pulsed signal 中文意思是什麼

pulsed signal 解釋
脈沖信號
  • signal : n 1 信號,暗號;信號器。2 動機,導火線 (for)。3 預兆,徵象。adj 1 暗號的,作信號用的。2 顯著的...
  1. In this paper, wavelet neural network is used to extract the signal feature of three millimeter pulsed radar, and the simulation is done by the computer

    本文將小波神經網路用於三毫米脈沖體制雷達回波信號特徵的提取並做了計算機模擬。
  2. Intelligent counter digital frequency rotating speed line velocity display control transmit instruments are all adopt used advanced microprocessor for smart control. input is pulsed quantity or contect switch quantity signal, after cpu operation processing, count, rotating speed or line velocity will be clearly intuitional indicated by high brightness led numeral tube, at the same time, these signals can be changed into standard voltage current signal to transmit output. and have the functions of super - limited alarm, standard serial communication function

    簡易后備操作器接收從dcs系統或pid調節器給定的模擬量信號,正常控制時,操作器輸入輸出相當于直通的,以實現dcs系統或pid調節器對執行機構的自動控制,當前級dcs系統或pid調節器發生故障時,操作器接收到故障狀態信號,即轉為手動控制狀態,由按鍵控制操作信號的輸出,當故障解除,儀表自動恢復自動狀態。
  3. Are all adopt used advanced microprocessor for smart control. input is pulsed quantity or contect switch quantity signal, after cpu operation processing, count, rotating speed or line velocity will be clearly intuitional indicated by high brightness led numeral tube, at the same time, these signals can be changed into standard voltage current signal to transmit output. and have the functions of super - limited alarm, standard serial communication function

    接收從dcs系統或pid調節器給定的模擬量信號,正常控制時,操作器輸入輸出相當于直通的,以實現dcs系統或pid調節器對執行機構的自動控制,當前級dcs系統或pid調節器發生故障時,操作器接收到故障狀態信號,即轉為手動控制狀態,由按鍵控制操作信號的輸出,當故障解除,儀表自動恢復自動狀態。
  4. Raw thermal images acquired by pulsed thermography ( pt ) usually have low signal noise ratio ( snr ) and temperature contrast

    摘要脈沖熱像檢測中直接獲取的原始熱像往往信噪比較低、對比度較差。
  5. Combined with the key project of the preliminary research of national defence science and technology, the target recognition system for millimeter wave initiative homing guidance, a systematic study on the signal processing method based on the background of millimeter mave ( mmw ) missle - borne pulsed doppler radar is performed. it include specifically the detction and the recognition of the moving target and hovering helicopter under strong clutter background

    本文結合國防科技重點預研項目「毫米波主動尋的制導目標識別」 ,針對脈沖多普勒體制雷達導引頭的應用背景,對基於彈載高重頻脈沖多普勒體制雷達的信號處理方法進行了較深入的研究。主要研究內容包括對雜波背景中的機動目標以及對懸停直升機的檢測和識別方法。
  6. In particular, based on the complex analytical signal theory, the solutions for the components of a pulsed gaussian - like beam in rectangular symmetry are derived and compared with those derived from slowly - varying - envelop - approximations ( svea )

    本部分給出了時間波形為gauss 、 hyperbolicsecant和lorentz的脈沖光束奇異性的計算模擬,並給出了解決這些奇異性的復解析信號( complexanalyticalsignal )解。
  7. But the complex analytical signal ( cas ) theory can erase this spatial sigu - larity. in this section, gauss, hyperbolic and lorentz pulsed gaussian beam have been derived and compared svea and cas solution by numerical simulatio n. in section 3, by using fourier transform technique and applying the paraxial approximation in frequency domain, we derive an integral solution for the transverse and longitudinal components of the light field propagating in free space

    接著,考慮了幾種特殊的脈沖gauss光束( pulsedgaussianbeam ) ,結果顯示,在此情況下緩變包絡近似( slowly - varyingenvelopeapproximation )理論已不再有效,其失效的原因是,該理論導致了脈沖光束解的空間奇異性,並使脈沖光束不再具有符合物理意義的光束行為,而通過復解析信號的分析方法可以消除這種空間奇異性。
  8. At the same time, it uses a frequency translator to obtain a frequency shift, which is equal to the brillouin frequency in fiber. then the detecting pulsed light and the cw reference light can coherent. this method greatly improved the system ’ s sensitive and signal to noise ratio ( snr )

    同時在探測光路中引入一個光移頻環路,使探測光移頻后再經光纖中布里淵頻移,其後向布里淵散射光頻率與參考光束大致相當,可進行相干自外差探測,大大提高了系統的探測靈敏度以及系統的信噪比。
  9. The working principle of pulsed eddy current ( pec ) nondestructive testing technology is analyzed, the pec testing system was been established to examined the specimen of multi - layered aircraft structure, peak and zero - crossing time of the time domain transient response signal of pec are extracted as the features to detect the corrosion in the second layer of aircraft structure quantificationally, the experiment results are consistent with that of the theory analysis, as the pec have the advantages of fast speed and quantification, this makes the method have the broad using foreground in the testing of aircraft structure corrosion

    摘要對脈沖渦流無損檢測技術的工作原理進行了分析,建立了脈沖渦流的檢測系統對加工的模擬飛機多層結構的試件進行了測試,提取其時域瞬態感應信號的峰值和過零時間作為特徵量,對出現在飛機多層結構第二層中的腐蝕缺陷進行了定量檢測,試驗結果和理論分析相一致,證明了脈沖渦流檢測方法的有效性,由於其具有快速和定量化的優點因而在飛機結構的腐蝕檢測中具有廣闊的應用前景。
分享友人