pwm 中文意思是什麼

pwm 解釋
脈沖寬度調制，被用來進行充電控制。
常見于諾基亞手機的充電控制電路。

  1. In addition, we analyse the dead time effects of pwm control on the output waveform

    另外還分析了逆變橋上下管驅動信號上的死區對輸出電壓波形的影響。
  2. The generation of pwm baseband digital signals and the demodulation

    基帶數字信號的產生與檢測
  3. A circuit topology of the inverter with duty cycle extended active clamp forward style high frequency pulse dc link is adopted by each independent inverter. each inverter is cascaded by a circuit with duty cycle extended active clamp forward style high frequency pulse dc link and a dc / ac inverting bridge. the control strategy of voltage mode pwm forwardback is adopted by the former, and the control strategy of three - state discrete pulse modulation ( dpm ) hystersis current is adopted by the later

    每個獨立的航空靜止變流器採用占空比擴展有源箝位正激式高頻脈沖直流環節電路拓撲，由占空比擴展有源箝位正激式高頻脈沖直流環節電路與dc ac逆變橋級聯而成，前級採用電壓型pwm前饋控制技術，后級採用三態dpm電流滯環控制技術。
  4. In the next place, by studying the change of the resonant frequency of the whole system, this paper designs the circuit to track the resonant frequency of the system by cd4046 mainly. at the same time, in order to improve the efficiency and get better dynamic capability of the converter, we choose pll and fuzzy control after comparing the pll circuit, fuzzy circuit and pll ? fuzzy control circuit. in the end, this paper brings forward the control blue print to realize the drive control circuit of the high frequency converter, using the dsp chip as the key part to realize four routes of pwm drive pulses with dead band of the control system

    其次，通過對整個系統諧振頻率變化的分析和研究，設計了以鎖相環cd4046為核心的鎖相環控制電路，同時，在綜合比較鎖相環控制、模糊控制以及模糊控制和鎖相環復合控制三種控制演算法的基礎上，進行了系統模擬，得出採用復合控制可使跟蹤電路既具有鎖相環路較好的穩態性能，又擁有模糊控制較好的動態性能，系統魯棒性能好，同時也提高了逆變器的效率。
  5. This paper presents a method that chopping wave is done by switch devices which consist of three - level resistance regulating module and intelligence power module ipm, and which realizes constant - current discharge of storage battery. to achieve the intelligence control of the drive protection and the discharge process of ipm, the paper designs circuit formed by igbt threshold drive pulse pwm signals. ipm fault - blocking protection circuit and microcomputer 80c196. the devices can accurately control the 0 ~ 150a discharge current and the discharge time of the storage battery and calculate the releasing power

    實現蓄電池恆流放電過程智能控制是蓄電池放電裝置發展的必然趨，本文提出了一種通過三極電阻調節模塊和由智能功率模塊ipm為開關器件進行斬波從而實現蓄電池恆流放電的方法。為達到對ipm的驅動保護和放電過程的智能控制，文中設計了igbt門極驅動脈沖pwm信號形成電路和ipm故障封鎖保護電路及由單片機80c196為核心的微機控制器。本裝置能夠對蓄電池進行0 150a放電電流及放電時間的精確控制及釋放容量的計算。
  6. 3. added engine system, icm and pats of pwm protocol

    3新增了pwm協議發動機系統z5 icm儀表系統pats被動防盜系統。
  7. Some studies on control modes of the system, especially on a dc, pm, brushless and sensor - less motor driven systems. a method of rotor position identification without sensors has been developed. using a microchip to increate system efficiency, anti - disturbing ability and reliability of pwm modulation

    研究了適于直流、無刷、永磁、無位置傳感器電機轉子位置的檢測方法；採用單片機實現了該種電機的運行控制，提高了系統在pwm調制時位置檢測換相控制過程的抗干擾能力。
  8. Digital pwm techniques for sine inverter power

    正弦逆變電源的數字脈寬調制技術
  9. A novel phase - shifted zero - voltage and zero - current switching pwm dc / dc full - bridge converter is presented in this thesis, which is based on the groundwork of summarization of the development of power electronics in recent years and lucubration in theoretical basis of modern high frequency soft switching power convert technique and analysis of operation principle, characteristic of the circuit and inherent drawbacks of the traditional phase - shifted zero - voltage switching pwm dc / dc full - bridge converter

    本文在對近年來電力電子學科的發展高度綜述和對現代高頻軟開關功率變換技術理論基礎深入研究的基礎上，對傳統的移相控制zvspwmdc dc全橋變換器的工作原理、電路特性、存在的缺點進行了分析，在此基礎上提出了一種改進型的移相控制zvzcspwmdc dc全橋變換器。
  10. Secondly, according to the character of this kind of harmonic, the solutions of power filter are deeply analyzed and an optimized topology for series connected hybrid power filter is obtained. by pwm technique, midfrequency transformer and the principle of the magnetomotive force ( mmf ) compensation, the problem to the transfer of the low - frequency harmonic power compensatory signal in the series apf is solved, in technique

