pressure recovery 中文意思是什麼
pressure recovery
解釋
壓力復原-
The technology in fluid pressure energy recovery
流體壓力能的回收技術 -
The result is that this gas pool has simple structure, only forms a little nose - like structure at the district of fenghuangshan ; this pool belongs to delta front sub - facies sedimentary model, the underwater distributary channel and mouth bar is the better sedimentary microfacies ; the physical property of the reservoir is poor, the type of pore of the reservoir rock mostly are intergranular pore, intergranular solution hole and little are intercrystalline micropore ; the influential factors of pore structure and physical property are lithofacies, lithologic character and diagenesis ; the off - take potentia of all the testing well are deadly shortness, the wells have the worth of industrial recovery only under the condition of going through sand fracturing, and in the early of binging into production, the oil and sheath pressure drop rapidly, the production of the well drop rapidly
研究認為該氣藏構造簡單，只在鳳凰山形成了一個小型的鼻狀構造；屬於三角洲前緣亞相沉積模式，水下分流河道和河口壩是有利的沉積微相；儲層物性差，儲層巖石的孔隙類型主要有粒間孔、粒間（內）溶孔及少量晶間微孔；影響蓬萊鎮組氣藏儲層孔隙結構及儲集性的因素有巖相、巖性條件及成巖作用；所有測試井自然產能都極低，必須經加砂壓裂后才有工業開采價值，且投產初期，油套壓下降較快，氣井產量下降迅速。 -
The subject for different process technology and surface treatment of crank takes tracking checkout for its internal stress, analyses relation of jumping measurement, deformation measurement, recovery measurement and stress change, finds the reason and usual law of jumping overproof of crank. through cold pressure alignment, hot pressure alignment, support aged alignment and so on methods for 42crmo steel crank, the subject checks change of stress in the process of alignment and change of tissue and property after alignment for crank, and gives comprehensive evaluation for every alignment technology, then give safe and feasible technology parameter
本課題主要是對不同加工工藝及不同表面處理過程的曲軸，對其內應力進行跟蹤檢測，分析各工藝過程中跳動量、變形量、恢復量與應力改變的關系，找出曲軸跳動量超差的原因和一般規律。通過對42crmo鋼曲軸進行「常溫壓力校直」 、 「熱壓力校直」 、 「支撐時效校直」等方法的校直，檢測校直過程中曲軸應力的變化及校直后組織和性能的改變，進而對各校直工藝進行綜合評價，給出安全可行的工藝參數。 -
It is a resistance device without pressure recovery.
這是一種沒有壓力補償的阻尼式裝置。 -
Some changes are needed in the configuration of the plant to reflect the changes that have occurred on the site, primarily that both the hydrogen recovery plant that was fed with purge gas and supplied instrument air and the site auxiliary boilers that provide low pressure steam have been dismantled
裝置布局發生了一些變化，主要的兩項就是拆除了氫回收裝置和輔助鍋爐，氫回收裝置消耗吹掃氣和儀表空氣，輔助鍋爐曾經用來提供低壓蒸汽。 -
Using the opened thermosiphon of 38x3 as experimental element and water as working fluid, the characteristics of dynamic low load boiling, stable severe boiling heat transfer coefficient and critical heat flux are gotten for the opened thermosiphon at the pressure of 0. 02 - 0. 1mpa and 0. 1 - 0. 8mpa respectively, which makes up the drawback that the opened thermisiphon has not yet accurate boiling heat transfer relationship formulas. by means of experimental results, an opened thermisiphon waste heat recovery boiler is designed for the high temperature gases that the positi e electrode copper refining furnace exhaust, which overcomes effectively the drawback of short life, little capacity and unable to inspect that the closed steel - water thermosion has
本文以工程上常用的38 3的開口封底為實驗元件，以水為工質，對開啟式熱管內的動態低負荷沸騰、穩態旺盛沸騰及臨界沸騰特性進行系統的可視化實驗研究，實驗壓力為0 . 02 0 . 8mpa ，實驗得出了38 3的開口封底管在工作壓力為0 . 02 0 . 8mpa和0 . 1 0 . 8mpa下的管內沸騰傳熱系數及臨界熱負荷計算關聯式，彌補了開口封底管? ?這一新型傳熱元件尚無準確的沸騰換熱關聯式的缺陷。 -
On the basis of these results, the relations of total - pressure recovery coefficient or flow coefficient and flight mach number, angle of attack and the second movable wedge angle of the inlet have been founded by hypersurface fitting, then the mathematical model of the inlet is established
根據流場計算結果並利用超曲面擬合方法建立了進氣道總壓恢復系數、流量系數與飛行馬赫數、進氣道攻角及二級可調斜板角度之間的關系，由此得到了二元混壓式超聲速進氣道數學模型。 -
When there are struts at the divergent parts of inlet, the total pressure recovery coefficients and the kinetic energy coefficients of inlet decrease, and the flow distortion index increases obviously
當進氣道擴壓段有側向支柱存在時，進氣道總壓恢復系數和動能系數均有所降低，而流場畸變指數則顯著增大。 -
The value of exercise test systolic pressure recovery rate in diagnosis of coronary heart disease
運動試驗收縮壓恢復比對冠心病的診斷 -
