reinforcement ratio 中文意思是什麼

reinforcement ratio 解釋
鋼筋比
  • reinforcement : n. 1. 增強，加固；補強物，強化物；補給品。2. 增援，支援；〈pl. 〉增援部隊，援軍；救援艦。
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. Thecalculating results show that the composite action between concrete floor and steel beamsgreatly influence the bending bearing capacity and initial rotational stiffness of joints, it shouldbe considered in practical engineer. reinforcement ratio of lengthways reinforcing bar andthe stiffener of web have great influencer on the behavior of connections, while the thicknessof end - plate and degree of shear connection have a litter influence on its behavior

    分析計算結果表明:樓板與鋼梁的組合作用對節點的抗彎承載力及初始轉動剛度的影響非常大，實際工程中節點設計應當考慮這種組合作用;樓板內縱向鋼筋配筋率與柱腹板加勁肋對節點性能影響顯著，而連接端板厚度及剪力連接程度的影響則不是太顯著。
  2. Critical fatigue reinforcement ratio of concrete beams reinforced by cold - rolled deformed steel bar

    冷軋帶肋鋼筋混凝土受彎構件的疲勞界限配筋率
  3. Based on analysis and comparison of existing test data applied to existing ultimate strength prediction models, interfacial stress at the end of plate is deduced. after formulas for calculating the effective moment of inertia for frp - strengthened beams being revised and adjustment coefficient related to nominal main steel reinforcement ratio and curtailment length ratio being put forward, strength prediction formulas of compound beams under plate end debonding failure are established. in analysis of strength of compound beams under intermediate crack induced interfacial debonding failure mode, several bond strengths and their relation are introduced

    對于板端剝離破壞，在總結現有承載力模型的基礎上，利用已有試驗數據對各承載力計算公式進行了分析比較，進一步採用分階段分析法，推導了板端界面應力的計算公式，在此基礎上，採用加固復合梁有效慣性矩的修正公式，建立了考慮名義配筋率和板端偏移比影響的板端剝離破壞梁承載力的計算公式；對于跨中受彎裂縫導致的粘結破壞，闡述了常見的幾種粘結強度之間的區別和聯系，並基於拉剪粘結強度，提出了跨中受彎裂縫導致粘結破壞的承載力計算公式，並利用現有試驗結果確定了模型中的一些參數；最後，利用試驗數據對本文建立的兩種粘結破壞承載力計算公式進行了檢驗，結果基本吻合。
  4. In this paper, five restrained beams with web and different longitudinal reinforcement were tested under static point loads, with the shear - span ratio being kept around 1. 5. on this basis, the overall process of cracking development under shear and the effect of longitudinal reinforcement ratio on it was investigated

    本文通過集中荷載作用下五根剪跨比為1 . 5 、不同縱筋率的有腹筋約束梁的試驗，深入研究了有腹筋約束梁的受剪破壞全過程及縱筋率對其的影響。
  5. The main achievements of this thesis are as follows : l. the effect of the frp reinforcement ratio on cracking moment is analyzed. the calculating method and corresponding calculating formulas of flexural cracking moment of frp reinforced concrete beam are put forward

    分析了纖維增強塑料筋配筋率對纖維增強塑料筋混凝土梁正截面開裂彎矩的影響，提出了纖維增強塑料筋混凝土梁正截面抗裂度的計算方法和相應的計算公式。
  6. Until now, the domestic and overseas scholar has studied the factors that have effect on performance of steel fiber reinforced concrete corbel such as shear span to depth, strength of concrete, reinforcement ratio ( including longitudinal reinforcement and stirrup ) and ratio of horizontal to vertical load. for calculating the cracking load, and ultimate load domestic and foreign scholar has brought forward a series of calculative formulas and methods have been put forward that based on statistical analysis, flexural model and truss model

    到目前為止，國內外學者已研究了剪跨比、混凝土強度、配筋率（包括縱向鋼筋和箍筋） 、水平荷載與垂直荷載之比等因素對鋼筋鋼纖維混凝土牛腿受力性能的影響，對牛腿的抗裂計算和承載力的計算，國內外學者曾提出了基於數理統計分析、彎壓模型和桁架模型等的一系列計算方法和計算公式。
  7. In static test, t - shaped and l - shaped specimens were respectively divided into four groups according to concrete strength grades, sectional height to thickness ratio, reinforcement ratio and ratio of axial compressive force to axial compressive ultimate capacity of section. how these factors affect the load - carrying and deformation of short - leg shear wall is known by analysis the result

    在擬靜力試驗中對t形和l形短肢剪力墻分別進行了四組試驗，通過對試驗結果的分析，揭示了混凝土等級、截面配筋率、軸壓比和墻肢截面高厚比等因素對短肢剪力墻承載力和變形的影響。
  8. Abstract : based on the systematic analysis of the shear behavior for r. c. beams, the tests of 11 simple supported beams under the top concentrated loads and the uniform loads are supplemented. the prime variable is shear span ratio, span depth ratio, horizontal web reinforcement ratio and vertical web reinforcement ratio. according to the test results, the working behavior, the prime shear failure modes, the effect of concrete and web reinforcement ( horizontal web reinforcement and vertical web reinforcement ) and other aspects of r. c. beams are analysed. the uniform calculation method for shear capacity of deep beams, short beams and shallow beams for practical is presented

    文摘:在對國內外鋼筋混凝土梁的受剪性能進行較系統分析的基礎上，補充了11根鋼筋混凝土簡支短梁在頂部集中荷載和均布荷載作用下的試驗，試驗梁的主要變化參數為剪跨比、跨高比、水平腹筋率和垂直腹筋率.根據試驗結果，對試驗梁的工作性能、主要的剪切破壞形態、混凝土項的抗剪作用、抗剪腹筋（包括水平腹筋、垂直腹筋）的作用等進行了較為深入的分析，提出了可適用鋼筋混凝土深梁、短梁和淺梁相互協調的受剪承載力的統一計算方法
  9. The major factor considered in experiment are followed : the influence of width of wall, the influence of different reinforcement ratio of wall, the influence of axis compress ratio, the influence of mortar layer

