separation velocity 中文意思是什麼

separation velocity 解釋
分離速度
  • separation : n 1 分離；分類；分開。2 隔開；間隔；脫離。3 （夫婦的）分居。4 分隔物。5 【化學】離析；析出；釋出...
  • velocity : n. 1. 迅速；快速。2. 速度，速率。3. 周轉率。
  1. It is showed that numerical calculation could give the same position of separation line with the cold gas simulation. however, numerical simulation result is of a little deferent from cold gas simulation in some details, such as recirculation velocity and turbulent intensity. the main problem of numerical simulation is that the turbulent model is not perfect, and the computational grid is not precise enough

    利用實驗結果對數值模擬的準確性作了檢驗和評價，結果表明數值模擬能給出與實驗結果一致的分離線位置，但在某些流動細節上還有差別，如迴流速度大小和湍流度等，數值模擬中存在的主要問題是湍流模型不夠完善和網格生成不夠精細。
  2. With the tracing particles, the sinking velocity of middle and higher density particles that pass through the lower density coal particles in jig bed for different jigging air circle were measured. the results showed that the air cycle with a long inlet period can promote the separation of middle and higher density particles and lower density coal particles

    運用彩色人工顆粒，對不同跳汰周期下中、高密度顆粒在低密度煤炭床層中的沉降速度進行了示蹤研究，確認長進氣期周期有利於中、高密度顆粒與低密度煤炭顆粒的分離。
  3. The experiment shows that by changing the velocity coefficient, the separation of boundary layer on pump vane can be controlled, and the performance of pump is improved and its hydraulic efficiency

    實驗證明通過改變葉片型線參數方程中的速度系數的取值，可以控制邊界層的分離，進而改善泵的性能，提高其水力效率。
  4. This article confirmed the grafting efficiency of starch grafted to acrylic acid and the structure of starch and its grafted matter through the separation, purification and analysis tests to the grafted copolymer and the grafted forked - chain matter produced from the process of this reaction ; and deduced the formula of the velocity of such reaction mentioned above with a calculated result of the apparent activation energy in this reaction by the curve showing the relationship among the consistency of starch, monomer and initiator and the velocity of the grafting copolymerization

    摘要對澱粉接枝丙烯酸所得接枝共聚物及接枝側鏈物進行分離提純和分析測試，確定了其接枝效率並表徵了澱粉及其接枝物的形態結構；通過分別測定接枝共聚反應速率與澱粉、單體、引發劑濃度的關系曲線，確定了該接枝共聚反應的速率關系式；推算出了反應的表觀活化能。
  5. By increasing the length of laval nozzle, an approach was presented to obtain higher particle velocity necessary for gas - solid separation in dusty gas of high temperature and high pressure

    提出了用增加縮放噴管長度的方法，使含塵高溫高壓氣體中的灰塵顆粒獲得實現氣固兩相分離所必需的更高動量的途逕。
  6. A mathematical model of flows in the substrate was established using the equivalent continuum approach, and multi - dimensional numerical simulation of the steady flows in the catalytic converters was performed. simulation results show that the separation and vortex, which cause the pressure loss and the velocity non - uniformity at the front of the first substrate, are generated near the wall of the conical pipe. in addition, the larger the inlet cones angle the more the pressure loss and maldistribution in converters, however, when the angle enlarges enough the pressure loss would be decrease

    結果顯示氣流在擴張圓錐管壁附近出現分離產生較強的擾動，造成局部流動損失和載體前氣流速度沿徑向分佈不均勻；入口擴張管結構對催化器的流動特性有很大影響，但並非擴張角越大，催化器流速武漢理工大學碩士學位論文分佈的不均勻性和壓力損失也增大，而是存在著一個最佳角度，但當擴張角增大到一定程度以後，擴張角對流速分佈和壓力損失的影響變小。
  7. 3. the characteristics of boundary layer ' s transition, shape and separation are researched. the details as follows : ( l ) airfoil surface is turbulent boundary layer flows ; ( 2 ) velocity figure changed unsteady near the point of boundary layer separation due to randomicity of turbulent flow ; ( 3 ) the airfoil have better state of boundary layer separation and poor stall characteristics because of the upper surface of airfoil is flat

    給出了該翼型的附面層特性：翼型表面基本為湍流附面層；在靠近附面層分離位置處，速度型形狀、特別是靠近翼型表面的底部速度型形狀變化不定，是湍流流動的隨機性所致；該翼型具有較好的附面層分離形態，但在失速迎角附近，附面層分離形態變化劇烈、失速特性差，是翼型上翼面形狀較為平坦所致。
分享友人
分享到 Line

分享到臉書