separate solution method 中文意思是什麼

separate solution method 解釋
分別溶液法
  • separate : vt 1 分；分開；分離；隔開；隔離；切斷；割斷。2 區別；分別；識別。3 使脫離關系；使分居。4 開革；開...
  • solution : n. 1. 溶解；溶液，溶體，溶劑。2. （補輪胎用的）橡膠水；〈美國〉藥水。3. 解決，解答 （of; for; to）; 解釋；（數學等的）解法，解式。4. 免除，解除。5. 【醫學】消散，消退。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. The urea - formaldehyde ( uf ) polymer / sio2 composite microspheres were prepared by polymerization - induced colloid aggregation ( pica ) method. the formation mechanism of composite microspheres is attributed to the fact that that urea and formaldehyde firstly undergo acid - catalyzed polymerization to form oligomers, and then the sol particles are adsorbed on the chain of oligomers by wan der walls force and hydrogen bonding. when the oligomers reach the critical chain length, they separate from solution due to phase separation

    對復合微球形成機理的研究表明，尿素和甲醛在酸性條件下自身聚合可以形成高分子微球，在sio _ 2酸性溶膠中發生聚和反應時，隨著反應的進行，齊聚物不斷生成， sio _ 2膠體顆粒逐漸吸附在齊聚物分子鏈上，當聚合物鏈達到沉澱臨界鏈長時，由於相分離作用，從前驅物溶液中析出，同時sio _ 2膠體顆粒均勻的分佈在脲醛聚合物網路中，隨之沉澱出來，形成脲醛sio _ 2復合微球。
  2. In this paper, dynamic stability of parametrically excited flexible cam - follower system on the weakly nonlinear condition is investigated by using the combination of both the method of multiple scales and the technique of fourier series expansion. the equations of approximate transition curves in the plane of the dimensionless frequency and excitation ( amplitude ) parameter that separate stable from unstable solution are derived

    隨后，本文採用多尺度法並結合fourier級數展開，分析了不同的凸輪從動件運動規律和不同的凸輪的升程、停程以及回程的時間分配規律下，無間隙的周期時變凸輪系統模型的穩定性，獲得了各種規律下的凸輪系統的穩定區間圖。
  3. But the influence trend of the maximum rolling angle and the rolling period was not so simple, it was because the influence of which embodied in the phase relationship of mass flow and the pressure drop across the tube. the d - partition method was developed to separate the test tube into four regions and the drift flow model was imported into the two phase region, based on which the solution of the response of the pressure drop of tested tube to the inlet mass flow perturbation can be obtained

    在不搖擺和搖擺工況下，採用d分區法對實驗段進行分區，在兩相區採用漂移流模型對實驗段的壓降對入口流速擾動的響應進行了求解，給出了各區壓降響應的表達式，進而得到了在不搖擺和搖擺工況下，壓降與入口流速擾動之間的傳遞函數。
分享友人
分享到 Line

分享到臉書