error for vibration systemwith twin - motor drives rotating in the same direction
同向回轉雙機傳動振動系統相位差的模糊監督控制 -
In order to meet the requirement of phase - error and physical dimension, high - pass / low - pass filter phase shifter and solid - structure are applied in the design of if broad - band five - bit digital phase shifter
考慮對相位誤差和物理尺寸的要求，中頻寬帶五位數字移相器採用高通/低通濾波器形式和立體結構進行設計。 -
And typical super heterodyne structure in rereiver part. this scheme benefited to reduce frequency error and phase error, and had the advantages of good dynamic range and selectivity, short exploitation cycle and small venture in the given performance demand, etc. this system implemented a six - layer hoard rf handset model together with baseband by using advanced eda tool veribest 2000
系統設計應用hd155131的gsm900 dcs1800雙頻解決方案，發射機部分主要採用offsetpll方案，該方案有利於減小系統的頻率誤差和相位誤差；接收機部分採用典型的超外差式結構，它具有優良的動態范圍和選擇性，在給定的性能要求下具有開發周期短、風險小等特點。 -
The algorithm, basing on convolution filtering technique and the fringes " gray values max - min distribution, can automatically and accurately carry out space frequency spectra shifting without spectra analysis and spectrogram in the technique of phase method of projected grating for 3 - d object shapes measurement. the new algorithm makes image processing much caster and the technique of object shapes measurement more automated. the phase error caused by filtering and the crossed - optical - axes geometry setup is also discussed
本文採用投影光棚相位法和數字卷積濾波技術：根據柵線的條紋灰度值分佈具有極大極小分佈的特性，提出卷積濾波形貌光學自動檢測的圖像處理方法，有效地實現了頻譜自動移位，從而進一步提高了圖像處理的速度和形貌測量技術的自動化程度；同時對採用兩光學主軸相交，且非遠心投影系統所產生的誤差進行了分析，並提出了修正方法。 -
In angle measuring, an antenna configuration and interferometer ambiguity - resolving algorithm are proposed, and to eliminate the error caused by carrier phase error, a correction method is introduced, through which all ambiguity - resolving error can be recognized and he corrected even when the error probability is up to 0. 42
在測角中，提出了一種干涉儀天線陣結構和干涉儀解模糊演算法，針對通道載波相位誤差可能引起的解模糊錯誤，又提出了一種糾正方法，模擬顯示，在發生解模糊錯誤的概率高達0 . 42的情況下，該方法仍然可以識別並糾正所有解模糊錯誤。 -
It is shown from the test results that the ratio error and phase error have been integrated to meet class 0. 2 of national standard
經過實驗室測量，整機系統的比差和角差達到了我國關於0 . 2級電流互感器的標準要求。 -
From the experiments we can get a conclusion that with the characteristics of working well, sample circuit and light path, rated current error and phase error fulfilling accuracy class 0. 2, and respond speed and bandwidth superior to old electromagnetic current transducer, the hybrid current transducer we designed is practical
實驗證明，採用這種方法設計的混合式光纖電流互感器工作可靠、電路和光路簡單，比差和相差都能夠很好地滿足國標中對0 . 2級電流互感器的要求，動態響應速度、帶寬等性能都明顯優于傳統的電磁式電流互感器，已經進入實用化階段。 -
Finally, it takes a detailed test to the processed millimeter 4 - bit digital phase shifter. the test result is better than expectant guideline : the maximum of the phase error is 10, the insertion loss is better than 10. 74db, the return loss is more than - 14. 88db in the 33. 9ghz 34. 5ghz frequency band. the whole volume of the phase shifter is 80mm 35mm 20mm
最後，對加工出的毫米波四位數字移相器進行了測試，測試結果完全達到了預定指標要求:在所要求的33 . 9ghz 34 . 5ghz頻帶內，最大相移誤差小於10 ，插入損耗小於10 . 74db ，輸入輸出回波損耗大於- 14 . 88db ，整個電路尺寸為80mm 35mm 20mm 。 -
The paper gives two ways to solve the phase synchronization, which is a key technology to bistatic sar, namely direct synchronization and indirect synchronization. meanwhile, the paper also studies the affection of linear phase error, quadratic phase error and sine phase error which are engendered by the method mentioned of the paper upon imaging
相位同步問題是雙站sar的一個關鍵技術問題，本文提出用直接同步法和間接同步法解決，並著重討論了兩種方法中可能出現的一次相位誤差、二次相位誤差、正弦相位誤差對成像的影響。 -
