proportional range 中文意思是什麼

proportional range 解釋
比例度
  • proportional : adj （成）比例的；相稱的，平衡的，調和的 （to）。 a proportional number 比例數。 a proportional e...
  • range : vt 1 排列；整理（頭發等）。2 使歸類[班、行、隊]；把…分類。3 〈用被動形或反身形〉加入，站住…的一邊...
  1. The temperature of the system is precisely controlled by a proportional valve to maintain within a tolerance range of plus or minus 2 & degc

    本機溫度控制採用比例式控制閥，溫控精準可控制在2 & degc以內。
  2. Was added, the absorption of morin at 350nm decreased and a new absorption peak at 419nm appeared. adding of nucleic acids to the morin - al binary system leads to decrease of the absorption at 350nm and great increase at 419nm. there is an isochromatic point at 370nm. the increase of absorbance at 419nm is proportional to the amount of nucleic acids added within certain concentration range. based on this, a new sensitive nucleic acids analysis method is established. the linear ranges of ct dna, fs dna and y rna are 0. 7135. 4 0. 6425. 6 and 0. 9428. 4g ml, respectively

    鋁離子的加入使桑色素350nm處的吸收峰下降，在419nm處出現桑色素-鋁絡合物的吸收峰。再往桑色素-鋁離子二元體系中加入核糖核酸或脫氧核糖核酸，則進一步引起桑色素350nm吸收峰的降低， 419nm處的吸收大大加強，同時在370nm處有一等色點。 419nm處吸光度的增加值與加入的核酸量在一定范圍內成正比，基於此建立了在較寬范圍內測定核酸的方法。
  3. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  4. At a given location, however, the strength of the tidal current is generally proportional to the relative tidal range for that day

    然而，在一定的地點，潮流強度一般與那一天的相對潮差成正比。
  5. In the large range of bridge length between inner pinholes, the rupture pressure is positively proportional to the bridge length remarkably

    在可能的橋長變化范圍內，結構爆破壓力與橋長間存在顯著的正比關系。
  6. Because vortex flowmeter has no movable mechanical parts, the output signal of it is a frequency signal that is proportional to flow signal, and it has less pressure loss, wider measurement range, it is used widely

    由於渦街流量計具有無機械可動部件，可得到與流量成正比的頻率輸出信號，壓力損失較小和量程比較寬等優點，因而應用相當廣泛。
  7. The relationship between sputtering conditions and the depositional speed shows : with working pressure 1. 2 pa, sputtering power 180w, the depositional speed of tio2 thin film is 40nm / h, and increases with the increasing of sputtering power. it can be also founded that the depositional speed is nearly proportional to the working pressure : within the range of 0. 3pa to 1. 6pa, the depositional speed increases linearly with the increase of ar pressure. with the enhancement of the substrate ' s temperature of sputtering or annealing, the resulted thin films show a tendency of decreasing in thickness, and increasing in refractivity

    本實驗是採用磁控濺射方法，在不同的溫度下制備了tio _ 2薄膜，並對薄膜進行了不同溫度和時間的退火處理，通過原子力顯微鏡（ afm ） 、 x射線衍射（ xrd ） 、掃描電鏡（ sem ）等檢測手段對薄膜的表面形貌和組成結構進行了分析，結果如下： （ 1 ）濺射工藝條件與薄膜沉積速度的關系表明：採用1 . 2pa工作氣壓， 180w的射頻功率tio _ 2薄膜的沉積速率為40nm h ，並隨射頻功率的增加而提高，呈近似的線性關系，在0 . 3pa 1 . 6pa氣壓范圍中，氬氣壓強升高沉積速率迅速增加，濺射溫度提高和退火處理能使薄膜的厚度減小和折射率提高。
  8. Referring to the theory of the modern air - combat, the thesis discusses the process of beyond visual range air combat about “ air - to - surface precise attack ” ; according to the optimal strategy, studies respectively the four key techniques, which are multi - target sorting, multi - aircraft cooperative air - combat and the optimization of proportional navigation of the fighter and the technique of the associated attack and defend of group fighters

    借鑒現代空戰理論，對「空對面精確打擊」中的超視距作戰過程進行了系統論述，對超視距空戰中的四個關鍵技術多目標排序、多機協同空戰，機群聯合攻防及戰機導引律的優化分別進行了研究。
  9. This paper analyses the type, function and characteristics of usual proportional control valves and raises a new modificative version in the light of their drawback. that is, basing on the principle of flow amplification and electrical feedback and throughout calculation and analysis on flow closed loop control and pressure flow combination., determination of the minimum controlled pressure difference as well as flow controlling range and structure of main valve and research of the dynamic and static characteristic, the paper puts forward control principle of " flow - load pressure change - displacement revision " and pressure / flow double closed loop, and further expounds that using a proportional controller and a electric mechanical transducer can separately serve the control function of pressure or flow as well as flow pressure combination

    本論文分析了目前常用比例閥的類型、功能、特性，並針對其不足提出新的改進方案，即：以流量放大，電反饋兩個原理為基礎，通過對流量閉環控制及壓力流量復合的計算分析、確定上最小控制壓差及流量控制范圍，確定主閥結構、功能特性研究等，提出了「流量? ?負載壓力變化? ?位移修正」的控制原理和壓力流量雙閉環控制原理，並進一步論述了利用一個比例控制器和一個「電?機械轉換器」就可完成獨立的壓力或流量控制功能以及流量壓力復合控制功能。
分享友人
分享到 Line

分享到臉書