position to be tested 中文意思是什麼
position to be tested
解釋
試壓部位-
In the positioning servo - system, which generally is configured by the d. c. pulse width modulator ( pwm ) velocity governing system and position servo - loop, the parameter perturbance of pwm velocity loop really exist by reason of such as the load behavior ; power voltage supply ; operating setting value, etc. 1, 2 ， and it cannot be ignored. by using the identification technique to form the mathematical model of the system, authors have confirmed the facts. therefore, to design the discrete sliding mode controller ( dsmc ) of the positioning servo - system, the perturbed parameters value bounds of the pwm velocity loop, which is as the controlled plant of position servo - loop, should be accounted. consequently, the design principle of dsmc for accounting system with parameter perturbance is proposed by the authors. the proposed method can ensure the stability of system with parameter perturbance and the behavior of non - overshoot, fast precise positioning. in order to reveal the effects of the design method, the comparative research work is done by the authors. also, it has been tested in an industrial experiment, the results proved it is satisfactory
由直流脈寬調速系統（ pwm ）和位置環構成的定位系統中，速度環的參數隨負載特性；電網電壓；給定工況而攝動是不容忽視的.作者通過系統辨識建模也證實了這一事實1 ， 2 .因此在設計位置環的離散滑模控制時，必須針對速度環（即位置環的控制對象）的參數攝動范圍採用「對象參數攝動離散滑模控制器的設計方法」 ，以確保系統在參數攝動時的穩定性和快速、無超調、準確定位的優良動態品質.為剖析該設計方法的控制效果，本文作了對比性研究，並將該設計方法用於工業試驗中，取得了滿意的結果 -
The main idea of this research can be summed up as following words, reflecting light or scattering light upon the surface of measured object formats an image on the photo surface of psd by a optical system, because of the good relationship between the offset of image point in psd and the offset of object thickness, a mathematical model can be founded according to this relationship. it can measure the shift of object thickness through these analyses of movement of image point position in psd, and this device can be tested its reliability with many practical specimens
光學式非接觸厚度-微位移測量儀是在激光三角測量法的基礎上實現的，在本研究方案中，根據象點在psd上的移動量建立與被測物厚度-微位移變化之間的數學模型，通過對象點位置變化的計算，實現被測物厚度-微位移變化量的測量。本文重點闡述了光學式非接觸厚度-微位移測量儀的工作原理，並對測量儀的工作過程進行了分析；對影響測量精度的因素做了討論。
分享友人