sliding part 中文意思是什麼
sliding part
解釋
滑動件-
In this dissertation, through computer simulation, the problems of modeling, control and guidance of auvs are presented. the first part of this dissertation addresses the problem of dynamically modeling of auvs, and derives thrusters " two - dimension nonlinear dynamic model, which has axial flow speed and propeller rotational velocity as two state variables, voltage or current of motor as inputs, and thruster force and torque as output. the second part focuses on the nonlinear adaptive sliding mode control of auvs in diving plane and steering plane
本論文系統研究了自主式水下航行器的建模、非線性自適應滑模控制、以及深度調整和水平面導引方法等問題，具體成果和創新點如下1 、根據流體力學理論，建立了螺旋槳推進器的動態模型，它以螺旋槳來流速度v _ p和螺旋槳轉速n為狀態變量，以電機施加轉矩為輸入，螺旋槳推力t和轉矩q為輸出。 -
Safety of woodworking machines. circular sawing machines. part 1 : circular saw benches with or without sliding table and dimension saws
木工機械的安全.圓盤鋸機床.第1部分:圓盤鋸鋸床 -
Fire safety systems - operated safety systems - part 3 : automatic shutting sliding door
消防系統.運行的安全系統.第3部分:自動關閉滑動門 -
Hardware for furniture - terms and definitions - part 8 : sliding door gears
傢具用五金件.術語和定義.第8部分:推拉門齒輪 -
Abstract : based on the data obtained from field observations and deformation monitoring, this paper deals with the deformation and failure of a double - decked slope composed of soft rock strata in its lower part and hard - brittle rock strata in its upper part. it is demonstrated that the deformation of this kind of slopes is always initiated by the non - homogeneous rheological compression of the lower soft rock strata, leading to the tension fracture and toppling of the upper hard rock strata, and at last the sliding of the whole deformed body will be caused by the shear failure along the stress - concentration zone in the lower soft rock mass under the actions of the gravitational loading and infiltration water
文摘:以現場考察和變形監測資料為依據，探討一個下部有軟弱基座，上部為硬脆性坡體的「二元結構」邊坡的變形破壞問題，揭示這類邊坡的變形總是以下部軟弱巖體的不均勻壓縮流變為先導，進而引起上部硬脆性坡體的拉裂與傾倒，最終通過滲入水的作用，使下部承載狀況已進一步惡化了的軟弱巖體，沿剪應力集中帶發生剪切破壞而導致整個變形坡體的下滑。 -
This paper researches in detail the sorting system which is the core part of sliding shoe parcel machine through theoretical and experimental analysis
本文對推塊式分揀機的核心部分? ?分揀系統做了詳細的理論與實驗性研究。 -
The most favourable sequences for subtle traps are cycle 3 and cycle 4, and the most favourable oil and gas - pool forming regions are jishan sandstone, fan - delta sandstone of south part of linnan sag, sliding turbidity sandstone of the slope part of shuangfen delta front and turbidity and sub - fan near fault of jiangjia dian
基山砂體、臨南窪陷南部沙三下扇三角洲砂體、雙豐三角洲前緣的斜坡地帶的滑塌濁積巖砂體和江家店地區的濁積扇體和近岸水下扇體是最有利的勘探目標區。 -
Technical requirement for repairing special equipment of trailing hopper suction dredgers part 2 : sliding bottom values
耙吸挖泥船專用設備修理技術要求第2部分：水平滑移式泥門 -
The model of winding & transpot can be making with consumer ' s opinions. custom - msde part stainless steel, sliding - vane, food employ rubber belt, abs, stainless steel conveyer and stainless steel net etc
提升、輸送形式根據用戶要求訂制，分別為不銹鋼刮板、不銹鋼網帶、食用橡膠、 abs工程塑料、不銹鋼螺旋輸送帶。立即替換掉此處的內容及標題，即可用這個樣式迅速創建版面。也可以在你需要的位置插入圖片。 -
( 2 ) this paper presents some basic theory about wavelet analysis, and proposes a fast wavelet ( packet ) algorithm based on sliding window. by storing the part of wavelet packet coefficients in memory in advance, we avoid repeating calculation and gain a fast wavelet algorithm at the cost of increasing some storage space
（ 2 ）本文介紹了小波分析的一些基本理論，提出了一種基於滑動時窗的小波（包）快速演算法，通過預先存儲一部分小波（包）系數，避免重復計算過程，可以用較小的存儲空間為代價，獲得了計算效率很高的小波（包）變換快速演算法。 -
Adapable units of wire and cable machinery pay - off and take - up. part 4 : sliding guide type pay - off and take - up
電纜設備通用部件.收放線裝置.第4部分:導軌式收放線裝置 -
