solution surface 中文意思是什麼

solution surface 解釋
積分曲面
  • solution : n. 1. 溶解；溶液，溶體，溶劑。2. （補輪胎用的）橡膠水；〈美國〉藥水。3. 解決，解答 （of; for; to）; 解釋；（數學等的）解法，解式。4. 免除，解除。5. 【醫學】消散，消退。
  • surface : n 1 表面；地面；水面；廣場，空地。2 外觀，外表，皮毛。3 【幾】面；切口；【航空】翼面。adj 表面的...
  1. A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate

    對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎
  2. Glucose biosensors were then constructed by these nanocomposites, and their electrochemical properties had been explored. secondly, the self - assembled nanocomposite was formed by mwnts and biopolymer, and was used to study the electrochemical properties of nadh. and finally, the modified electrode which was formed by immobilizing small molecular onto electrode surface, was used to detect dsdna in the solution

    本論文首先，將多壁碳納米管（ mwnts ）與納米顆粒相結合，制備的納米復合材料用於構建葡萄糖生物傳感器，並研究了它的電化學性質;然後，將mwnts與生物聚合物自組裝制備的納米復合材料用於研究nadh的電化學性質;最後，本文還將小分子自組裝固定在電極表面，用於測定溶液中的dsdna 。
  3. Surface tension of the calcium hydroxide solution is higher than that of water when the concentration of additive is the same

    但同濃度下，石灰水溶液的表面張力要高於水溶液的表面張力。
  4. In order to simulate working atmosphere of additives in concrete, the influence of additives on surface tension of calcium hydroxide solution is studied in this paper too

    為了更好的模擬外加劑在混凝土中的工作環境，本文同時研究了外加劑在飽和石灰水溶液的表面張力。
  5. Its mechanism is to reduce the surface tension of solution, to enhance the efficiency of nebulization, to generate glue group of chemical combination and to concentrate molybdenum by surfactant

    其機理是溶液表面張力的降低、霧化效率的提高、膠團化合物的形成及表面活性劑對鉬的富集作用。
  6. Send wind to ensure public air conditioning system is safe, prevent to erupt popular, when necessary, can mix to the whole equipment that offer wind canal sending wind is service and effective chloric rise for every 500 to 1000 milligram contain chloric disinfectant solution to wipe disinfection. 2 it is to be able to undertake air disinfection and object surface are disinfected

    為確保公共場所的空調系統安全送風，防止爆發流行，必要時，可對整個供風設備和送風管路用有效氯為每升500到1000毫克的含氯消毒劑溶液擦拭消毒。
  7. The detecting and measuring instrument used for detecting and measuring surface tension by means of bio - solution and sense finding methods at moving conditions is developed in order to detect and measure surface tension adsorptive ratio and diffusivity of the active substance of the alveolus surface and other life - forms. the alveolus burned by breath in the high temperature condition or damnified with serious sickness will destroy the active substance of the alveolus surface. detecting and measuring surface tension of the active substance of the alveolus surface and other life - forms can help us determine the extent of pathological changes or damnification of the alveolus or other apparatus which can produce the active substance. lt is the research problem of the modern times medicine

    生物液智能表面張力動態測試儀是為測試肺泡肺液表面活性物質的表面張力、吸附率和擴散率以及其它生物液的表面張力而研製的。高溫條件下通過呼吸而燒傷肺部，或者因某些嚴重的疾病而損傷肺部都將會破壞肺部表面活性物質。通過測試肺泡或其它生物液表面活性物的表面張力，可以幫助我們測定肺泡或其它產生活性物質的器官病變損傷的程度。
  8. As we know, inverse techniques make blade ' s profile well compatible with its surface velocity distribution, however, they give designers big challenges that the ideal velocity distribution is hard to obtained and sometimes the non - physical solution, such as double covering of flow field or unclosed profiles, would come out. the proposed design procedure in the paper has avoided the disadvantage mentioned above. in this paper, a quasi - irrotational equation is used to describe the flow in cascade instead of the generally used irrotational equation

    眾所周知，一般的反問題和混合問題的最大特點，是在給定的壓力面和吸力面上的壓力分佈或速度分佈條件下，直接得到葉片的幾何形狀，它可以使葉型型面與表面氣流參數有機結起來；其不足之處在於，對設計者而言，很難給定理想的葉片表面壓力分佈或速度分佈，並且有時會得到一個非物理解，如：得出的初始葉型可能會出現前緣、尾緣不封閉的現象。
  9. To understand the meaning of the remaining surface integrals in(5. 9. 22)we first investigate the solution corresponding to a doublet source.

