polarization voltage 中文意思是什麼

polarization voltage 解釋
極化電壓
  • polarization : n. 1. 兩極分化。2. 【物、天】極化；極化強度。3. 【物理學】偏振（化）。
  • voltage : n. 【電學】電壓，電壓量，伏特數。 the working voltage （電氣的）耐壓限度。
  1. In order to eliminate the influences caused by temperature, electrode - polarization and autoeciousness - capacitance, the traditional instrument has added complicated circuits so that it cause such shortcomings as big error, time - retardation and a relatively small scope. through the problems caused by 2 - probe electrode and ac current source, a new measuring circuit based on the excitation of bi - directional voltage pulse and the sensor of 4 - probe electrode is proposed, using single - chip to achieve auto - temperature compensation

    作者在參閱國內外大量相關參考文獻的基礎上，從電導測試技術的原理性研究出發，分析了採用交流激勵源、兩電導電極為傳感器的傳統電導測試系統所面臨的種種問題，提出並研製了一種基於雙極性脈沖電壓激勵、以四電導電極為探頭、運用單片機進行溫度自動補償的新型電導率測量系統。
  2. The factors which influenced the process include the insulator ' s material, structure, the distribution of space electrical field, the way to deal with the surface, the characteristic of voltage waveform, pulse width etc. there are two kinds of theory for the vacuum surface flashover : secondary electron emission avalanche ( seea ) and electron triggered polarization relaxation ( etpr )

    影響該過程的因素包括絕緣材料結構、空間電場分佈、表面處理方法、所加電壓特徵，脈沖寬度等。研究真空表面閃絡過程有兩類理論：二次電子發射崩潰（ seea ）和電子引發極化鬆弛（ etpr ） 。
  3. A realtime depolarization strategy is put forward that takes polarization voltage and soc as inputs, and the width of depolarization pulse, revised by solution temperature, as output

    提出了以蓄電池極化電壓和蓄電池的荷電狀態為輸入變量，以去極化脈沖的寬度作為輸出並根據蓄電池電解液溫度進行修正的實時去極化策略。
  4. Based on a number of charging and discharging experiments, a thought is put forward that the polarization may be detected according to the terminal voltages at charging, terminal voltage at the short pause, and the soc ( state of charge ) ; the depolarization by momentary discharge according to the reference of optimal curve

    在論文撰寫過程中，作者主要進行了如下方面的研究： -對鉛酸蓄電池的電化學機理進行充分研究，並在大量充放電實驗的基礎上，提出了依據蓄電池充電時和停充瞬間的端電壓和蓄電池荷電狀態檢測蓄電池極化狀況的思想。 -依據最佳曲線給定，採取瞬間放電減少極化。
  5. Abstract : on the basis of the theory of controlled phase - changes of piezoceramics, high - temperature polarizing technology makes initial working temperature a little higher than curie temperature of a sample, but the polarization voltage needed is greatly lower than the one needed in normal polarization ( only 1 / 10 - 1 / 5 ). the improved polarizing technology can make polarization more complete

    文摘:壓電陶瓷的高溫極化是利用受控的場致有序化的順電鐵電相變原理，使起始極化溫度略高於樣品的居里溫度，但所需的極化電壓大大低於常規極化，僅為1 / 10 - 1 / 5 ；選擇較高的降溫升壓速率，可使極化趨于更加完全，具有常規極化工藝無可比擬的優越性。
  6. Research of high - voltage pulses power supply for polarization reversal in ktiopo4 crystals

    晶體極化反轉的高壓脈沖電源的研究
  7. The corrosion test, performed in 5wt % salt fog or with the electrochemical calculation of anodic polarization in 50, g / g potassium chloride aqueous solution, indicates the coatings densification corresponds with their corrosion protection to uranium. the denser the coatings are, the more effective their protection to uranium is. compared with the al coatings produced at - 300v bias voltage and al _ ( 2 ) o _ ( 3 ) coatings produced with ps technique, the al coatings at - 100v and al _ ( 2 ) o _ ( 3 ) coatings with rms and to techniques are denser thus providing a better protection for uranium

