shaft pump 中文意思是什麼
shaft pump
解釋
礦井泵-
Fsb series fluoroplastic alloy pump is composed of pump body, impeller, back cover, seal, support, pump shaft, bearing, coupling, fasten bolt, nut and base plate
Fsb系列氟塑料合金泵由泵體、葉輪，后蓋，密封性，支架，泵軸，軸承，連軸器，吊緊螺栓，螺母，底板組成。 -
The entire rotating assembly shall be designed with sufficient rigidity and balanced to provide for a maximum shaft deflection at the lower seal of 0. 002 " under all operating points between plus or minus 40 % of the flow at best efficiency point ( bef ) on the pump ' s performance curve
整個旋轉總裝都應該具有足夠的硬度，在泵性能曲線最好性能的正負40 %的范圍內，在所有工作點，最大的軸偏差限制在0 . 002英寸內。 -
Selection and installation of submarine pump in inclined shaft emergency draining
斜井搶險排水中潛水電泵的配置及安裝 -
Based on the comparison of the restoring features of several common journal dimensions and in accordance with the shaft wearing character of large water pump, the treatment technique applying brush coast and hot spraying was discussed
摘要在比較幾種常用軸頸尺寸修復特點的基礎上，根據大型水泵軸軸承位磨損特徵， ?述了採用電刷鍍和熱噴塗處理技術修復水泵軸的工藝方法。 -
Pump shaft is provided with independent supporting point to ensure dependable running of motor bearing
泵軸有獨立的支撐點，使電機軸承運行可靠。 -
The 1st and 2nd order perturbed identification results that represent the strengthened effects on bending rigidity of the rotor caused by the impellers and the sleeves on the shaft of the pump are given, and the modified dynamic models of the rotor are obtained
給出了給水泵轉子上的熱裝葉輪、軸套對轉子剛度產生加強作用的一、二階攝動識別結果，得到了修正的給水泵轉子系統動力學計算模型。 -
The influence of the eccentricity mass moment, position of mass center and the bearing stiffness to the vibration characteristics of the rotor system is discussed in detail ; 3. to verify the exactness of fem and learn the principle of vibration of dredge pump further, the orbit of the rotor shaft of the pump in the dredger is measured, the measurement results show : the repeat of the orbit of the rotor shaft is very bad when dredge pump is in the dredging mud condition
模態分析確定了泥泵的振動特性（固有頻率和振型） ；諧響應分析確定了泥泵轉子軸在偏心力的作用下軸截面處的最大響應位移；研究了轉子軸的質心位置、軸承剛度和質量偏心矩對轉子軸振動特性的影響； 3 、採用軸心軌跡法，實船測量了泥泵軸工作時振動響應值。 -
Research on shaft of gear pump repaired by arc - sprayed 3cr
13修復齒輪泵軸試驗研究 -
Manufacture and repair of pump shaft seals for all american - made centrifu - gal pumps
為全美國製造的低溫泵修理泵軸封。 -
The strength and fatigue analysis of spline shaft of hq1400 high pressure pump worm
1400型壓裂泵蝸桿花鍵軸強度及壽命分析 -
The pump stroke sensor is installed near the rotary shaft of mud pump
泵沖傳感器裝在鉆井泵轉軸附近。 -
Borehole shaft driven pump
井下長軸傳動泵 -
In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards
論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。 -
Pump shaft sleeve
泵轉軸套筒 -
For pump shafts, the results reveal that the stress in the spline is higher than the other parts of the shaft, and the highest stress is at bottom and terminal of the spline. in fact, the broken of shafts is at the same position ; it demonstrates that the calculation is right
實踐證明，軸斷部位基本集中在潛油泵軸花鍵的根部，說明計算結果和實際是吻合的；對于潛油電機軸，應力集中點主要處在軸承鍵與環槽的交界處和花鍵的根部。 -
To ensure the charging pump working reliably, the following measures should be adopted : ( 1 ) adopting modified circular casing to reduce the radial force of the impeller and decrease the seal clearance ; ( 2 ) using radical ribs on impeller and helical sealing on shaft to realize minor pressure differential ; ( 3 ) using back pressure stuffing box to ensure sealing under small packing force ; ( 4 ) adopting self - lubricant flexible graphite stuffing for absorption of solids entering in the graphite in case of leaking
為確保灌注泵可靠工作，提出改進措施： （ 1 ）採用改型環形泵體降低葉輪的徑向力，減小軸封間隙，抑制泄漏； （ 2 ）採用背葉片降低葉片根部壓頭，獲得微壓，使軸封兩端承受較小壓差； （ 3 ）採用螺旋密封降低軸封兩端壓差，在保持微壓的同時避免出現負壓，密封效果更好； （ 4 ）採用反壓式填料密封結構，在很小的壓緊力下，即可保證密封； （ 5 ）採用具有潤滑功效的柔性石墨填料，即使發生軸封泄漏，進入石墨內部的固相顆粒也將隨著石墨的消耗而被鉆井液吸收。 -
The company specializes in the production of air - cooled diesel and gasoline engine, generator sets, sprayer pump, vibrator shaft, compact machinery, cut machinery, robin gasoline enginine, power tiller
公司專業生產風冷柴油機，汽油機，及其配套發電機組，水泵機組，藥泵，振動泵，平板夯，割縫機，羅賓汽油機，手扶拖拉機。 -
One - piece solid stainless steel dynamically balanced rotor / pump shaft assembly with short shaft overhang - specifically designed for submersible pump application
一體式實心不銹鋼動態平衡轉子泵軸以懸掛短軸方式安裝，這是專為潛水泵的特殊應用進行的特殊設計。 -
Insulation shell in a new induction shaft coupling is a main element to solve leakiness of magnet pump, it often works in changing magnetic field so that eddy current is produced, and eddy current results in wastage and decreasing the efficiency
摘要磁力聯軸器中內外轉子間的隔離套是磁力泵實現無泄漏的主要零件，由於磁力聯軸器工作時，隔離套便處在變化的磁場中，則其內部將產生渦流，導致渦流損耗和傳遞效率降低。 -
The series pumps are designed by our company on the basis of is series and isg series pump, adopting the modern most excellent hydraulic model and using lengthening shaft motor for direct - coupled configuration
系列泵是我公司採用is系列泵和isg系列泵的優點，選用最先進的水力模型而設計的新型水泵。
分享友人