separation loss 中文意思是什麼

separation loss 解釋
分離損失
  • separation : n 1 分離；分類；分開。2 隔開；間隔；脫離。3 （夫婦的）分居。4 分隔物。5 【化學】離析；析出；釋出...
  • loss : n. 1. 喪失；丟失，遺失。2. 減損，損失，虧損（額）；損耗；減少，下降。3. 失敗；輸掉。4. 錯過；浪費。5. 損毀；【軍事】傷亡；〈pl. 〉 傷亡及被俘人數。
  1. According to the company, the concerned pacemakers may fail due to separation of interconnect wires and may cause loss of rate response, premature battery depletion, intermittent or total loss of signals

    根據該公司的資料，有關的心臟起搏器可能會因連線的分離而失效，因而引致失去心律調整功能、電池過早耗完、間歇或完全失去訊號。
  2. As the chilly wind of late fall in chicago blew yellow leaves from the trees, chris experienced the pain of physical separation because he felt the loss of your love for him that had been manifesting through me

    猶如芝加哥暮秋的冷風吹落樹上的黃葉，克萊斯意識到您透過我傳達給他的愛即將離他遠去，小小的心靈因此感受到離別之苦。
  3. Measurement of cavity loss and quasi - fermi - level separation for fabry - p 233 ; rot semiconductor lasers

    腔半導體激光器的腔內損耗和準費米能級差的測量
  4. Since the controller concerned did not positively apply vertical separation between the two aircraft or take prompt recovery action when they came close to each other, a loss of standard separation occurred

    由於控制員未有為兩架航機提供適當的高度間隔，或在兩機接近時立即採取糾正行動，因而導致這次標準距離出現偏差事件。
  5. A mathematical model of flows in the substrate was established using the equivalent continuum approach, and multi - dimensional numerical simulation of the steady flows in the catalytic converters was performed. simulation results show that the separation and vortex, which cause the pressure loss and the velocity non - uniformity at the front of the first substrate, are generated near the wall of the conical pipe. in addition, the larger the inlet cones angle the more the pressure loss and maldistribution in converters, however, when the angle enlarges enough the pressure loss would be decrease

    結果顯示氣流在擴張圓錐管壁附近出現分離產生較強的擾動，造成局部流動損失和載體前氣流速度沿徑向分佈不均勻；入口擴張管結構對催化器的流動特性有很大影響，但並非擴張角越大，催化器流速武漢理工大學碩士學位論文分佈的不均勻性和壓力損失也增大，而是存在著一個最佳角度，但當擴張角增大到一定程度以後，擴張角對流速分佈和壓力損失的影響變小。
  6. By choosing reasonable suction location and combination, the large scale profile separation can be well controlled, but the effect on decreasing the secondary flow loss is limited

    計算結果表明，通過選用合理的抽吸位置及抽吸方式的組合，附面層抽吸能較好地控制葉柵內的大尺度的葉片表面分離流動，但對二次流損失的改善效果並不明顯。
  7. The separation of ownership and control in modern enterprise and the asymmetry of information between professional enterpriser and owner are the condition to produce this problem. the establishment of incentive and disciplinary mechanism to professional enterpriser can assure that modern enterprise has the high efficiency produced by the functional division of labor among enterprisers, besides, it is the necessary requirement to avoid loss that is caused because of the disagreement of target gains between enterpriser and owner. for these reasons, whether the incentive and disciplinary mechanism to enterpriser is good or bad, is one of important indictors to evaluate economic system

    現代企業所有權和控制權的分離，職業企業家和所有者之間信息不對稱，是產生企業家的激勵約束問題的條件，建立職業企業家的激勵約束機制，是在保證現代企業組織享有企業家職能分工產生的高效率的同時，避免職業企業家和企業所有者的目標利益不一致從而造成損失的必然要求，從這個意義上說，企業的激勵約束機制優劣，是比較、評價經濟體制的重要指標之一。
  8. Results from this investigation show that the loss generation within the coolant holes is substantial and that ejection into regions of low static pressure increases the loss per unit coolant mass flow. the results also reveal strong interactions between endwall coolant ejection and secondary flow in the blade passage. the secondary flow has a strong influence on coolant trajectories and coolant ejection delays the three - dimensional separation of the inlet boundary layer on the endwall, chang the secondary flow and reduces its associated losses

    本文的研究成果顯示，冷卻孔內產生的損失是主要的，並且低靜壓區域的冷空氣噴射會增加單位冷空氣質量流的消耗；噴射的冷空氣與葉柵端壁流場之間有強烈的相互作用；二次流對冷卻空氣的流動軌跡有較強的影響；冷空氣噴射能延緩端壁入口邊界層的三維分離、改變二次流從而減少其相關損耗。
分享友人
分享到 Line

分享到臉書