signal bias 中文意思是什麼
signal bias
解釋
信號偏壓-
As a mix - mode chip, the application - specific controller including analog signal and digital signal processing block can be applied to receiving, amplifying, processing, controlling signals of pir, and offer a wide application in some fields. in analog circuits, by sub - threshold mosfet, a self - bias current source is presented, which has a high power supply restrain ratio and a complementary to absolute temperature characters
這款晶元是一款數模混合晶元，包括模擬信號處理（含模數介面模塊）和數字信號處理兩大模塊，完整實現對紅外信號的接收、放大、處理、控制，產生有效數字電平驅動繼電器、可控硅等負載，應用於自動燈等多種場合。 -
The positive-going signal subtracts from the forward bias of the lower transistor.
正向信號則使它的正向偏壓減弱。 -
For phonetic signal modulation, if the pass band range of the band pass filter ( bpf ) is 300hz - 3400hz, the anti - noise properties of laser are approximately independent of bias current and parameters of the cavity ; when the pass band range of bpf increases to a certain degree, modulating bias current and parameters of the cavity can improve the anti - noise properties of laser
對語音調制情況，如帶通濾波器的通帶范圍取為300hz - 3400hz ，則激光器的抗噪聲性能基本不依賴于偏置電流和腔內參數；當帶通濾波器的通帶范圍增大到一定程度，調整偏置電流和腔內參數可以實現半導體激光器的高抗噪聲性能。 -
The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement
偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。 -
The thesis analyses the problems on the noise of apd photoelectric receiving system. author designs apd laser signal receiving system circuits, front amplify circuit, controlling time - series logic circuits, dc / dc transform circuits. and takes apd bias voltage fuzzy control
分析了apd光電接收系統的噪聲問題，並對apd激光信號接收系統電路、前置放大電路、控制時序邏輯電路、 dc / dc變換電路進行了設計，採取了apd偏壓模糊控制。 -
A driving signal with a dc bias voltage and ac voltage is usually necessary for sensing very small capacitance. the reliable operation conditions of the capacitive sensor for foreign acceleration had been researched with the assumption of the parallel comb plates. but the comb plates are actually not parallel for the reason of the drie process
前人在研究外界加速度信號對傳感器的作用時，假定驅動信號產生的靜電力作用在平行梳齒電容極板上，但是，在用drie工藝對硅進行刻蝕時會產生側蝕效應，從而得到的梳齒電容有一定的傾斜角度。 -
3 ) < wp = 12 > using perturbation analysis, the space - correlation loss and the bearing - estimated error for finite - bandwidth incoherently distributed sources are evaluated analytically, respectively. it is disclosed that bandwidth - induced bearing bias increases monotonously with the signal ' s relative bandwidth. when the relative bandwidth is not small enough to be negligible, the spatially - only processing cannot lead to accurate bearing estimate, that is, the joint space and time processing is necessary for high - precision bearing estimation
3 ）利用擾動分析方法，解析評價了有限帶寬引起的非相干分佈源的空間損耗及其對波達方向估計的影響；分析表明，帶寬擾動引起的方向估計偏差隨信號相對帶寬單調增加；當相對帶寬無法忽略時，為了得到高精度的波達方向估計，需要進行聯合空時處理。 -
The usual method to broaden the bandwidth of the pin diode switch is combining the pin diodes with stub filters : when under reverse bias, the didoe is part of the filter, the transmission bandwidth is broadened ; when under forward bias, the structure of the filter is destroyed, signal is isolated
Pin二極體開關展寬頻帶的方法一般是把pin二極體結合進短截線濾波器，使pin二極體在反向偏置時作為濾波器的組成部分，以展寬開關在傳輸狀態下的頻帶；當二極體正向偏置的時候，濾波器的結構被破壞，起到隔離的作用。 -
In charter iii, the author designed a set of direct current bias and a schematics for measuring signal, by which the character of conduction of the laser plasma in electrical field caused by bias was studied
第三章中本文作者自己設計了一套直流偏壓裝置及信號測量裝置及方案，從激光等離子體在偏壓電場作用下的導通特性測量，研究了偏壓對激光等離子體空間膨脹過程的影響機理。 -
The results that increasing of bias current and shunted resistance and lowing critical current and connected inductance can decrease the transmission time are shown ; ( 4 ) a new type of circuit, ladder shape multiplayer jtl. structure is provided by author, thus output signal of rsfq circuits can be amplified before transfer to room temperature electronics system. it has highly gain of amplify relatively and the double peak structure are avoided through decreasing parasitic capacitance
（ 4 ）針對目前超導與室溫介面電路的電壓放大器存在的「雙峰」和放大增益效率較低的不足，提出了一種全新的階梯式多層jtl電壓放大電路結構，較好的解決了以上的問題，通過初步的模擬分析證實，該電路的構思極負有創新性。 -
And then the stability and the stable error response of the dpll are analyzed. there is an obvious doppler shift frequency offset in the received signal with flight at a high speed, in the dissertation the uniform sampling second - order dpll is used to remove the frequency bias for its excellent high - pass characteristic of the error transfer function
由於高速飛行的遙測目標在接收信號中會出現較大的多普勒頻率分量，而典型均勻采樣二階數字鎖相環dpll （ digitalphase - lockedloop ）的誤差函數具有高通特性，所以本文提出一種利用其高通特性來去除多普勒頻率分量的新方法。
分享友人