rotor coil 中文意思是什麼

rotor coil 解釋
轉子線圈
  • rotor : n 1 【電機】轉子 〈cf stator〉; 動片，轉片。2 【航空】水平旋翼。3 【物理學】旋度。4 （風筒船的）...
  • coil : vt vi 卷，盤繞，（把…）盤[卷]成一圈 （up）。n 1 （一）卷，（一）盤，（一）圈。2 螺旋管，蛇管。3 ...
  1. As a result, the electromagnetic field intensity is changed accordingly and fluctuating current in the damper coil is created. damping force is mostly produced because of the phase difference between fluctuating current and displacement of rotor. the formulas of fluctuating current and damping coefficient are deduced theoretically, and the calculated results are consistent with the experimental results

    通過分析發現電磁阻尼器線圈內由於轉子渦動時變化的磁場而產生的波動電流與轉子位移間的相位差是產生阻尼的主要原因，推導了波動電流、阻尼系數的計算公式，並通過實驗展示了被動式電磁阻尼器的阻尼效應。
  2. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  3. Permanent magnetism of the rotor synchronous electrical cigang permanent magnetism is multipolar, stator are two pairs of feet are still 90 degrees electricity perspective, a very similar jacket one coil

    永磁同步電機的轉子是多極的永磁磁鋼，定子是兩對爪極偏90度電角度，爪極外套一線圈。
  4. Firstly, the experimental phase current and input power data obtained from load test are employed to estimate the parameters in ii rated condition. then, the phase current and input power data in locked rotor condition are used to track the variation of the parameters of the secondary coil with slip frequency. the classical method and the direct modification method are also used to estimate the parameters of the induction machine in comparison with this technique

    首先利用了負載試驗的定子電流和輸入功率數據來識別額定工況下的電機參數，然後又使用了堵轉時的定子電流、輸入功率數據來識別電機二次繞組參數隨轉差頻率的變化，並與傳統參數測試方法和直接修正參數法進行了比較。
  5. Cause and treatment for cracked terminal lead of generator rotor coil

    發電機轉子線圈引出線崩毀原因及處理
  6. Detect problems caused by faulty wires, plugs, cap, rotor, coil, etc. works on distributor and dis systems

    用途:判斷有分電線的點火系統，每缸的工作高壓電kv情況。
  7. Coil wound rotor

    線繞轉子
分享友人
分享到 Line

分享到臉書