    試驗中考慮的主要因素有：墻體厚度對于抗震的影響、墻體不同配筋的影響、軸壓比的影響、砂漿層的影響等。
  10. The major factors of the experiment are listed as following : the influence of different reinforcement ratio of the walls, the influence axial compression ratio, the influence of vertical reinforcing bars at the boundary, the influence of mortar layers etc. furthermore, the load carrying capacity and the elastic stiffness are calculated and experimental results have proved that they are good

    試驗中考慮的主要因素有：墻體不同配筋的影響、軸壓比的影響、兩端豎向加強鋼筋的影響、砂漿層的影響等。並對試件的承載力及彈性剛度進行了實測結果與計算的比較，符合較好。
  11. 3 ) a study is carried out to understand the changing rule of ultimate load and stiffness with the different reinforcement ratio of anti - punching shear bar. the increasing speed of the ultimate load is slower than that of the reinforcement ratio is indicated

    3 .對不同抗拔鋼筋配筋率的鋼筋混凝土承臺-鋼柱腳抗拔極限承載力和剛度變化規律進行了計算分析，發現了隨著承臺中抗拔鋼筋配筋率的提高，其承載力提高的比例逐步減小的規律。
  12. Problems are often occurred : cross - section of frame columns depends upon the limit of axial compressive ratio, the constructional reinforcement ratio becomes the ratio of longitudinal reinforcing steel bar of frame columns, such problems are not reasonable

    經常出現的情況是：框架柱的斷面由軸壓比限值確定，而框架柱的配筋由構造配筋率決定，這其中存在著不合理的地方。
  13. Based on the test of 3 concrete beams reinforced with surface adhering sand carbon fiber bar and 2 concrete beams reinforced with surface adhering sand glass fiber bar, the deflection, balanced reinforcement ratio, failure mode, and ultimate capacity were analyzed and corresponding formulas are recommended

    摘要以3根粘砂碳纖維聚合物筋混凝土梁和2根粘砂玻璃纖維聚合物筋的試驗為依據，分析了纖維聚合物筋混凝土梁的撓度變形和破壞形式，以及界限配筋率和正截面承載力；並結合我國混凝土結構設計規范對梁的正截面承載力計算公式進行了推導。
  14. A simplified formula for the shear capacity of rc simply supported beam which strengthened with the cmmr is proposed in this paper. 3 、 the shear capacity of rc beam strengthened with cmmr is studied. though the test of fourteen simply supported reinforced concrete beams and five overhanging reinforced concrete beams with cmmr, it analyses the effects of shear - span ratio, web reinforcement ratio of cmmr, style of loading, preloading on strengthening, and compares them with rc beams using ordinary stirrup

    3 、根據本文進行了的14根混凝土簡支梁和5根混凝土伸臂梁的水泥復合砂漿鋼筋網抗剪加固試驗，分析了剪跨比、鋼筋網配筋率、加固形式以及持荷狀態等因數對整個構件極限抗剪承載力的影響，並與混凝土梁進行了比較。
  15. The codified design equations based on such testing data may be unconservative. systematic investigation for effect of longitudinal reinforcement ratio on shear behavior of rc beams is particularly rare

    因而，建立在這種縱筋率較高的梁的受剪性能試驗數據基礎上的規范抗剪設計方法可能是偏不安全的。
  16. Reinforcement ratio per unit volume

    體積配筋率35
  17. A program with c + + language was designed to calculate ultimate load of the reinforced concrete masonry shear wall structure. the reliability of the program was proved by comparing the program results with experimental results. ( 2 ) using the program, impact to the shear resistant of the ratio of grout for concrete and the ratio of height to section thickness and the horizontal reinforcement ratio was discussed

    （ 2 ）利用本文編制的程序，討論不同的高寬比、灌芯率和水平配筋率對配筋砌塊砌體剪力墻抗剪承載力的影響，並驗證了《砌體規范》 （ gb50003 - 2001 ）規定允許高寬比和允許配筋率范圍。
  18. During the swelling capacity test of the reinforced soils under load, three different reinforcement ratio samples are tested in order to reduce their expansion of the soils

    在加筋土有荷載膨脹量試驗中，取三種不同加筋率的試樣進行試驗求其膨脹率。
  19. 2. the effect of frp reinforcement ratio on the ultimate moment of frp reinforced concrete beam is studied, the conclusion is that the ultimate moment increases with the increase of the reinforcement ratio for frp reinforced concrete beam in a certain range of reinforcement ratio

    結果表明，對纖維增強塑料筋混凝土梁，在配筋率的一定范圍內，配筋率越大，受壓區面積越大，極限抗彎承載力越高。
  20. In terms of strength and ductility, the concept of specified yield point is put forward. based on the principle that under the same condition ( that is, the size of cross section, material strength and reinforcement ratio are identical ), the resultant ultimate moment must be identical, the compression failure of frp reinforced concrete beam is equal to the tension failure for the viewpoint of design and calculation

    從強度與延性兩方面的綜合考慮，提出了纖維增強塑料筋名義屈服點的概念，對發生受壓破壞的纖維增強塑料筋混凝土梁，按照同樣條件下（截面尺寸、材料強度、截面配筋率等均相同）截面承載力相等的原則等效轉化為受拉破壞進行設計與計算，以此確定纖維增強塑料筋的強度折減系數_ f 。
分享友人
分享到 Line

分享到臉書