setting pressure 中文意思是什麼

setting pressure 解釋
初撐力
  • setting : n 1 安裝;裝配;裝置;安放。2 (機器的)底座。3 調整。4 整齒。5 銼鋸子。6 配樂;譜曲。7 (果樹的...
  • pressure : n 1 壓;按;擠;榨。2 【物理學】壓力,壓強;大氣壓力;電壓。3 精神壓力,政治[經濟、輿論等]壓力。4...
  1. 4. it is the first time that eclogite conglomerates are discovered in maotangchan and fenghuangtai formations. this suggests that ultra - high pressure metamorphic rocks in the dabie orogenic belt exhumed to the earth ' s surface in lower cretaceous. the geochemistry data indicates that the protoliths of the eclogite gravels formed in a structure setting of volcanic arc

    首次在毛坦廠組、鳳凰臺組中發現了榴輝巖礫石,這一發現表明大別造山帶超高壓變質巖在早白堊世已經折返到地表,而且地球化學研究表明這些榴輝巖礫石的原巖形成於巖漿島弧構造背景。
  2. Apply computer chip to control the circuit ; omron opto - elecrtonic control - ler and panasonic and mitsubishi inverter have stable performance, high precision, rapid reaction and long life - span ; the controlling plate applies tactile operation board which is handled easily ; vertical structural screen is easy to adjust the vertical printing pressure so as to ensure the quality of printing ; the frame lift is driven by electrical motor and installed with imported linear guide rails, of which the speed - adjust device, scraper and scraping blade can be adjusted within15 to 45 and can be set for many times so as to repeatedly printing with good precision and output, the flat bed is made of 2mm stain - less steel plates which are flat, smooth and indeformable ; it is also equiped with micromatic setting device in order to ensure the precision of multi - color overprint and auto air - intake device to ensure strong adsorption

    採用電腦板控制電路,歐姆龍光電控制器,松下,三菱變頻器,行直穩定.精度高,反應快,壽命長,控制面板採用觸摸式操作面板,操作方便,六式結構型網版垂直升降印刷壓力可調保證印刷質量,機架升降採用電機驅動安裝進口直線導軌,刮刀、回墨刀可在15一45角調整,可設置多次,重復印刷保證產品精度.平臺板採用2毫米不銹鋼板製作,平整光滑不變形配有微調裝置,確保多色套印精度,配自動吸氣裝置,確保強有力的吸附。
  3. Setting home high pressure laminate hpl sheets, laminates

    把木業國際網設為首頁
  4. Due to the size of the defect, a fragment of bone is introduced to support the mucosal graft. strength of the repair is verified by increasing intercranial pressure with the valsalva maneuver, and it is seen to be watertight. rapid - setting fibrin glue is applied, and a second layer of mucosa is applied over this

    由於瘺孔較大,置入一些骨的碎片以支持填塞物,通過valsalva法咽鼓管吹氣法增加顱內壓可以觀察修補的牢固性,可以看到沒有泄漏,利用可以快速固定的纖維蛋白膠進行固定,其上鋪上一層粘膜,然後再用膠水進行固定。
  5. Chapter two " impacts of china ' s accession to wto on retail industry " analyzes : the influence of accession to wto on domestic retail industry ; pressure from international business capital due to its advantages of capital strength, scale and advanced business pattern ; competition pressure from low profit criterion of supermarket business ; pressure from the management advantage of international business groups. chapter three " development strategy for retail industry after china ' s accession to wto " studies the development strategy for china ' s retail industry after accession to wto : formulating relevant laws and policies for foreign capital introduction as soon as possible ( asap ) ; working out plans for establishment of large - scale supermarket network asap ; developing multiple business patterns with mainstay business as the focus ; developing chain store business to bring about scale efficiency ; accelerating of modern enterprise institutional reform ; promoting scientific management level of retail enterprises ; setting up scientific and overall marketing concept, further strengthening sense of market orientation ; attaching greater importance on resources of talented persons and commodities ; making full use of information technologies, implementing e - commerce mode in retail enterprises ; actively exploring northwest china and developing new market

    文章第二章「中國加入wto對零售業的沖擊」從中國零售業對外開放的歷史入手,簡要介紹了中國加入wto對國內零售業的影響,指出加入wto后,中國零售業可能面臨以下幾個方面的沖擊:國際商業資本在資金、規模和業態的先進性上所帶來的壓力;規模擴張壓力,即中國連鎖超市受到了投資規模擴張的資金壓力;超市行業低贏利水準的競爭壓力;國際商業集團在管理上的優勢對中國零售企業的壓力;新的管理理念、服務方式進入所帶來的沖擊;現代商業觀念的引進打破了中國商界固有的思維;國際經濟一體化程度的提高不斷促使中國零售業的絕對利潤和相對利潤下降;我國零售業網點的不足以及布局的不合理;零售業的信息革命所帶來的觀念沖擊。
  6. Abstract : the author describes the fuzzy control towards high - pressure air valve in raw coal separation system, including fuzziness of input, setting - up of fuzzy control rules and certainty of outputs

    文摘:論述了如何對原煤分選系統中的高壓氣閥進行模糊控制,其中包括輸入量模糊化、模糊控制規則的建立及輸出量的清晰化。
  7. Using the system designed in this thesis work, flow field calibration of the wind tunnel is accomplished, which covers dynamic pressure drop coefficient, dynamic pressure time stability, axial static pressure gradient, boundary layer, and degree of turbulence, etc. boundary layer measuring principle and method are especially described in detail, the relationship between boundary layer thickness, wind speed setting, and the depth of the experimental section is summarized, and finally the calibration data for th e model center zone under specific wind speed are given