Safety of wood working machines - tenoning machines - part 1 : single and tenoning machines with sliding table
木工機械的安全.制榫機.帶滑動工作臺的單端制榫機 -
Safety of woodworking machines - tenoning machines - part 3 : hand fed tenoning machines with sliding table for cutting structural timbers
木工機械安全.制榫機.第3部分:用於切割結構木材的帶滑動臺的人工加料制榫機 -
In real engineering, the two surfaces in sliding contact are rough. and it is an important theoretical part to calculate the coupled temperature and stress of sliding bodies having rough surfaces
工程實際中，相互接觸的滑動摩擦表面是粗糙的，對粗糙表面的瞬時溫升和熱機械應力分析有重要的理論意義。 -
In the dry sliding experiments of composites, friction coefficients decrease with the loads. plastic deformation happens in the worn surface where the element of fe is found, so pam microfibrils support part of the load and prevent the further deformation
低速低載時，試樣磨損表面出現塑性變形，在復合材料的磨損表面還發現fe元素的存在，表明pam微纖承受了部分載荷，阻止了基體的粘著轉移，此時磨損機理為磨粒磨損和粘著磨損。 -
Through establishing three mathematics models including the movement equation of the mechanical and electrical transmission system, the control of the load and the sliding in stable status, direct - current - brake of ac motor, this paper ascertained the range of the frequency value of drive motor and the efficiency of transmission system, calculated the efficiency of load motor in stable status and the moment of load motor in braking. this paper completed the design of the mechanical part of inertia brake test platform and provides a tool for the measurement of the inertia brake parameters
本文還通過建立慣性制動器試驗臺的包括機電傳動系統的運動方程、穩態運行時負載與轉差率控制、交流電動機直流制動在內的三個數學模型，確定驅動電機的頻率取值范圍和傳動系統的傳動效率，驗算慣性制動器穩態運行時負載電機軸功率和慣性制動器制動時負載電機軸力矩，完成慣性制動器試驗臺設計中的機械部分，為慣性制動器各參數的測量提供工具。 -
Abstract : this paper analyses the structure characteristics, die structure and design plan of qd1212 driving terminal. the sliding part design is becoming more ideal after several times of modification
文摘:分析了qd1212驅動端蓋結構特點，壓鑄件模具結構及設計方案；該模具滑塊部分的設計經過多次修改後更趨合理，鑄件易於脫模。 -
The inner loop make the cart track the position. the balance control part based on sliding mode keep the pendulum upright
平衡控制利用滑模變結構控制理論使擺到達近似垂直向上位置后能保持垂直向上狀態。 -
Through these studies and analysis, following conclusions could be drawn : ( 1 ) it is necessary to study on harness engineering of landslide and dangerous rock since the main representations of this geological hazard are landslide and dangerous rock through geological investigation ; ( 2 ) it can be concluded though stability analysis that the dingzhuang landslide is stable naturally, which is identical to the in - situ investigation ; ( 3 ) through stability analysis, the landslide would slide if the water level dropped down from 175. 10m to 156. 0m and it rained successively after the three gorges reservoir work. ( 4 ) according to the results of calculation and the characteristic of the landslide, it is suggested that such measures as unloading at upper part, anchorage and pile supporting system and drainage system should be used on the landslide. ( 5 ) according to geological investigation, there are three kinds of dangerous rock in the engineering, those are failing - down rock, collapsing rock and sliding rock
因此有必要對滑坡進行治理； （ 4 ）根據滑坡推力計算結果和本滑坡屬牽引式滑坡的特點，滑坡體上部相對較穩定，中下部處于基本穩定或不穩定狀態，因此建議此滑坡治理採用上部削坡減載與錨拉抗滑樁、擋墻進行支擋結合的處理方法，同時結合截排水等措施進行綜合治理； （ 5 ）根據地勘資料，通過對危巖體的形態、規模、基座和底界層及分佈特點和分析，將本工程危巖體失穩崩塌的方式歸納為墜落式、傾倒式和滑塌式三種類型並分別提出相應的穩定性計算方法； （ 6 ）分別對本工程中的危巖體進行了穩定性計算，並且發現其都處于不穩定狀態，因此根據實際情況分別提出相應襯砌支撐和清理等加固治理措施，最後還對加固后的危巖體進行了校核計算，滿足要求。 -
State of railway vehicles - passenger area - part 7 : loading doors - type of construction : sliding plug doors, sliding doors, roller loading doors, folding doors
鐵路車輛的狀況.乘客區.第7部分:裝貨門.結構類型:推
分享友人