pressure turbine 中文意思是什麼

pressure turbine 解釋
反喚水輪機
  • pressure : n 1 壓;按;擠;榨。2 【物理學】壓力,壓強;大氣壓力;電壓。3 精神壓力,政治[經濟、輿論等]壓力。4...
  • turbine : n 【機械工程】(渦)輪機,葉輪機,汽輪機,透平機。 a hydraulic [water] turbine 水輪機。 a steam t...
  1. Specifications for steam turbine low pressure feed water heaters

    汽輪機低壓給水加熱器技術條件
  2. The turbine is spun by the high-pressure gases.

    渦輪由高壓燃氣驅動旋轉。
  3. New and improved nickle - base, iron - nickle - cobalt - base superalloys were available for use in high - pressure turbine airfoils in aircraft gas turbines

    新改進的鎳基、鐵鎳鈷基超耐熱合金可用在飛機燃氣輪中的高壓透平機翼上。
  4. When water is pressurized beyond the critical pressure point, steam is produced to drive a turbine

    當水加被加壓到超越臨界點的壓力,產生的蒸汽可以驅動一個渦輪機。
  5. At the sometime, a set of backpressure turbine generator of 15mw with the inlet steam pressure of 110kg cm

    的抽凝式汽輪發電機組,一臺
  6. Hydrostatic tests for steam turbine pressure parts

    汽輪機承壓件水壓試驗技術條件
  7. According to the question of using natural cooling will prolong the period of opening cylinder for overhaul, we expound three modes for the steam turbine quickly cooled after being stopped, these are vacuum and aeration - cooling, pressure - air cooling and steam 1ing, then analysis and contrast them

    摘要針對汽輪機採用自然冷卻方式會延長機組檢修開缸時間的問題,提出了汽輪機停機后的三種快速冷卻方式:抽真空通汽冷卻法、壓縮空氣強迫冷卻法和蒸汽冷卻法,並對這三種方式進行了比較和分析。
  8. By using harika algorithm, the characteristic of a high - pressure compressor is calculated at different installation angle of the inlet guide vane and the stator vanes ; the characteristics of a high - pressure turbine and a low - pressure turbine are simulated at different installation angles of the guide vane based on ainley method

    本文用harika演算法計算了導流葉片和靜子葉片安裝角度可調的變幾何高壓壓氣機特性;用ainley法計算了渦輪導向器面積可調的高壓渦輪和低壓渦輪的特性。
  9. Based on an engineering background, through numerical simulation of the flow field in the hp turbine of the energy efficient engine ( e3 ), the article research the unsteady flow in a transonic turbine stage, the unsteady phenomena in the stage include the shockwave, wake, shedding vortex, endwall vortex, passage vortex and leakage vortex, etc. there are two shockwaves generated on the vane the tailing edge, one on suction side is named moving shockwave, and name another on pressure side steady shockwave

    本文首先對于研究的意義和國內外研究的現狀做了簡要的介紹,再從某工程背景出發,通過對e3發動機高壓渦輪內流場的數值模擬,研究了干涉的周期性的問題,以及渦輪級內常見的非定常現象:激波、尾跡、脫落渦、根腳渦、通道渦、漏流渦。導向器尾緣會出現兩道激波,在吸力面的激波可稱為「運動」激波,壓力面的激波可稱為「定常」激波。
  10. Retrofit of 25 mw intermediate - pressure turbine and economic analysis of high - intermediate - pressure associate turbine

    機組改造和與高壓機組聯合運行的經濟性分析
  11. Load / pressure plant of turbine - generator unit is a complicated multivariable control plant

    火電廠單元機組負荷/汽壓對象是一個相對復雜的多變量控制對象。
  12. The thesis analyzed the principle of “ hp inlet pressure control ” and the application, which based on the analysis of daya bay and lingao turbine control system ( gre ), in addition, the problems and the way to prevent during the normal operation also be concerned in this article

    本文詳細分析了大亞灣核電站和嶺澳核電站汽輪機的壓力控制的原理及實現方式,並結合應用案例,分析了設計及實際應用中容易出現的問題,以及避免這些問題的對策。
  13. These variable geometry components include high pressure - compressor, high - pressure turbine, low - pressure turbine, inlet area ratio of mixer and main nozzle throat area. the results of calculation show that the adjusting of low - pressure turbine and mixer has a remarkable effect on the performance of engine and bypass ratio

    計算結果表明,低壓渦輪和混合器的調節對發動機的性能和涵道比的影響尤為顯著;在其它部件幾何結構不同時,單個部件幾何調節后,發動機性能的變化趨勢是不同的。
  14. Mixed pressure turbine

    混壓渦輪機
  15. The long - term life and low cycle fatigue life of low pressure turbine blade for an aeroengine under real loading spectrum is analyzed by using this method

    用該方法對某型發動機低壓渦輪工作葉片在實際飛行載荷譜作用下的持久壽命和低循環疲勞壽命進行了分析。
  16. Back pressure turbine

    背壓渦輪機
  17. To investigate the aerodynamic design ideas and concrete methods of high performance low pressure turbine ( lpt ) at low reynolds number condition, a new lpt of high load, large chord and proper velocity distribution was designed

    摘要為了探索高空低雷諾數情況下高性能低壓渦輪部件的氣動設計思路和設計方法,通過採用高負荷、大弦長的葉片設計和選擇恰當的葉片表面速度分佈形式設計了一臺新低壓渦輪。
  18. A simplify high pressure turbine ( hpt ) tip clearance model is analyzed with the cyclic symmetry method. research on the flow, heat and structure integration analyses is achieved in this paper. flow / heat analysis is done by fluent software, and heat / structure analysis is done by ansys software

    針對渦輪部件的結構特點,進行了適當的簡化,利用參數化設計思想建立了渦輪葉尖間隙計算模型,用循環對稱的方法分析了某型發動機高壓渦輪葉尖間隙在工作過程中變化的情況。
  19. Multi - pressure turbine

    多壓渦輪機
  20. Intermediate pressure turbine

    中壓渦輪機
分享友人