servo simulator 中文意思是什麼

servo simulator 解釋
伺服模擬機
  • servo : n. 〈用作定語或前綴〉1. 【自動化】伺服。2. 伺服系統；隨動系統；伺服機械；從動系統。3. 【航空】舵機〈自動駕駛儀附件〉。
  • simulator : n. 1. 模仿的人，假裝的人。2. 模擬器，模擬器，模擬裝置[設備]；模擬計算機；模擬宇航機。
  1. Due to the electrohydraulic servo mechanism was used to drive the motion deck of the semi - physical simulator on the ground. therefore, the model of electrodraulic servo mechanism was built based on the fundamental equations of hydraulic jar and servo valve

    由於空間對接機構地面半物理模擬系統採用電液伺服驅動機構，因此本文根據電液伺服驅動機構的基本方程，建立單缸電液伺服驅動機構的模型。
  2. In order to guarantee the normal operation of hydroelectric generator unit, it is necessary to make a thorough test of the performance and characteristics of a governor before it is installed or after it is overhauled. to facilitate the test of the governor, a real - time dynamic simulator based on pcc for water turbine governing system was developed. it has three functions : simulating controlled objects ( pressure water conveying system, water turbine, generator and electric grid ), simulating governor " s electro - hydraulic servo system and working as a real - time measuring system for governor

    水輪機調速器是水輪發電機組一個很重要的自動化調節設備，它由調節器和電液隨動系統組成，在調速器安裝或者大修后都要對其性能和特性進行全面測試，為了方便對水輪機調速器的測試，特開發水力機組調速系統實時動態模擬儀，該模擬儀具有三種功能：對調速器調節對象（有壓引水系統、水輪機、發電機和電網）進行模擬、對調速器電液隨動系統與調節對象進行模擬和作為實時測試系統監測調速器的工作是否正常。
  3. The thesis devote to desams ( double - channel electro - hydraulic servo adaptive motor simulator - rig ) condition monitoring and accessing in theory and application. based on short signal analysis theory, the thesis explores the representative vibration faults of complex and non - linear equipment by both theoretical and experimental methods systematically

    本文基於簡訊號分析技術，針對電液伺服道路模擬試驗臺運行狀態監測和狀態評價，對簡訊號的最大熵譜分析技術在自復雜非線性系統的實時在線故障診斷領域的應用進行了系統的理論和實驗研究。
  4. Sequently it deals with frequency characteristics of the rudder and loading systems in matlab and simulate the system with 20 - sim. when improve the loading performance with adding the structure invariance principle to eliminate surplus force. to improve loading performance of loading system controlled by p - q servo - valve, this dissertation analyzes the uncertainties of electro - hydraulic load simulator, then designs a robust controller

    在此基礎上，應用matlab對舵機系統和加載系統進行頻域分析，利用20 - sim軟體完成對系統的時域模擬，並採用結構不變性原理來抑制多餘力干擾，改善系統的加載性能。
  5. This dissertation put forward a new control scheme to improve the control performance of load simulator. this control scheme which can bring the merit of the two kinds of servo valves into full play, use a pressure servo valve and a flow servo valve to control loading system

    本文提出了壓力伺服閥和流量伺服閥雙閥控制方案，通過與壓力伺服閥單閥控制方案的對比，指出其特點，為減搖鰭加載臺的設計提供了新方法。
  6. In this dissertation, the author builds up mathematical model of electro - hydraulic load simulator system. and it also builds up model of p - q servo - valve and complete system based on bond graph theory, which consider the nonlinear of orifices and real - time changing characteristic of liquid capacity in the cylinder chambers

    論文建立了電液負載模擬器的數學模型，同時，基於鍵圖理論考慮閥口流量非線性和液壓缸液容的時變特性，建立p - q伺服閥和全系統的鍵合圖。
  7. The experimental system is build up in this dissertation, by which we proceed the experimental research aiming at two structure schemes which are electro - hydraulic load simulator controlled by single pressure servo valve control and loading platform controlled by pressure and flow servo valves separately

    本文建立了減搖鰭電液負載模擬臺的實驗系統，並分別在單個壓力伺服閥控制加載系統、壓力伺服閥和流量伺服閥雙閥控制加載實驗系統進行了實驗研究。
  8. The aeroload simulator ( als ) is a typical application of the passive torque servo system ( ptss ) in the engineering

    被動式力矩伺服系統在工程實際中的典型應用就是力矩負載模擬器。
  9. The researches of this paper are very important and significative job to improve precision of servo - control system of three axis optical tracking test table even all type of electric simulator tables. this paper expounds the structure of simulator

    本論文的研究對于提高三軸光學跟蹤試驗轉臺以至於所有電動模擬轉臺的伺服控制系統的精度來說，是一項十分重要和有意義的工作。
  10. In the dissertation, the author analysis and makes the experiment about the electro - hydraulic servo system applied to the simulator inner gimbals

    本文針對轉臺內框電液位置伺服系統進行了理論分析及實驗研究。
  11. The codes of the software were developed after the mathematical models of controlled objects and electro - hydraulic servo system are successfully constructed. through the closed loop simulation test ( based on parameters of an actual hydroelectric power plant ) of the simulator linked with the pcc regulator, the effectiveness of the simulator software and pcc regulator software is confirmed

    在建立調節對象和電液隨動系統的數學模型后完成模擬儀軟體的編制工作，並將模擬儀和微機調節器進行閉環對接，利用某真實電站的參數進行模擬試驗，對模擬儀軟體和微機調節器軟體進行測試，驗證其有效性。
分享友人
分享到 Line

分享到臉書