pressure angle of involute 中文意思是什麼

pressure angle of involute 解釋
漸開線壓力角
  • pressure : n 1 壓；按；擠；榨。2 【物理學】壓力，壓強；大氣壓力；電壓。3 精神壓力，政治[經濟、輿論等]壓力。4...
  • angle : n 【英史】盎格魯人〈cf Angles〉。n 1 角，隅，角落；棱，嬗角。2 【數學】角，角位，角的度數。3 【機...
  • of : OF ＝Old French 古法語。
  • involute : adj. 1. 紛亂的，錯綜復雜的。2. 【植物；植物學】內卷的。3. 內旋的；螺狀的。n. 【數學】漸伸線，漸開線，切展線。vi. 1. 內卷，捲起。2. 恢復原狀。3. 消失，消散。
  1. The basic types and dimensions of hobs for 45 pressure angle involute splines

    壓力角漸開線花鍵滾刀基本型式和尺寸
  2. The basic types and dimensions of hobs for 30 pressure angle involute splines

    壓力角漸開線花鍵滾刀基本型式和尺寸
  3. The equation of pressure angle, width coefficient, and contact ratio are calculated and the influences of these parameters on contact are analyzed. based on ordinary involute gear, the diametral deflection principle of curvilinear - tooth

    最後針對現有文獻的不足，研究了刀具壓力角、齒寬系數和重合度等參數的計算方法，並分析了這些參數對弧齒線圓柱齒輪嚙合的影響。
  4. This paper deduced the involute gear total tooth profile equations of unsymmetric teeth with double pressure angles, proposed the calculation formulas of coordinates and load angle at the upper and lower points of single and double teeth mesh areas, and programmed the relevant parametric programs

    摘要推導出雙壓力角非對稱漸開線齒輪系統全齒廓方程，以及在單、雙齒嚙合上、下界點處坐標和載荷角的計算公式，編制了相應的參數化程序。
  5. Abstract : calculation of the module of a 45 pressure angle involute profile for a tapered splined shaft substituting for a delta profile is studied in this article. the formula of calculation is deduced and the influence of unsuitable module on contact zone is also analysed

    文摘:討論了錐三角齒花鍵軸用45壓力角漸開線齒花鍵軸代替時，如何計算模數的問題，並推導出相應的計算公式，分析了模數選擇不當對接觸區的影響
分享友人
分享到 Line

分享到臉書