    其次，針對acem系統特有的「電源諧波」特性，深入分析了濾波器方案，得到了一種適用於acem系統諧波抑制的串聯混合型有源電力濾波器優化拓撲結構，並採用了pwm調制技術、中頻注入變壓器和磁勢補償原理有效地解決了串聯apf中低頻諧波功率補償信號傳輸的難題。
  11. Research on double pwm pulse mig feed - wire circuit based on c8051f

    焊送絲電路的研究
  12. In the positioning servo - system, which generally is configured by the d. c. pulse width modulator ( pwm ) velocity governing system and position servo - loop, the parameter perturbance of pwm velocity loop really exist by reason of such as the load behavior ; power voltage supply ; operating setting value, etc. 1, 2 ， and it cannot be ignored. by using the identification technique to form the mathematical model of the system, authors have confirmed the facts. therefore, to design the discrete sliding mode controller ( dsmc ) of the positioning servo - system, the perturbed parameters value bounds of the pwm velocity loop, which is as the controlled plant of position servo - loop, should be accounted. consequently, the design principle of dsmc for accounting system with parameter perturbance is proposed by the authors. the proposed method can ensure the stability of system with parameter perturbance and the behavior of non - overshoot, fast precise positioning. in order to reveal the effects of the design method, the comparative research work is done by the authors. also, it has been tested in an industrial experiment, the results proved it is satisfactory

    由直流脈寬調速系統（ pwm ）和位置環構成的定位系統中，速度環的參數隨負載特性；電網電壓；給定工況而攝動是不容忽視的.作者通過系統辨識建模也證實了這一事實1 ， 2 .因此在設計位置環的離散滑模控制時，必須針對速度環（即位置環的控制對象）的參數攝動范圍採用「對象參數攝動離散滑模控制器的設計方法」 ，以確保系統在參數攝動時的穩定性和快速、無超調、準確定位的優良動態品質.為剖析該設計方法的控制效果，本文作了對比性研究，並將該設計方法用於工業試驗中，取得了滿意的結果
  13. Space vector simplified algorithm of three phase pwm rectifier

    整流器空間矢量簡化演算法
  14. Lyapunov - based control of three - phase pwm rectifier - inverter

    逆變系統的李亞普諾夫控制
  15. Based on the tms320f240 controller produced by ti company, the hardware and software designation of the symmetrical voltage space - vector pwm is presented. designed a digital controller with tms320f240 to modulate the speed of the motor, in which the keyboard and led display are bedded. it can be to set the frequency of motor and display the run frequency of motor in real time

    基於ti公司的tms320f240控制晶元，介紹了對稱空間電壓矢量硬體設計和軟體設計，採用tms320f240設計了一款用於電機變頻調速的數字控制器，該控制器上設計有鍵盤和led顯示，可以設定和動態顯示電機運行頻率。
  16. Direct current servo control system of pwm based on tl

    直流伺服控制系統
  17. A novel pwm dc converter with snubber cell

    一種新的帶有緩沖單元的脈寬調制式直流變頻電路
  18. However, the efficiency of pwm at light load is low and the filter design of pfm is rather difficult due to the random characteristic of the frequency spectrum distribution

    採用相應調制方式的ic品種繁多，各有千秋。但pwm在輕載時效率較低，而pfm由於頻譜分佈隨機，不利於后續濾波器的設計。
  19. In this study, the load charateristics of submergible centrifugal pump and the influence of various regulating methods on energy dissipation are analyzed. the loading capacity of the submergible motor in variable speed drive control process is analyzed. the papers simple discribe the basic structure of the variable speed drive system in electric submergible pump > principle of pwm inverter and the basic structure of igbt

    在研究中，對潛油離心泵負載性能以及閘閥調節和調速調節對能耗的影響進行了分析；對潛油電動機在變頻調速的負載進行了分析；對潛油電泵變頻調速系統的基本結構、 pwm逆變器原理以及igbt的基本結構進行了簡單介紹。
  20. A novel bi - directional dc / dc converter was introduced in the dissertation, which based on refer much converter data. the soft switching, phase - shifted pwm and bi - directional dc / dc converter hang together, depress circuit switch ullage and noise effectively, which provide condition to increase switch frequency, efficiency and reduce size and weight for the converter ; at the same, the converter have the virtue of structure compact, voltage and current stress small etc such as ordinary hard switch converter

    本文作者在查閱國內外大量雙向dc dc變換器資料的基礎上，採用一種新型雙向dc dc變換器的拓撲結構，把軟開關技術和移相控制pwm技術以及雙向dc dc變換器技術有機結合在一起，有效地降低了電路的開關損耗和開關噪聲，為變換器裝置提高開關頻率、效率以及降低尺寸及重量提供了良好的條件。
分享友人
分享到 Line

分享到臉書