    然後利用本文設計的系統完成了落差系數、動壓時間穩定姓、軸向靜壓梯度、邊界層及湍流度等內容的流場校測。特別對邊界層測量的原理及方法做了較詳盡的敘述,總結出邊界層厚度與設定風速、實驗段深度的關系,然後給出模型中心區一定風速下校正數值。
  8. About water economization, chiefly introduced new equipment, new hot water cycle system, the control of the exceed pressure of out water, reuse of grey water, reuse of rainwater, new method of setting fire - fighting poor, new kinds of water meter and its management and vacuum technology

    節水方面,主要介紹了新型節水設備,新型熱水循環系統,超壓出水的控制,中水回用,雨水回用,消防水池的設置新方法,新型水表及管理方法,真空節水技術。
  9. This paper introduces the existing problems and the process of remolding for the elevating organ of 40t - fuel - al mixed furnace door and specifies the remolding methods for the hydraulic pressure principle, the setting of the hydraulic pressure station and the hydraulic pressure vessel of the furnace door elevating organ

    摘要介紹了40t燃油鋁混合爐爐門提升機構改造前存在的問題及改造過程,並對爐門提升機構液壓控制原理、液壓站布置、液壓缸的改造方法進行了詳細說明。
  10. Its effect is simulated when setting a gas pressure accumulator near the valve

    在閥門處安裝蓄能器,對其減振效果進行了模擬。
  11. In setting up the model of optimizing design of dewatering program, the goal function ( reduction pressure coefficient ) was to make surrounding ground settlement minimum under the promises of ensuring foundation pit draw down

    在降水優化設計模型的建立中,以減降系數為目標函數,在保證基坑降深的前提下,使周邊地面產生的沉降最小。
  12. Consisting of blowers, air ducts, rescue stations and other auxiliary equipment, the mobile pneumatic emergency rescue device is a new - style firefighting emergency rescue equipment targeting at metro fires, with the working principle of adopting mechanical ventilation to create positive pressure so as to prevent the outside smoke entering, thus setting up a temporary smokeless secure place in the smoking accident site

    摘要可移動充氣式應急救護裝置是一種重點針對地鐵火災的新型消防搶險救援裝備,主要由風機、風管、救護站及其他輔助設備組成,其工作原理是採用機械通風的方式在救護站內建立正壓,阻止外界煙氣進入,從而在充滿煙氣的事故現場建立一個沒有煙氣的臨時安全場所。
  13. Saab socket tool for pressure switch vw audi v6 camshaft setting plate

    豐田凌志曲軸皮帶輪卡住固定工具
  14. When the electrohydraulic push rod works, if the external force suffered by the piston rod is more than the setting output torque, the piston moves to the end ; oil pressure in the oil pipeline increases rapidly to the setting value, the safety valve overflows rapidly, to achieve overload protection

    電液推桿工作時,當活塞桿所受外力超過調定的輸出力距活塞運動到終點;油路中的油壓迅速增高至調定值,安全閥迅速溢流,實現過載保護。
  15. Then the most representative node in each group is selected as the locality for setting pressure measure apparatus. the pressure measure points in xi ' ning are optimized and selected by this way. there are 32 measure points which will be setted in the network ( 16 setted )

    本文利用模糊聚類方法,對影響系數加以分析將具有相同水壓變化規律的節點劃歸為一組,最後在每組中選擇最具代表性的節點作為測壓點,從而優化選擇了西寧市給水管網測壓點。
  16. The real - time and dynamic simulations for the excavation processes and the setting of the braces and middle beams can be achieved with this method. what ' s more, the spatial dynamic change and distribution of the internal forces, displacements and the earth pressure acted on the retaining structures can be also described by the same method. 4

    該方法不僅能夠實時、動態地模擬基坑開挖全過程以及支撐和腰梁的設置,而且還能夠確定出開挖過程中支護體系內力和位移以及作用在支護結構上的土壓力的空間動態變化和分佈; 4
  17. Minimum setting pressure of relief valve

    安全閥調定壓力
  18. Experiment shows that when the gas hydrate is obtained by spray, its induction time is generally shorter, its phenomenon is not obvious, setting of initial temperature and pressure with an autoclave has certain influence on induction time, but not obvious, water resources and spray nozzle have bigger influence on the induction time

    試驗表明,噴霧方式制取天然氣水合物時,誘導時間普遍較短,誘導現象不明顯;反應釜設定初始溫度和壓力對誘導時間有一定影響,但不是很明顯;水源和霧化噴嘴對誘導時間的影響較大。
  19. This product, prepared from the 2 - stage high - pressure hydrofined white oil, is characterized this lproduct, prepared from the 2 - stage high - pressure hydrolfined operation, its quality is up to by its high breaking down voltage, low setting pont and steady operation, its quality is up to or even superior to the state standarde and is widely used in various transpormers to ensure therir normal operation

    本產品採用二段高壓加氫精製的白油為基礎油料,經復配調制而成。產品具有抗擊穿電壓性能優良、凝固點低、穩定性好等特點,質量指標達到或超過國家標準要求,可廣泛應用於各地區變壓器的安全正常運轉。
  20. Application and setting pressure of relief valves for ships ' machinery

    船上機械裝置用減壓閥的應用和設定壓力
分享友人