serial capacitor 中文意思是什麼
serial capacitor
解釋
串聯電容器-
The characteristics : the unit is composed of high voltage parallel capacitor, serial reactor, switch ( disconnector, grounding switch, breaker etc. ), lightning arrestor, fuse, discharging coil, current transformer, insulator, busbar and steel bracket, includes two kinds of structure : frame type and cabinet type
產品特點：裝置由高壓並聯電容器、串聯電抗器、開關（隔離開關、接地開關、斷路器等） 、避雷器、熔斷器、放電線圈、電流互感器、絕緣子、母排和鋼架組成，裝置有框架和櫃式兩種結構。 -
Firstly, the whole scheme of the transducer is designed, the transducer includes capacitance / voltage converting, ripple - control capacitor switching, magnify - multiple switching, a / d converting, singlechip, photoelectric isolation and rs - 485 serial communication, etc. the measurement of microcapacitor is the key technology of transducer
首先對變送器部分進行了整體的方案設計，變送器由電容/電壓轉換、紋波控制電容切換、放大倍數切換、 a / d轉換、單片機、光電隔離和rs485串口通訊等幾部分組成。 -
At installation site. 3. the capacitance tolerance in each serial group and segment shold no more than 0. 5 %. the ratio between maximum value and minimum value of capacitance which is measured at any two termin - als of capacitor unit in three phases should no more than 1. 02
3 .電容器內部每個串聯組串聯段間的電容之差不大於0 . 5 % ，三相單元中在任何兩個線路端子之間測得的最大電容與最小電容之比不超過1 . 02 。 -
High voltage shunt capacitor installation is comprised of assembling capacitor, high voltage vacuum or sf6 switch, serial reactor, zno arrestor and discharge device. because of its simple structure, small cubage, high output,
由集合式並聯電容器和高壓真空或六氟化硫斷路器串聯電抗器氧化鋅避雷器及放電線圈等設備組成的高壓並聯電容器成套裝置，具有裝置結構簡單體積小容量大佔地省 -
The sampling data are displayed by 7 - segment leds that are designed in a dependent pcb, the display board has a serial interface which use less pins of mcu. it ' s a efficient way. at last the outputs by calculation and reference of fis control the capacitor - group and voltage adjuster by relay - group, the whole device is divided into three part, the first part is sampling & control board ; the second part is display leds board and the third part is supply & output board
在電壓無功綜合控制器的設計中，考慮到mcu管腳有限且要求顯示的數據較多，使用了較多的spi介面形式的外圍晶元（如cs5460a 、 ezprom ） ，而且將數碼管顯示部分設計為串列數據傳輸模式，這樣其數據線也可以利spi介面的數據線復用，提高了mcu管腳的利用率也保證了功能的實現。
分享友人