residual deflection 中文意思是什麼
-
Along with the progress of drilling technology, many new types of bha such as steering motor assembly, dropping assembly with eccentric bend sub, dropping assembly with flexible connection are developed based on common building, dropping and holding assemblies. for using these bha, a new mathematical model is put forward for 3d static analysis of these types of bha under small deflection. and its weighted residual solution is given. the mathematical model includes ( 1 ) differential equations ; ( 2 ) boundary conditions at drill bit, stabilizer, bend angle, diameter change, tangential point and borehole wall ; ( 3 ) lateral forces and deflection angles of bit. the software based upon this method runs well
為了更好地應用各種新鉆具，建立了適用於對普通下部鉆具、導向鉆具、帶偏心彎接頭和柔性接頭的下部鉆具進行三維小撓度靜力學分析的數學模型，包括（ 1 ）微分方程； （ 2 ）鉆頭、穩定器、彎角、變截面、切點和井壁的邊界條件； （ 3 ）鉆頭的側向力和鉆頭轉角.給出了該模型的加權余量解.用該方法編寫的軟體應用效果良好 -
The reduction factors derived from curve fitting based on calculation results by the finite element program ( ansys ) considering all kinds of damages such as cutouts, corrosion, cracks, denting, initial deflection and residual stress are introduced to modify the effective width of perfect panel in the present paper
本文考慮板中可能存在孔洞、腐蝕、裂縫、局部撞損和初始焊接變形或殘余應力等損傷和初始缺陷，對不同的損傷形式用有限元程序（ ansys ）進行大量的計算，通過曲線擬合的方法引入折減系數對完好板格的有效寬度進行修正。 -
In the analysis of the elastic local buckling strength of the plates in stiffened plates, an analytical expression is derived for calculating the local strength of a stiffened plate subjected to biaxial thrust considering plate / stiffener interaction and welding residual stresses and initial deflection
由於船體中的加筋板結構的受力情況是十分復雜的，除了主要受到由於總縱彎曲而產生的縱向壓力以外，還會受到橫向的壓力以及垂向壓力。 -
In the other method, young ' s modulus, residual stress, and bending strength are characterized under a wedge tip by means of micro bridge deflection tests
利用楔形壓頭和薄膜微橋撓曲法，得到了標準氮化硅、低應力氮化硅和氮化鋁薄膜的楊氏模量、殘余應力和彎曲強度。 -
The inelastic finite element solution considering both large - deflection and plastic extension is used to analyze eccentric - loading columns in this paper. the stability capacity of different slendemess ration and eccentricity are calculated, the residual stresses and their influence upon the steel eccentric - loading columns are emphasizedly discussed, at the same time ten steel columns were achieved
本文採用大變形和塑性擴展的兩重非線性有限元方法進行偏心受壓柱子的全過程模擬，分析不同的長細比、不同的偏心率情況下柱子的穩定性能，並著重討論殘余應力對柱子承載能力的影響，完成了10根試件的試驗。 -
The article has applied the weighted residual method and laplace changing to analyze the plastic dynamic response of a simple circular plate, the influence of elastic foundation on it and drives its residual deflection and the terminal time
摘要應用加權殘值法和拉普拉斯變換，分析彈性基礎上簡支圓板的塑性動力響應問題，彈性基礎對薄板塑性動力響應的影響，並且給出板的殘余撓度和終止運動時間。 -
In this paper, firstly according to fourier heat conduct ~ quation, the analysical solutions of the temperature field of sfrc pavement structure were obtained and the finite element solutions were soluted by means of galerkin weighed residual methoded. secondly, based on the temperature field, the analysical solutions of the temperature stress of sfrc pavement structure were dissolved with westerguard - bradbury method, and then the finite element solutions were obtained by means of the finite element method. at last, the dynamic response of sfrc pavement plant structure affected by shock load with the finite element method was studied, and the deflection and stress response under shock load was calculated
其次，根據已求得的溫度場，利用威斯特卡德-布拉德伯利法求解鋼纖維混凝土路面板結構的溫度應力的解析解，然後又利用有限單元法對由溫度變化產生的溫度應力進行求解。最後，作者利用有限單元法分析了鋼纖維混凝土路面板結構在沖擊載荷作用下的動力響應，計算了由沖擊載荷引起的撓度響應及應力響應。
分享友人