sensor element 中文意思是什麼

sensor element 解釋
讀出元件, 傳感元件
  • sensor : n. 1. ＝sensory （名詞）. 2. 【自動化】感受器；傳感器；靈敏元件，控制儀板上顯示溫度、輻射量等變動的裝置。
  • element : n 1 要素；成分；（構成）部分；分子。2 【化學】元素；【數學】元，素；【機械工程】單元；單體；【無...
  1. The bimetal element is the simplest and most often encountered sensor.

    雙金屬元件是一種最簡單和最常見的傳感器。
  2. Cg - 1 magnets sensors also known as pm proximity switch sensor in the elevator shafts for flat layer control. because of its speed is faster, high reliability and energy - saving advantages, it can be widely used in various movements to control spacing and other equipment for automatic control system for sensing element role

    Cg - 1型永磁感應器cg - 1型永磁感應器亦稱永磁接近開關在電梯中作井道傳感元件使用，即電梯平層控
  3. The water heater shall have a self - diagnostic control that monitors and indicates power on, no power or control failure, start - up failure, high - limit operation, sensor failure, defective upper element, or defective lower element

    這種熱水器應該配置自診斷控制裝置，能夠監控和顯示通電、停電、控制裝置故障、啟動故障、高溫運行、感應器故障、上部加熱元件或下部加熱元件故障等狀態。
  4. Based on an amplified spontaneous emission ( ase ) source, a ring - cavity fiber laser, in which sensor element acted as the reflector of the cavity, was achieved with high - signal noise ratio ( snr ) and high - power. it was demonstrated that the output power was maximum, when output coupler ratio of the coupler was seventy percent

    實驗證實耦合器的輸出耦合比選為某一個最佳值70 ，當980nm泵光工作電流為50ma時，其輸出功率達3 . 5mw ，且輸出激光波長與作為反射鏡的光纖光柵中心波長相同。
  5. Using a chain element with integrated thin - film sensor, the tensile force is measured on straight sections and in diversions over the entire conveying section of a bottle cleaning plant

    採用集成薄膜傳感器的鏈式元件，可以測量清瓶車間的直線設備部分和整個傳輸部分的轉向裝置。
  6. The experimental results showed that the substrate of pyroelectric sensor could significantly affect the detectivity. the porous silicon dioxide and pet plastic film substrate could effectively decrease the thermal conduction and the thermal fluctuation noise of the pyroelectric element, increase the voltage responsivity and the detectivity obviously

    結果表明，多孔氧化硅和pet塑料可有效降低熱釋電元件的對外熱傳導，明顯提高傳感器的電壓響應率和降低熱釋電元件的熱噪聲。
  7. Based on local coupling mode theory of graded index optic fiber wave guide, the variation regularity of coupling output light has been deduced when sound wave acts on single mode optic fiber coupler. and a new idea has been proposed that a novel sensor can be applied on detection of acoustic / vibration. the sensing element of sensor is the melting area of single mode coupler in which the feasibility of the new - type optic fiber sensor has been proved in experiment

    本文從緩變光纖波導的局部耦合模理論出發，推導出了單模光纖耦合器耦合分光在聲波作用下的變化規律，提出了以單模光纖耦合器的熔融區為傳感元件的傳感器在聲振動信號檢測中應用的新思想，並實驗論證了這種新型光纖傳感器應用於實際的可行性。
  8. Sensor with externalconvection sensitive element

    外對流敏感元件傳感器
  9. Sensor with intrnalconvection sensitive element

    內對流敏感元件傳感器
  10. Sensor with bare wire sensitive element

    裸絲敏感元件傳感器
  11. In a general way, the sensitive performance of gas sensor is closely relative to the working temperature. it is very easy for mems to integrate the gas sensitive element, the heater and temperature sensor together

    氣體傳感器的敏感性能一般與工作溫度密切相關， mems技術很容易將氣敏元件和加熱元件、溫度探測元件製作在一起，保證了氣體傳感器的優良性能。
  12. Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application

