shear 中文意思是什麼

音標 [ʃiə]
shear 解釋
vt. 及物動詞 ,vi. 不及物動詞 （sheared, 〈古語〉 shore; shorn , sheared）1. 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。
2. 〈詩〉（用劍）斬。
3. 【機械工程】剪斷，切斷；【礦物】截割；【物理學】（使）切變。
4. 剝奪；搶奪；騙取。
5. 〈蘇格蘭語〉（用鐮刀）收割（莊稼）。
6. 飛起，如割開一般地越過。
n. 名詞 1. 剪；切；刈割。
2. 剪下的東西。
3. 【機械工程】剪斷；剪力；剪床。
4. 【物理學】切變；切力；剪力。
5. （羊的）剪毛次數；（羊的）年歲。
6. 【礦物】截割；直立截槽。
n. 名詞 -er 1. 剪切者；剪切工；剪羊毛者。
2. 可剪毛的羊。
3. 剪切機，剪床；【礦物】直立槽截煤機。
n. 名詞 -ing 1. 剪羊毛。
2. 剪斷，切斷。
3. 剪下的羊毛。

  1. Papers also points out that the size of the adscititious powder agglomerate enwrapped by pure al melt, the effect and intensity of stirring shear force and the melt temperature at the beginning of reaction between the adscititious powder and al melt are the main factors affecting the in - situ reaction ongoing velocity

    並指出了影響反應進行速度的主要因素是熔體中分散包裹的加入粉末團的尺寸大小、有無攪拌剪切力作用、反應進行時的熔體溫度。其中，粉末團尺寸大小與徹底完成反應所需時間的關系最大，大尺寸粉末團將大大延長反應時間。
  2. 1. aviation meteorology : altimetry ; turbulence and wind shear ; aircraft icing ; route and aerodrome forecasts ; preparation of aviation weather documents

    1 .航空氣象學：包括測高學湍流及風切變飛機積冰機場及飛機航線天氣預報航空氣象文件的編制。
  3. Making use of the amendatory " truss + arch " theory, the theoretical formula of the shear resistanc

    目明，理論抗剪公式是偏於安全的。
  4. In this paper, a new amendatory shear mechanism of beams and columns based on the " truss + arch " mechanical model is put forward

    在本文中修正的提出了建立在桁架+拱力學模型基礎上的抗剪理論。
  5. Detail mapping shows that the yagan mcc consists of crystallized metamorphic core ( low plate ), detachment zone and upper plate. the metamorphic core consists of can be further subdivided into two level parts low - level high metamorphic and upper - level shallow metamorphic structural slice and between them there exists a ductile shear zone. thus the whole texture of the mcc is characterized by " three layers and tow zones " this reveals a process of extensional uplift of poly - level slices by poly ductile shear zones, a characteristics of poly - level extensional structural systems. the deformational environments change vertically in a sequence of high amphibolite facies

    亞干變質核雜巖由下盤結晶巖系變質核、拆離帶和上盤巖系構成，其中，變質核由四個單位及許多花崗巖體（脈）組成，可進一步分為中深和中淺變質兩個構造單位（巖片） ，之間發育次級韌性拆離帶（花崗質糜棱巖帶） ，加上上盤總體構成「三層兩帶」的結構特點。
  6. The pumps must be of the low shear archimedes screw type.

    泵必須是低剪切力的阿基米德螺旋式泵。
  7. Aseismatic design of brick masonry building with frame - shear wall at lower two stories

    八度區底部兩層框墻磚房的抗震設計
  8. Based on the analysis of mechanism for joint region, the " frame - wall " and " aslope compression stub column " mechanical models and yielding patterns of core zone of the joints are set up. the shear load - carrying formulation for joint core zone is also given in terms of plastic ultimate analysis. and then, the comparisons between the formulas given in this paper and that of chinese design code ( draft ) and nonlinear fem as well are presented

    對節點核心區的抗剪，通過受力機理的分析，建立了鋼「框架剪力墻」加混凝土「斜壓短受力體系及其屈服機制，根據塑性極限分析，給出了節點核心區抗剪承載力計算的迭加公式， 《規程》公式和非線性有限元近似模擬分析結果進行了比較。
  9. Establishment of kangguertage auriferous shear - zone and its important geological and ore - searching significance

    揚子地臺東南緣錳礦地質特徵及成礦原因
  10. In general, the deformation of the model grille is a combination of axial and shear strains.

    一般情況下，模型柵格的變形是軸向應變和切向應變的組合。
  11. Sintered bimetal material - determination of shear strength

    燒結雙金屬材料剪切強度的測定方法
  12. Finally, author have discussed the relationship transformation process of the honghe fault shear mode and block movement, proofed that the eta - type tectonic system was formed in miocene epoch

    討論了紅河斷裂剪切方式的轉變過程與巖塊運動的關系，論證了歹字形構造體系形成於約20ma的中新世時期。
  13. Figure 5. shear and bulk modulus relation for sandstone and weakly cemented sands

    圖5 .砂巖和弱膠結砂體中剪切模量和體變模量之間的關系。
  14. The derived dry bulk modulus must be positive and greater than 2 / 3 of shear modulus to insure a positive lame constant and poisson ' s ratio

    提取的乾燥體變模量必須為正，並且大於剪切模量的2 / 3 ，以保證拉梅常數和泊松比為正。
  15. Shear abilities and calculative methods of precasted concrete joints with steel flber high performance concrete

    預制結構鋼纖維高強混凝土節點抗剪能力及其計算方法
  16. Three stages of deformation can be distinguished from the cataclastic superposition of matrices that infilled the microcracks in cataclastic rocks, and two phas es of paleotectonic stress field from the typical conjugated shear joints by stereograms illustrating

    構造巖中膠結物和微裂隙充填脈反映了巖石碎裂變形的三次疊加。斷裂變形帶內發育兩期典型的共軛剪節理，但區域分佈各有特點，反映出斷裂變形的空間演化。
  17. The rigid arm cc is simply a statement that the "plane sections" hypothesis may be applied to the shear wall.

    剛臂CC只是說明了在剪力墻中可以應用「平截面」假設。
  18. 3. on the present deformation condition, the cementite in pearlitic steel has more severe plastic deformation capability t - he max shear strain up to 1. 9. 4

    C方式ecap變形條件使珠光體鋼65mn中的滲碳體可以表現出很強的塑性變形能力? ?觀察到的最大切變形達到1 . 9的等效真應變。
  19. Standard test method for laboratory miniature vane shear test for saturatedfine - grained clayey soil

    飽和細粒粘性土壤的實驗室小型十字板剪切試驗的標準試驗方法
  20. Based on the sha lo wan profiler data at 0740utc, the vertical shear at around 1, 100 ft was close to 8 kt per 100 ft. although this was lower than the 8 kt per 100 ft which has been used in the windshear warning system at the old kai tak airport, the increase in head wind was nonetheless significant due to the steep climb angle

    根據沙螺灣的氣流剖析儀在0740utc錄得的資料顯示，在約1 ， 100尺的垂直切變接近每百尺每小時8海里。雖然此切變低於以往啟德機場的風切變警報系統所用的每百尺每小時8海里，但因為陡峭的爬升角度，令到逆風的增加變得顯著。
分享友人
分享到 Line

分享到臉書