solid interface 中文意思是什麼

solid interface 解釋
固體界面
  • solid : adj 1 固體的；實心的，實質的，密實的。2 【數學】立體的，立方的，三維的。3 結實的，堅強的，堅固的...
  • interface : n. 分界面，兩個獨立體系的相交處。vt. （-faced, -facing） 把界面縫合。vi. 交流，交談。
  1. Controlling solid - liquid interface configuration during crystal growth of cdznte by vertical bridgman method

    晶體時固液界面形狀的控制
  2. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  3. The globalization course was that the preformed texture recrystallized and became the granular equiaxed grain, when the temperature rose and the holding time prolonged, the granular grain melted at some area and at the liquid - solid interface the grain globalized at the role of the curvature overheated

    過程機制為：擠壓形變組織在加熱過程中首先發生再結晶長大變為顆粒狀等軸晶；隨溫度升高和保溫時間延長，等軸晶發生局部熔化，液固界面的曲率過熱使晶粒外形向球狀轉變。
  4. The paper studies the degradation rule of physical mechanical property of vulcanizate during the period of heat ageing, which involves the relationship between the property, variable temperature and time. the analytic expressions for the frictional temperature rise of the interface were presented according to the theory of heat conduction of solid when a tire slides of rolls along the road. finally, the value of temperature and pressure is used to monitor the tire ' s status

    本課題針對影響汽車輪胎橡膠機械性能的溫度老化模型進行了一定深度的理論研究，並進一步研究輪胎的在滑動、滾動時的溫度場的數學模型，在理論上論證了溫度、壓力是影響輪胎行使安全性能的重要因素，並以其作為最終的監測對象。
  5. Compared with the behavior of macromolecules in real solution system, the adsorption information in the monte carlo simulation system, such as adsorption isotherm, surface coverage, and bound fraction, was studied for discussing its relation to simulation parameters. five - selection simple cubic lattice, self - avoiding walk, and nearest interaction model were used to construct the homopolymer adsorption model on the solid - liquid interface. periodic boundary conditions were used to reduce the fixed error from limited cubic lattice in size

    模擬中採用五選擇簡單立方格子上的自迴避行走和最近鄰相互作用模型；使用周期性邊界條件以減小有限大格子空間帶來的系統誤差；用鏈節間相互作用能、界面吸附能、體相濃度和鏈長約束體系中的高分子的吸附行為；用末端轉動、 l -翻轉、曲柄運動、蛇形運動和r - r切除-生長法對模擬體系進行擾動；用系統達到吸附平衡后的樣本來研究模擬體系中的高分子鏈在固液界面上的吸附。
  6. Liquid and solid bonding strength of cu fe interface in copper clad steel

    鋼液固相復合界面的結合強度
  7. Hence, it is very significant to analyze the mechanism and extend law of interface debond of solid rocket motor

    因此，研究固體火箭發動機界面脫粘的機理和擴展規律，是固體火箭發動機結構完整性分析的重要課題。
  8. Interface debond between propellant and liner is a key form of failure of the structure integrity in the analysis of solid rocket motor

    在固體火箭發動機結構完整性分析中，襯層/推進劑藥柱粘接界面的脫粘是完整性被破壞的關鍵形式之一。
  9. Because the propellant grain is viscoelastic material, the liner and adiabatic layer are also viscoelastic one, the interface debond problem is actually interface crack about elastic - viscoelastic or bi - viscoelastic materials. research about this problem relates to the knowledge of viscoelastic mechanics and interface fracture and combustion. numerical analysis method about interface debond on solid rocket motor is researched in this paper

    由於固體火箭發動機的推進劑藥柱是一種粘彈性材料，襯層和絕熱層也具有粘彈性性質，因此其界面脫粘問題實際上是彈性-粘彈性或雙粘彈性各向同性材料界面裂紋問題，對該問題的研究涉及到粘彈性力學、界面斷裂力學和燃燒學等相關學科。
  10. Because of limit that invisibility and discommodious in anciently program, based on the method of limited rigid body equilibrium, using visual program language vb and connect autocad, realize plane and solid programme of abutment analysis of arch dam, provide alternation interface for designer. presently, our country constructing and will construct high 300m arch dam, it is important to judge security based on nonlinear fem analysis. basic theory of nonlinear fem analysis and its realization in ansys were studied

    針對傳統程序的存在問題，非直觀、不易操作特點，以剛體極限平衡法為基本分析方法， visualbasic作為操作平臺，結合autocad圖形軟體，完成了剛體極限平衡法二維、三維壩肩穩定分析程序設計，使之具有直觀性，可視性、易操作性，為設計人員提供了具有友好界面的工程使用軟體目前我國西部在建和將建一批300m級的高拱壩，運用有限元方法計分析拱壩穩定性、評判大壩安全度十分有必要。
  11. The velocity equation of stoneley waves at a liquid - solid interface

