solid impurity 中文意思是什麼
solid impurity
解釋
固體雜質-
Ivory or yellow flaky solid, no foreign impurity
象牙色或黃色片狀固體，無外來雜質 -
Some impurity as well as bromine was brought by solid matter that smuggled with foam fog in flash steam
閃蒸氣中霧沫夾帶的固體物引入了溴等雜質。 -
With the development of science and technology, more and more oxide crystals are synthesized by more and more advanced technique, the new oxide crystals are incessantly synthesized and the new characters of oxide crystals are incessantly founded. corundum dopped with impurity not only is cherished because of it ' s beautiful appearance, but also is used in the fields such as electrotechnics, mechanism, laser, the optic apparatus and the underlay of semiconductor. sapphire dopped with ti3 + is the best material of the tunable solid laser. zno crystal is material of the direct gap semiconductor ( the width of forbidden band : 3. 37ev ). the excited emission in zno crystal at room temperature has been found, so the ultraviolet luminescence in zno semiconductor can be acquired at room temperature
含有少量雜質的剛玉晶體（ - al _ 2o _ 3 ）不僅由於其色澤艷麗成為人們珍愛的名貴寶石，而且由於它具有的優異性能，被廣泛應用於電工、機械、激光器，光學器件和半導體襯底材料。鈦藍寶石是目前最優異的固體寬帶調諧激光材料，用於製作飛秒脈沖可調諧激光器。氧化鋅晶體是直接帶隙寬禁帶半導體材料（禁帶寬度3 . 37ev ） ，現已發現具有室溫下受激發射特性，有可能實現室溫下半導體紫外發光。 -
At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency
在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。 -
Air - removed filter series is the attached device of the flow meter, which can remover the air and solid impurity so as to ensure the flow metre accuracy and operation life
消氣過濾器是流量計附屬設備，它具有消氣、過濾液體中固體雜質的作用，從而保證流量計的計量精度，延長流量計的使用壽命。 -
The porous structure is proved by observation with scan electron microscope. the aperture is 0. 13 - 2. 0 u m which can block off the solid particulate and suspension impurity
溶膠凝膠法：其「微孔穴」結構，葉阻擋固體顆粒及懸浮雜質的于擾。 -
The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm
採用改進的檸檬酸法（以檸檬酸和edta乙二氨四乙酸為復合絡和劑，檸檬酸為燃料）和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm （ la _ （ 0 . 9 ） sr _ （ 0 . 1 ） ga _ （ 0 . 8 ） mg _ （ 0 . 2 ） o _ （ 3 - ） ） ，用差熱?熱重分析（ dta / tg ） 、 x光衍射分析（ xrd ） 、交流阻抗譜技術（ ac - impedancespectra ） 、比表面積分析（ bet ）和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵，並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。
分享友人