    為了理解（5922）中其餘那些曲面積分的意義，我們首先考察對應于偶源的解。
  10. Since the dry plating does not require the reduction using electricity, the dry plating has many advantages in that it permits to plate the surface of non - conductive polymer materials, and further does not use the electrolyte solution so that wastewater is not produced and the plating thickness can be readily controlled

    由於不要求用電還原，干鍍有許多優點，因為它允許對非導電性聚合物進行上鍍，其次不使用電鍍液，結果不產生廢水，而且鍍層厚度易於控制。
  11. An electric potential exists between the surface of the particle and the bulk of the solution.

    微粒表面和整體溶液之間存在電勢。
  12. The method of obtaining high concentration of na2feo4 solution by quick electrolysis mainly contains four aspects : adoption of either a diaphragm or an ionic membrane electrolytic cell in which a thin anodic cell lying between the two cathodes, ( 2 ) using an iron anode that has larger specific surface area, ( 3 ) keeping suitable concentration of naoh in the anodic cell, adoption of lower current density and higher electrolyzing speed. the practical technique parameters follow a s below : the naoh solution of 14 - 16mol / l, the temperature of 303 - 308k, the surface anodic current density of 300a / m2, the unit electrolyzing speed of efficiency larger than 6. 0a / l

    快速電解獲取高濃度na _ 2feo _ 4溶液的方法，主要包括四個方面：採用兩陰極室夾一厚度較小的陽極室的隔膜（或離子膜）電解槽；使用比表面積較大的鐵網陽極；保持陽極室中有適宜濃度的濃naoh溶液；採用較低的電流密度和較高的電解速度。具體工藝參數是： 14 16mol / lnaoh溶液、溫度303 308k 、表觀陽極電流密度300a m ~ 2 、有效單位電解速度6 . 0a / l 。
  13. As a rule, the immunosensors is to coat the surface of crystal with antibodies or antigens, immerge to muster solution, binding to the immobilized antigens or antibodies and take place immuno - reaction, can cause a frequency change of the quartz crystal, and the frequency changes are proportional to content of antigens or antibodies in muster solution

    通常將抗體（或抗原）固定於晶體表面，浸入樣液時，與抗原（或抗體）產生免疫反應，使晶體表面質量負載增加，頻率降低，其頻移值與樣液中抗原（或抗體）含量成正比。
  14. Liberation of hydrogen gas would be increased rapidly and sic particles on the surface might be dispersed if the current density exceed the upper limit. furthermore, nickelous hydroxide would be deposited because the ph of plating solution nearby the surface rapidly increased. all of above might result in coating deterioration

    若電流密度過大，超過所允許的上限值，會析出大量的氫氣，可能沖散表面覆蓋的sic微粒，而且易使磨頭表面鍍液ph值急劇上升而形成氫氧化鎳沉澱，導致鍍層質量惡化。
  15. This indicates that rich zn2 + and poor mn2 + ions in the colloidal solution of zns : mn2 + nps is the key to obtain highly efficient luminescence and highly quantum yields. the research on the properties of surface modification may be helpful to the widely application of nano - sized materials in the future

    對納米材料表面修飾后發光性質變化的研究有助於更加深入地認識表面和表面態的實質及其對發光的影響機制，為進一步控制納米材料的表面，提高發光效率，創制理想高效的納米發光材料提供基礎的理論的指導，使得納米發光材料得到更加廣泛的應用。
  16. An empirical solution of characteristic values of wetted solum under surface drip irrigation

    地表滴灌土壤濕潤體特徵值的經驗解
  17. The sbf cultivation results by different surface modification methods were : nano - tio2 coating > alkali solution treatment > tio2 coatings sintered in normal pressure > tio2 coatings sintered in vacuum

    不同表面改性方法的sbf培養結果比較為：納米二氧化鈦塗層堿液處理方法常壓下燒結二氧化鈦塗層真空下燒結制備的塗層。
  18. A method of determining solution surface tension

    溶液表面張力測定實驗的方法改進
  19. Composites of ultramicro iron - coated hollow glass bead were in - suit prepared using atpu as surface agent by decomposing carbonyl iron in hollow glass beads and dmf mixed solution

    用atpu作表面活性劑，在中空玻珠存在下「原位」熱分解五羰基鐵制備出中空玻珠超微鐵核殼復合粒子。
  20. The infection of different concentration chitosan - acetic acid solution surface sizing to the technical feature of paper was studied

    摘要研究了不同濃度的殼聚糖醋酸溶液表面施膠對紙的技術性能的影響。
分享友人
分享到 Line

分享到臉書