secondary exit 中文意思是什麼
secondary exit
解釋
后備太平門-
When primary electrons hit the surface of the chunnel, secondary electrons are generated, which make the electron distribution at the exit hole of the chunnel more uniform
當初始電子碰撞絕緣壁時，會產生二次電子，而二次電子能改善電子在通道出口處的電子能量分佈的均勻性。 -
Effects of different fuel - air ratios and different geometric parameters of dual - stage swirler ( such as inner diameters of the primary swirl and secondary swirl passages, outer diameters of the secondary swirl passages, vane angle of the primary and secondary swirler, the distance of the flare exit from throat etc ) on combustion performances are studied experimentally. the experimental results show that radial profiles of the outlet gas temperature 、 combustion efficiency 、 emissions of co2 、 co and nox and lean blowout are affected with different degrees by the different geometric parameters of dual - stage swirler and the arrangement of primary holes
在不同油氣比下，不同的雙級旋流器幾何參數（例如:一級與二級旋流器出口內徑d 、葉片安裝角、二級旋流器出口外徑d 、二級旋流器的喉道到出口截面的距離l和喉道前後的圓弧半徑r以及主燃孔孔布局等）對單頭部環形燃燒室的出口溫度分佈、燃燒效率、貧油熄火油氣比以及污染物（ co _ 2 、 co和nox ）排放等燃燒性能的影響規律進行了研究。 -
The conclusion that the optimal secondary nozzle exit area generating the maximum thrust agrees well with the numerical simulation, indicating that the exit area of secondary nozzle should be optimized according to structure and flow parameters during design
表明在引射火箭設計時，應結合引射火箭的結構和流動參數對二次噴管出口面積進行優化設計，以達到最佳推力性能。 -
The results indicate that with decrease of exit area of secondary nozzle, the bypass ratio is decreasing, and the static pressure in integrated ejector combustor is increasing, and mixing condition becomes better. there exists an optimal exit area of secondary nozzle to get maximum thrust of rocket ejector
結果表明：引射能力隨著二次噴管出口面積的減小而減小；整體式引射燃燒室壓強隨著二次噴管出口面積的減小而上升，混合隨之更為充分；存在一個最優的二次噴管出口面積，使發動機推力最大。 -
It is shown that when the exit area of secondary nozzle and the fuel / oxidizer ratio is fixed, the increase of mass flow rate of secondary flow lead to the decrease of velocity of mixed flow, and increase of total mass flow rate. the synthetical result of these two phenomenon cause the increase of thrust of rocket ejector, but the increasing magnitude is relatively small, indicating that these is no necessary to claim large bypass ratio in rocket ejector design. in the comparison between two configurations, the typical one has better performance, indicating the importance of pressure ratio
結果表明：在固定二次噴管出口面積和氧燃比的條件下，二次流（引射空氣流）流量的增加引起混合氣體出口速度的下降和總流量的增加，二者綜合作用使發動機推力增加，但增幅不大，表明在設計發動機結構和工作參數時，不必過分追求大的引射系數；兩種結構的性能對比分析表明了增壓比對引射火箭性能的提高具有重要意義；對引射火箭的熱力循環分析同樣表明，增壓比對于提高發動機性能非常關鍵。
分享友人