post-combustion temperature 中文意思是什麼
post-combustion temperature
解釋
燃燒后的溫度- post : n 1 （被指定的）地位，崗位；職位，職守。2 【軍事】哨所，站；哨兵警戒區；〈轉義〉哨兵，衛兵。3 基...
- combustion : n. 1. 燃燒，發火，點火。2. （有機體內營養料的）氧化。3. 騷動。
- temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
-
Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. ， if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios
文摘:在某些廢鋼熔煉過程中，當爐料中含碳及碳氫物質且燃燒不充分時，會帶來煙氣中一氧化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變化，試驗結果表明，反應過程的限制性環節是油分的熱分解；在較低的溫度下（ co ） / （ co2 ）比例影響轉化率和二次燃燒率；而在任意比例下保證充分反應的溫度為900以上 -
About design programs of propylene tower post weld whole heat treatment, we have made analyses and compare from the various technical and economic aspects, and in vertical state of large pressurized vessel, we propose to adopt the internal combustion heat treatment method, in horizontal state of it, to adopt high temperature flue gas heat treatment method, and propose center combustion tube method as the future direction of technical developmnet insights
摘要圍繞丙烯塔焊后整體熱處理的各種設計方案，從技術、經濟等方面進行分析對比，提出對超大型壓力容器，立置狀態下宜採用內燃法熱處理；臥置狀態時宜採用高溫煙氣法熱處理，並提出將中心燃燒管法作為今後技術發展方向的見解。 -
The simulations results show that the average combustion temperature is much lower in fuel - rich state and little higher in oxygen - rich state near the best o / f ratio. by extending the post - chamber length the oxidizing gas and the fuel pyrolytic gas can burn completely and the average combustion temperature can be prominently increased. the fuel - rich recirculation zone close to the head of combustion chamber is very important for the combustion
計算結果分析表明：發動機在富燃狀態下平均燃燒溫度偏低，在接近理想配比的富氧狀態下平均燃燒溫度有所提高；加長補燃室可以大幅度提高發動機的平均燃燒溫度，並促進氧化劑氣體和熱解氣體的充分燃燒；燃燒室頭部的富燃迴流區對發動機的燃燒非常重要，去掉燃燒室頭部突擴段后，氧化劑氣體和燃料熱解氣體不能充分燃燒，發動機的平均燃燒溫度大幅下降。
分享友人