quenching in water 中文意思是什麼

quenching in water 解釋
水冷韌化處理
  • quenching : n. 【機械工程】淬火;【物理學】淬熄。
  • in : adv 1 朝里,向內,在內。 A coat with a furry side in有皮裡子的外衣。 Come in please 請進來。 The ...
  • water : n 1 水;雨水;露;〈常作 pl 〉 礦泉,溫泉;藥水。2 〈常 pl 〉水體;水域;水道;海;湖;河;海域;...
  1. In this paper, 6013al / sicp / gr metal matrix composite ( mmc ) was produced by spray codeposition, by means of changing the medium of quenching, influence of five types of heat treatment system ( furnace cooling, air cooling, water quenching, dry ice quenching, liquid nitrogen quenching ) and different aging temperature on the damping was studied systematically

    本文採用噴射共沉積方法制備了6013al sicp gr金屬基復合材料( mmc ) ,通過改變淬火介質,較為系統地研究了五種熱處理制度(爐冷、空冷、水冷、乾冰冷及液氮冷)以及不同時效溫度( 120 、 150 、 170 、 190及210 )對6013al sicp grmmc阻尼性能影響。
  2. After the stolon had suffered from severing disturbance, clonal ramets could keep photosynthetic organ from being damaged through the plastic responses of the chlorophyll fluorescence traits, such as increasing nonphotochemical quenching of chlorophyll fluorescence ( npq ), decreasing actual photochemical efficiency of ps ii in the light ( f / fm " ) and photochemical electron transport rate ( etr ). moreover, the clonal ramets could also increase water use efficiency by means of decreasing stomatal conductance

    在匍匐莖受到切斷干擾后,臭柏能通過提高非光化學猝滅( npq ) 、降低ps實際光化學量子產量( f fm 』 )和表觀光合電子傳遞速率( etr )等葉綠素熒光特性的可塑性反應來保護小枝光合機構不被破壞,並且可以降低氣孔導度以提高水分利用效率。
  3. After the coke being puted into the coke - quenching device, the lid of the device should be shut at once. while the suction pump, refrigeration compressor, high pressured water circuling pump are started, the subpressure will be produced by the burning coke. then, in the vacuum, the coke will be extinguished in a flash. the burning of the coke instantly, still, produces a large quantity of heat which can be taken away by circulating water in refriger and the interlayer, after that, the temperature will fall to 60oc, even lower. in this condition, the coke will be pushed out to be stored, thus, the coke won ' t rekindle

    當焦炭推上攔焦車進入熄焦器后,立即關閉罐蓋,同時啟動真空泵、冷凍機、高壓循環水泵,這時,燃燒著的焦炭就會因真空泵把熄焦器內抽成負壓,由於缺氧,使焦炭熄滅,雖然煤炭在瞬間被熄滅,但由於焦炭生成過程中所產生的大量的熱量還存在,這時,冷凍機和夾層中的循環水的工作就會把焦炭中的熱量帶走,使之在短時間內將溫度降到60以下,在這種狀態下把焦炭從熄焦器內推出入庫,焦炭就不會復燃。
  4. ( 3 ) solid solution with good solid solution ability were acquired by solid soluting treatment for 25 min at 540 c, 560 c and 580 c, respectively, after that water quenching was carried on. in the case of 580 c, the coarseness of the precipitation at grain boundaries did not happen, equi - part 120 did not emerge at the intersection of three grains, these suggest that over sintering did not happen

    6013合金實驗熱軋板材經固溶處理後於180時效4小時達到峰值硬度; ( 3 ) 540 、 560 、和580固溶處理25min 、水淬,得到了固溶充分的固溶體, 580的情況下晶界析出相未粗化、三晶粒交界處的角度未出現等分的120 ,表明未發生過燒。
  5. At the same time, water quenching at 190 aging exhibit the highest damping capacities. compared with furnace cooling which show the highest damping capacities in five heat treatments, it show higher damping capacities when tempera ture is under 120 and above 290. further more, it show constantly damping value ( tan above 0. 004 ), but the damping value of furnace cooling is just 0. 0015 under 75

    水淬試樣在190的時效溫度下有最高的阻尼性能,通過與爐冷試樣的阻尼性能(五種熱處理制度爐冷試樣的阻尼性能較高)對比發現,在溫度低於120 、高於290范圍,水淬試樣在190時效溫度下的阻尼性能均高於爐冷試樣的阻尼性能,在120 290之間,它的阻尼性能低於爐冷試樣的阻尼性能,而此溫度區間正好是位錯內耗峰出現的溫度范圍。
  6. On - line monitoring of dissolved oxygen in water by a fiber - optic chemical sensor based on fluorescence quenching

    基於熒光猝滅原理的光纖化學傳感器在線監測水中溶解氧
  7. Second, on the numerical arithmetic of the quench - induced residual stresses ground, the quenching process of 7075t73 aluminum plate is simulated, the effect of material characteristics along with the plate temperature varying in quenching is considered, and on conditions of the different water temperature and different plate thickness, the quenching processes are compared

    2 、建立了航空鋁合金板材淬火過程的彈塑性力學模型,對航空鋁合金板材溫度場與應力場進行了數值模擬,模擬過程考慮了材料特性隨溫度變化的影響,並對不同的淬火影響因素進行了分析。
  8. Emquen p fluids are synthetic, oil - free quenching bases, inversely soluble in water and inhibited against ferrous corrosion

    Emquen p為具備逆溶解性與對鋼材抗腐蝕配方的不含油合成型濃縮淬火液。
  9. Emquen p fluids can dissolve easily in water at typical concentration form 5 % to 50 % depending on quenching speed desired

    Emquen p可輕易溶於水中,根據實際應用中對淬冷速率的不同要求,以5 - 50 %的濃度兌水使用,可提供高度潔凈的完工工件表面。
分享友人