The results prove that : ( 1 ) when the mach number of the flow at the exit increases, the total pressure recovery decreases, and the circular steady total pressure distortion coefficient, turbulence intensity and synthesis distortion increase
研究結果表明： （ 1 ）地面工作狀態下，隨著出口馬赫數的增加，蛇形進氣道出口截面的總壓恢復系數不斷下降，而穩態周向畸變指數、紊流度和綜合畸變指數均上升，穩態徑向畸變指數變化不大。 -
Pressure recovery system ( prs ) is one of the key techniques for the high energy chemical lasers ( hecl )
壓力恢復系統（ prs ）是高能化學激光器的關鍵技術之一。 -
The main work in this paper includes three parts : the theory research on partially - cavitating and super - cavitating axisymmetric bodies, the numerical computations and experimental investigations on partially - cavitation and super - cavitation on axisymmetric bodies. after finishing the study of theory and experiment on the partially - cavitation and super - cavitation for axisymmetric body, i use the potential flow theory to build the mathematical model on the partially - cavitation and super - cavitation for axisymmetric body. many cavity wake models, such as pressure recovery close model, riabouchinsky model and re - entrant jet model, are studied seriously
本文在深入研究了回轉體局部空化與超空化理論及實驗結果的基礎上，基於勢流理論，建立了回轉體局部空泡和超空泡流場的基本數學模型，通過對kinnas和fine 、 uhlman以及jiedang和gertkuiper等人基於二維水翼提出的壓力恢復閉合模型、鏡像板模型和回射流模型等空泡尾流模型進行了逐一的研究分析，發現其中的壓力恢復閉合模型較適用於模擬回轉體空泡尾部流場，並選用此空泡尾流模型作為求解回轉體空化流場正問題與逆問題的數學模型的組成部分。 -
The keep - up pressure recovery of most oil - gas reservoirs and the gas storage measurement on some depletion reservoirs have been made in china, which have endlessly caused variation of pressure difference between inside - pore and outside - pore, followed by always changes of compressibility, porosity and permeability of rocks due to injection and production time and again of reservoir fluids
摘要目前我國許多油氣藏進行了保壓開采措施及對部分衰竭油氣藏進行儲氣庫改造措施，油氣藏流體反復注采，使得孔隙內外壓差不斷變化，導致巖石壓縮系數、孔隙度、滲透率發生著不斷的變化。 -
Abstract : optimum distances between primary nozzle exit and mixing tube inlet, static pressure recovery of the mixing flow in mixing tube 、 total pressure distributions at the exit of mixing tube 、 pumping coefficients and total pressure losses of the exhaust ejector systems with four different types of primary nozzles have been measured in the experiments
文摘:對4種主噴管組成的排氣引射系統的引射系數和總壓損失、各主噴管出口與混合管進口之間的最佳間距、混合氣流在混合管內的靜壓恢復及混合氣流在混合管出口處的總壓分佈等進行了測量和對比。 -
In order to be convenient for use, reducing the volume of the whole laser system has become the important goal for the designer. the pressure recovery system ( prs ) takes up the most of the volume of the laser system. so, to study on how to improve the recovered pressure of the laser can reduce the burden of the prs at the end of the laser system, then the volume of the whole laser system can be reduced
為了便於使用，減小激光器系統的體積成為了設計追求的重要目標。因為壓力恢復系統在整個化學激光器中佔有較大的體積，所以，研究化學激光器中與壓力恢復相關的問題，設法提高激光器的恢復壓力，這樣就可以減少對激光器後部壓力恢復系統的要求，從而減小系統的體積。 -
This project mainly studies the determination of principle solution by effect in conceptual design and its software development. the study result is applied to the improved design of speedy cutting off valve in trt ( top gas pressure recovery turbine ), and the solution to the problems existing in the speedy cutting off valve is put forward
本課題主要研究效應用於概念設計中原理解的確定方法及其軟體實現，並將其應用於高爐煤氣余壓回收透平發電裝置（ topgaspressurerecoveryturbine ，簡稱trt ）中快速切斷閥的改進設計，提出存在問題的解決方案。 -
When the serpentine inlet is running at the exit mach number ma ( subscript e ) = 0. 45, the total pressure recovery coefficient equals 0. 90, and synthesis distortion equals 13. 85 %
本研究的蛇形進氣道在出口馬赫數為0 . 45時，總壓恢復系數為0 . 90 ，綜合畸變指數為13 . 85 % ，總壓恢復較低，畸變較大，超出了一般航空發動機的承受范圍。 -
Secondly, the cfd method is used to study the flowfields in the laser chamber and the loss of the total pressure in several types of nozzles. the answer shows that reducing the length of the nozzles and the high of the throats in the nozzles can reducing the loss of the total pressure. and the answer also shows that the small nozzles with helium injected in the base region are good for laser chamber pressure recovery
其次，本文利用cfd技術模擬了光腔流場，研究了幾種噴管的總壓損失特性。研究結果表明，對于平面對稱噴管，減小噴管長度，增加喉道高度有利於減少總壓的損失。用cfd技術對光腔段的模擬表明，採用小尺寸噴管，並且在基區大量注入氦氣有利於激光器壓力恢復。 -
Liquid pressure recovery factor
液體壓力恢復系數 -
Experimental results of the air pumping of a serpentine inlet under ground running show that the total pressure recovery at the exit is low and the distortion at the exit is large
摘要對一種蛇形進氣道開展了地面工作狀態下的抽吸試驗研究，結果表明，在該狀態下進氣道出口截面的總壓恢復系數較低、流場畸變較大。
分享友人