    固體分界面處斯通利波的波速方程
  12. Abstract : a new simulating method is established for the calcul ation of the hardness profile of high - carbon - concentration deep - carburization, on the basis of analyzing this process and taking into account the influence o f carbide solution and dissolution, carbon - concentration and temperature on the diffusion behavior, and the influence of the environment factor on carbon trans fer through the gas - solid interface

    文摘:在對高濃度深層滲碳的特點進行分析的基礎上，考慮到碳化物的析出與溶解、溫度及碳濃度對擴散行為的影響，氣氛環境對相界面碳傳遞過程的影響，淬火烈度對滲碳層冷卻效果的影響，提出了一種新的模擬高濃度深層滲碳滲層硬度分佈的方法。
  13. This model is represented by a superposition of gaussian beams, and can simulate the wave fields of planar or focused transducers radiating at oblique incident through a curved fluid - solid interface. the mgb model is highly efficient and can be easily implemented on an ordinary personal computer

    該模型是由一系列高斯聲束疊加而成，可模擬直探頭和聚焦探頭水浸檢測斜入射時的聲場分佈，計算效率高，易於在個人計算機上實現。
  14. The bionic non - smooth technique was applied to the centrifugal water pump to modify the liquid flow structure in the pump to reduce the hydraulic drag in the liquid - solid interface, resulting in the enhancement of the pump efficiency

    摘要基於仿生非光滑技術，通過改變離心式水泵中液體的流動結構降低固液界面的阻力，研究了水泵的增效問題。
  15. Moreover, nh3 gas from dissociation of ( nh4 ) 3zncl5, analogous to the inert gas, can adjust the growth rate of znse and stabilize the vapor - solid interface, and avoid the difficulties of the non - emerging of sen ( n = 2 ~ 8 ) in selenium vapor. above all, ( nh4 ) 3zncl5 is a novel transport agent with comprehensive advantages

    此外，該輸運劑可提供類惰性氣體nh _ 3而穩定氣固生長界面，並可避免了se _ n （ n = 2 - 8 ）共存所導致的se _ n相互競爭降低se分壓等工藝問題，是一種多功能的znse晶體氣相生長輸運劑。
  16. J. b. wang and g. w. yang, phase transformation between diamond and graphite in preparation of diamonds by pulsed - laser induced liquid - solid interface reaction, j. phys. : condensed matter 11 ( 37 ), 7089 ( 1999 )

    王金斌，楊國偉，脈沖激光誘導液-固界面反應合成金剛石納米晶中的結構相變模型，高壓物理學報， 13 ， 147 （ 1999 ）
  17. Hysteresis of contact angle at liquid - solid interface

    接觸角滯后現象的理論分析
  18. Stoneley wave is a kind of guide waves propagating along the liquid - solid interface in well. when a sonic beam strikes the surface of a thick plate immersed in a liquid, a stoneley wave is generated. stoneley wave approach is applied on analysis of well logging more and more widely in recent ten years with the introduction of advanced analysis methods for component waves from full - waveform array acoustic log data. the spectrum of stoneley waves are used to identify the fractured zones and quantitatively calculate the fracture parameters of reservoirs, especially to evaluate the validity of fractures at fracture - type complex reservoir

    斯通利波是一種沿井壁傳播的聲波，當聲波脈沖與井壁和井內流體的界面相遇時就會產生斯通利波。近十幾年來，由於長源距和偶極子陣列聲波儀在測井中的廣泛應用和全波形陣列聲波測井資料中各組分波的處理分析方法的進步，可將斯通利波分離出來單獨研究並應用於測井資料分析。斯通利波技術是評價裂縫及其滲透性的有效方法。
  19. Conjugate heat transfer calculation was carried out, with simple algorithm, studied up on boundary condition and modified pressure adapting algorithm, to give prediction on velocity field inside the disk cavity, the whole temperature field including fluid region and solid region, and heat transfer coefficient at fluid - solid interface. the simulation results indicate, ( 1 ) in rotor - stator disc cavity, the secondary flows near rotating disc stronger than which near state disc, keeps temperature of rotating disc lower than state disc ' s

    為了使計算方法得到更多的算例驗證，本次研究做了若干算例，文中選出其中四個算例進行分析，計算結果表明： （ 1 ）在轉靜盤腔結構中，轉盤表面的二次流大部分區域都比靜盤表面的要強，所以轉盤表面換熱情況較好，轉盤的總體溫度水平要低於靜盤。
  20. 6. the melting of the grain boundary is the reason of the semi - solid grain globalization, and its control factors were the atomic diffusion velocity and the liquid - solid interface curvature

    6 、半固態晶粒球狀化的基本原因是晶界熔化，其控制因素是因液界面處原子擴散遷移的速度和界面曲率。
分享友人
分享到 Line

分享到臉書