    電化學參數計算或鹽霧腐蝕結果表明，鍍層的緻密程度與其對鈾基體的保護性能呈現了較好的一致性：鍍層越緻密，其保護性越好，即- 100v偏壓下的鋁鍍層和rms 、 to法制備的al _ 2o _ 3鍍層；鍍層越疏鬆，其保護性越差，即- 300v偏壓下的鋁鍍層和ps法制備的al _ 2o _ 3鍍層。
  8. The lead zirconate titanate ( pzt ) / polymer composite presented large tan5 and dynamic modulus when the composites were exposed to higher polarization voltage and longer polarization time, because of the uniform dispersion of ceramic in polymer matrix and the strong interaction between grain and polymer. the morphology of the composites, namely the degree of the grains dispersion in polymer, can be observed through scanning electric microscope ( sem )

    顆粒結構性高的壓電陶瓷，其復合體系內耗大；在高極化電壓、長極化時間下，壓電陶瓷顆粒在聚合物中分散比較均勻，與聚合物接觸面大，相互間作用強；在外力作用時，體系tanb 、 g ， ， g ?呈現大的值。
  9. To shorten charging time and improve charging efficiency, the circuit can change the charging electric current automatically according to real time voltage of the battery, and dispel the polarization phenomenon by narrowing pulse discharge in the whole course

    該電路可根據蓄電池端電壓自動改變充電電流大小，並通過全程窄脈沖放電消除了充電過程中的極化現象，縮短了充電時間，提高了充電效率。
  10. In order to realize low half - wave voltage, high polarzation extinction ratio, low pigtailing polarization crosstalk, low insert loss, precise tapped power ( ratio ) and good splitting beam ratio, the optimum design was performed

    為了實現低的半波電壓、高的偏振消光比、低尾纖串音、低插入損耗、精確的抽頭功率比和良好的分束比，我們對器件結構進行了優化設計。
  11. For long - haul high bit rate trunk line optical fiber communication system and metro optical fiber network, a semiconductor optical amplifier ( soa ) is the most promising component due to its all kinds of properties and small dimension, compactiveness, low drive voltage, such as in optical network solutions, polarization - insensitive semiconductor optical amplifier ( pisoa ) is a popular candidate as optical gates. but the polarization - insensitivity over large wavelength range is requested. the purpose of this thesis is to develop a soa which is polarization - insensitive and has large 3db bandwidth

    隨著寬帶傳輸和寬帶接入以及全光網的組建和發展，大帶寬偏振不靈敏半導體光放大器（ semiconductoropticalamplifier ， soa ）由於其易於與其它器件集成，體積小，具有快的動態增益響應，非線性好，飽和輸出大，可實現無損操作等特點，在光通信網路中，成為光纖通信發展，全光網組建以及wdm 、 tdm技術成熟的關鍵部件之一，其中偏振不靈敏和大的3db帶寬是性能優良soa的重要指標，也是制備的技術難點。
  12. This thesis performs the research how to analyze and design lithium niobate optical modulator in i - fog. the analysis concentrates on those performance parameters of a modulator : half - wave voltage, single mode performance, quasi te / tm polarization, loss, bandwidth and split - ratio

    這些都是圍繞調制器的性能參數來研究的，它們包括：半波電壓，單模特性，偏振特性（ te和tm模之間的輸出功率比值） ，損耗，帶寬及分支比等。
  13. The purpose of introducing ferroelectric polymeric pvdf material was to make use of the remanent polarization of ferroelectric materials and to study the effect of the internal field formed in the device during the device worked. the diodes were driven at constant voltage and were also kept under short - circuit or reverse - bias conditions

    本文將具有特殊極化性能的鐵電高分子材料pvdf引入器件，目的在於利用其電場下其殘余極化特性，研究此種器件工作時形成的內電場情況及其對器件穩定性的影響。
分享友人
分享到 Line

分享到臉書