For the measurement of analog signals such as voltage and current of astg, a filter card for pre - disposing is designed, in order to improve real - time performance, algorithms for ac analog sampling is simplified, and a compensation algorithms for phase error due to sequence - sampling is brought forward. for the measurement of impulse - width signals such as rotor - speed and rotor - position - angle, an intelligent interface card based on isa bus is designed. all programs for measure and control based on c + + are compiled and debugged and the flow for system debugging is summarized
為了提高實時性，對交流采樣演算法進行了簡化，並提出了由於非同步順序采樣所造成的相位誤差的補償演算法；針對轉速、轉子位置角等脈沖寬度信號的測量，深入分析了測量原理，設計了基於isa總線的智能介面卡；編制和調試了基於c + +的全部測量控製程序；完成了整個系統的調試，並總結了調試方法。 -
So power systems harmonic analysis is a significant aspect of power systems research. power system harmonic analysis was realized usually with fast fourier transform ( fft ), but the method exits spectrum leakage, and can not analyse all harmonic parameters exactly, such as frequency, amplitude and phase, in particular has big phase error
電力系統諧波分析通常都是通過快速傅立葉變換（ fft ）實現的，但是這種方法存在柵欄效應和頻譜泄漏，使計算出的諧波參數即頻率、幅值和相位不準，尤其是相位誤差很大，無法滿足準確的諧波測量要求。 -
Motion errors are given first, and then theoretical analysis, simulation result show affections caused by 3 kinds of typical motion errors both on the doppler and the image. last the phase error criterions are given. 4
4 .研究了機載雙站sar中偏航、俯仰和橫滾三種姿態誤差對回波多普勒頻率和雷達成像的影響，並分析研究了天線指向誤差對回波幅度的影響，最後通過模擬實驗證明了研究的正確性。 -
To correct these effects, two methods were introduced in this paper : using weighted function to constrain second phase error caused by dispersion, and utilizing pga algorithm to reduce the phase perturbation due to the irregularities of the ionosphere
本論文介紹了兩種校正方法：利用加權函數抑制色散效應引起的二次相位誤差，以及使用相位梯度自聚焦演算法較正由電離層的不規則性引起的信號相位起伏。 -
On the following, on the basis of formulas given above, three kinds of effects due to ionosphere are presented : image shift due to group delay which was caused by the difference between the group velocity and the velocity of light in the ionosphere ; image distortion due to ionospheric dispersion which can create second phase error of lfm signals ; the last, the phase perturbation caused by the irregularities of the ionosphere can reduce the coherent length and affect azimuthal resolution
文中主要研究了電離層的三種影響：信號經過電離層傳播的群延遲引起的成像偏移；電離層的色散效應給線性調頻信號帶來二次相位誤差，導致圖像退化、失真；以及電離層的閃爍、湍流等不規則性引起的信號相位起伏。在此基礎上，比較分析了不同波段、帶寬條件下電離層的影響。 -
This method constructs covariance matrix by utilizing data vectors in different range lines and projects phase error vector into noise sub - space which is formed by eigendecomposing the covariance matrix
該方法利用不同距離單元的觀測矢量構造協方差矩陣，然後通過對協方差矩陣特徵分解得到噪聲子空間，最後將相位誤差矢量向噪聲子空間投影來估計多普勒調頻率。 -
Numerical analysis for phase error of silica - based arrayed waveguide grating
硅基二氧化硅陣列波導光柵相位誤差數值分析 -
In this paper, the polarization in the fiber - optic depolarized gyros has been analyzed. several aspects are under discussion, such as the polarization evolution in the depolarizer and the single - mode fiber sensing coil, the depolarization in the polarization - maintain fiber, the birefringence and coupling in the single - mode fiber, the nonreciprocal phase error and the output intensity. firstly, the depolarization effect of the lyot depolarizer to the polarized light and the partially polarized light has been analyzed
本文對消偏光纖陀螺中的偏振特性進行了分析，包括單模光纖環和消偏器中的偏振態演變、保偏光纖的消偏性能、單模光纖環的雙折射和耦合、輸出光強和非互易性相位誤差與偏振態的關系。 -
The reasons of the appearance of phase error in the system of direction finding by phase interferometer are introduced and a method of eliminating phase error resulted in inconsistency of channels is put forward
摘要介紹了相位干涉儀測向系統相位誤差產生的原因，針對因通道不一致性導致的相位誤差提出了一種消除方法。
分享友人