    熱、壓環境下壓阻變換壓力傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型，模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究表明，硼硅堆導致產生一定的非線性，但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器輸出的滯后和漂移誤差.然而，在相對穩定的環境下，軟黏合劑對傳感器的影響可以忽略.此外，詳細的設計和過程信息有助於提高模型的適用性
  13. The main working procedure of the fiber - optic sensor is : the sensing element detects the acceleration signal, this signal modulates the phase of the wave, and the phase change is corresponding to the acceleration signal

    該光纖加速度計的工作過程為:敏感元件感受外界的加速度信號，並把它轉化成馬赫-增德爾干涉儀測量臂的拉伸或壓縮，從而引起測量臂中的光波相位變化，相位變化量即代表被測加速度值。
  14. Optical gains as large as one million are used to achieve the high sensitivities required in current electro - optical sensors. these large optical gains make the detector the most susceptible sensor element to laser damage. people concerns that the influence to the quality of ccd camera image under laser irradiation, the laser - induced threshold of ccd detector and the evaluation of laser - induced effects

    光電探測器具有極強的目標探測能力，而激光具有極高的亮度；因而各類光電裝備的光電探測器成為國外發達國家正在大力發展激光武器系統的首要攻擊目標，激光對探測器的干擾與損傷程度如何、受干擾后能否繼續正常工作、何時達到損傷閾值以及如何對干擾效果做出客觀評價是人們非常關心的問題。
  15. For such calibrations it is necessary that the sensor element be mounted and sealed in a glass sheath so that the distance from the tip of the element to the bottom of the head of the thermometer is at least 450 mm, and the diameter of the glass sheath should not be greater than 8 mm

    進行上述校正時，感溫元件必須裝于及密封於一玻璃套內，而該感溫元件的尖端與溫度計把手部份的底部最少距離450毫米，該玻璃套的直徑不得超過8毫米。
  16. First, the finite element dynamic models of the cantilever intact and damaged laminated composite cylindrical shells are established. the piezoelectric smart materials bonded on the laminated composite shell are used as both actuator and sensor

    首先，建立表面粘貼有壓電片材料的懸臂完好復合材料層合殼體及損傷復合材料層合殼體的有限元動力學模型，並求出其動力響應。
  17. In order to decrease the cost, simplify the structure of the pmsm servo system and at the same has no effect on the system performance, this paper uses hall element as the position sensor, which has very low solution but very low cost, and in order to realize sinusoidal current drive of pmsm, this paper presents a new rotor position estimator based on flux estimation

    為了降低成本，簡化系統，本文採用低解析度的霍爾元件作為pmsm伺服系統的位置傳感器，採用基於磁鏈觀測法的低解析度位置傳感器控制技術，來估計電機轉子的實時位置和轉速，實現電流的正弦換向，減小轉矩脈動。
  18. A transducer is the mechanism, or element, of the sensor that transforms the energy associated with what is being measured into another form of energy

    交換器是傳感器的機制或元素，它將測量到的能源轉換成另一種形式的能源。
  19. Then, a micro - machined array of optical pressure sensor has been discussed ; each sensor element in the array consists of a fabry - perot etalon fabricated from single - crystal silicon ; sensor ' s performance has been increased through improved the structure, and can makeup the arrays which be suitable for the smart - skin

    其次，本文對一種傳統的法布里一帕羅標準具型光纖壓力傳感器（該傳感器陣列的每一單元均由單晶硅製造而成的法布里一怕羅標準具組成）進行了結構設計和性能分析。
  20. The optimum is obtained after computing and the optimization result indicates that the method is efficient to optimize the elastic element structure. so it could be applied extensively in the engineering of the sensor element optimization design

    優化結果表明該方法對傳感器的彈性元件結構起到很好的優化效果，該方法可廣泛應用於傳感器彈性元件的優化設計工程。
分享友人
分享到 Line

分享到臉書