quiescent current 中文意思是什麼

quiescent current 解釋
電信號電流
  • quiescent : adj. 1. 不動的，靜止的。2. （蠶等）靜止期的，休眠的。3. 寂靜的，沉默的。4. （疾病等）被遏制的，無癥狀的。adv. -ly
  • current : adj. 1. 通用的，流行的。2. 現在的，現時的，當時的。3. 流暢的；草寫的。n. 1. 水流；氣流；電流。2. 思潮，潮流；趨勢，傾向。3. 進行，過程。
  1. The typical ground current ( quiescent current ) is 1ma at full load, 60 a with no load and, and less than 1 a in shutdown mode

    在滿負載條件下，靜態電流為1ma ;在空載情況下，靜態電流為60 a ;在關斷情況下，靜態電流小於1 a 。
  2. The typical performance characteristics include : line and load transient response, efficiency, output voltage ripple, quiescent current, maximum load current, output voltage temperature characteristics and the short

    其中，整體模擬指標包括:晶元線性調整率和負載調整率、轉換效率、輸出電壓紋波、晶元靜態電流、最大負載電流、輸出電壓溫度特性及短路負載電流。
  3. Electricity power system computer simulation the computing include the current computing, simple fault computing, complicated fault computing, quiescent stabilization the computing and development stabilization the computing etc. because the computing software of electricity power system are all the earlier words software, it is very difficulty for studying and isn " t easily for using and ca n ' t draw the graphics of the electricity power system ect

    對電力系統的運行狀態進行分析需要進行大量的計算，電力系統計算機模擬計算主要包括潮流計算、簡單故障計算、復雜故障計算、靜態穩定計算和動態穩定計算等計算。本文針對當前電力系統計算軟體大多都是早期的字元界面的軟體，學習難度大，不易使用，以及不具備電力系統圖形繪制等弊病，對microsoft公司的visualc + + 6 . 0及其所提供的microsoft基礎類庫（ mfc ）展開了理論與應用的研究工作。
  4. The on - resistance of the synchronous rectifier is as low as 0. 4 ?. it has a very high efficiency even in the light load thanks to its low quiescent supply current

    整個晶元具有極低的靜態電流，使得此晶元即使在輕載的時候也有很高的效率。
  5. With the “ skip ” modulation technique, quiescent current are reduced to a minimized value of 1ma with full load, 60ua with no load, and less than 0. 01ua in shutdown mode

    在典型情況下，晶元滿載時的靜態電流為1ma ，空載時的靜態電流僅為60ua ，關斷電流小於0 . 01ua 。
  6. The driver has the quiescent current under 1 a and also has soft - start circuitry to limit inrush current flow at power up. the chip can be operated normally in the temperature range of - 40 to 85 according to the simulation results. the brightness of the white leds can be controlled by using a dc voltage or a pwm signal applied to the pin with a few external components added

    系統採用0 . 5 mcmos工藝;輸入電壓范圍為2 . 7v到5 . 5v ;在關閉狀態下消耗電流小於1 a ;具有軟啟動功能，可減小啟動過程中的浪涌電流;具有短路及過熱保護功能，工作溫度范圍為- 40至85 ; led亮度控制可以通過外加dc或pwm電壓信號和很少的外部元件實現。
  7. The current based test method can be divided into two categories, the one is quiescent current test ( iddq testing ) and the other is transient current test ( iddt testing )

    為了降低測試成本並且提高集成電路的可靠性，電流測試應運而生。電流測試技術包括穩態電流測試（ iddqtesting ） 、瞬態電流測試（ iddttesting ）兩種方法。
  8. Quiescent current test method has been widely applied in ic industries already and transient current testing is still at the stage of studying due to its harsh requirement for apparatus and other technical problems

    穩態電流測試目前已經實用化，而瞬態電流測試由於其對測試設備要求苛刻和其他一些技術問題仍處于研究階段。
  9. For the convenience of test, varied circuit chip defects caused by the production process are abstracted as all kinds of models. at present the commonly used fault models mainly consist of stuck - at fault, stuck - open fault, bridge fault, store fault, delay fault, etc. testing methods based on voltage testing mainly aim at stuck - at fault model and have also obtained satisfactory result in research for many years. bridge fault is tested easily by quiescent power supply current ( iddq ) testing method. in regard to stuck - open fault that is difficult to testd by quiescent power supply current ( iddq ) and voltage testing, it can is tested by the dynamic current ( iddt ) testing

    為了便於測試，我們將生產過程中集成電路出現的多種多樣的缺陷抽象為各種模型。目前常用的故障模型主要有:固定故障，開路故障，橋接故障，存儲故障，時滯故障等。電壓測試主要針對固定型故障模型，多年的研究也取得了令人滿意的結果; cmos電路中的橋接故障則宜用穩態電流測試方法（ iddq ）測試;對于電壓和穩態電流難以測試的開路故障，可以使用瞬態電流測試（ iddt ）的方法進行測試。
  10. But often what is not obvious when reading a manufacturer ' s data sheet is how the initial accuracy of the device is affected by other key device parameters such as line regulation, load regulation, initial voltage error, output voltage temperature coefficient ( tc ), output voltage noise, turn - on settling time, thermal hyste - resis, quiescent supply current, and long - term stability

    但，人們閱讀廠家的數據手冊時，因受諸如（電源電壓）線性調整率、負載調整率、初始電壓誤差、輸出電壓溫度系數tc 、熱遲滯（系數） 、靜態電流和長期穩定度等參數的影響而使初始精度往往不明顯。
  11. In the fifth chapter, a new fully differential operational amplifier with voltage and current - mode negative feedback has been proposed, which can stabilize its quiescent operation point, using the characteristic of mos transistors which operate in the triode region acting as active variable resistor, a fully differential fourth - order chebyshev low - pass filter with tunable frequency and bessel low - pass filter with accurate group delay based on r - mosfet - c and operational amplifier has been designed

    第五章：提出了一種新的既具有電壓共模負反饋又同時具有電流共模負反饋的全差分運算放大器電路，能較好地穩定電路的靜態工作點，並應用mos管工作在線性區可作有源可變電阻用的特性設計得到了截止頻率可連續調節的高性能r - mosfet - c 、運放結構切比雪夫（ chebyshev ）和精確群時延值貝塞爾（ bessel ）低通濾波器。
  12. In the early 1980 ’ s, quiescent power supply current ( iddq ) testing method was proposed in cmos testing. testing method based on current testing have very good compatibility with cmos circuits, it can detect some faults and physical defects those cannot be detected by testing methods based on voltage testing

    基於電流的iddq測試方法與cmos電路有很好的兼容性，它可檢測出電壓測試方法不能檢測的故障和物理缺陷，目前已成為一種廣為接受的重要的cmos數字集成電路的測試方法。
  13. The rt9016 performance is optimized for battery - powered systems to deliver ultra low noise and low quiescent current. a noise bypass pin is available for further reduction of output noise

    以最高速之160mhz工作頻率運作時，執行效能可達160mips的業界新標竿，為目前業界最高速的8051內核產品。
  14. Now, more and more electronic equipments are portable and multifunctional, which make the dc / dc converters must have special properties, such as high efficiency, low quiescent current, small board space, low weight and low cost

    小型化和多功能是便攜式電子產品的發展趨勢，因此要求dc / dc轉換器具有高效率、低靜態電流、小的板級面積、小體積和低成本等特性。
分享友人
分享到 Line

分享到臉書