solution treated alloy 中文意思是什麼

solution treated alloy 解釋
固溶處理合金
  • solution : n. 1. 溶解；溶液，溶體，溶劑。2. （補輪胎用的）橡膠水；〈美國〉藥水。3. 解決，解答 （of; for; to）; 解釋；（數學等的）解法，解式。4. 免除，解除。5. 【醫學】消散，消退。
  • alloy : n 1 合金。2 （合金中的）劣等金屬。3 （金銀的）成色，成份。4 〈比喻〉攙雜品。vt 1 合鑄，熔合（金屬...
  1. Copper - beryllium alloy wire and springs solution treated and precipitation treated

    銅鈹合金絲材及彈簧
  2. Copper - beryllium alloy strip, foil and parts solution treated and precipitation treated

    銅鈹合金帶材箔及零件
  3. Copper - beryllium alloy rods, sections and parts solution treated and precipitation treated

    銅鈹合金棒材型材及零件
  4. : copper - beryllium alloy strip, foil and parts solution treated, cold rolled : half hard and precipitation treated

    銅鈹合金帶材箔及零件
  5. Specification for castings of aluminium - silicon - magnesium alloy, sand cast solution treated and precipitation treated to an overaged condition

    砂型鑄造用鋁-硅-鎂合金鑄件規范
  6. The 2014 aluminium alloy treated by 500 solution and 165 ageing has fine alloy phases distributing equably, higher mechanical properties, thus the wear resistance is improved

    經500固溶和165時效處理后，其合金相分佈細小、均勻，力學性能較高，磨損時，在出現了犁溝的同時，還存在粘著剝落坑，磨痕最淺，耐磨性提高。
  7. Ecap was successfully used to refine ly12 alloy to 0. 5 m at room temperature after seven passes. the pretreatment process concluded from experiments was solution treated at 500 for 2h and overaging at 400 for 8h

    對普通高強度鋁合金ly12的室溫ecap的研究表明： ecap前的預處理對ly12室溫ecap的實現具有重要影響，採用500 2h固溶+ 400 8h過時效的預處理工藝，經七道次室溫ecap后，晶粒細化至0 . 5 m 。
  8. Copper - nickel - silicon alloy rods, sections and parts solution treated, cold worked and precipitation treated

    銅鎳硅合金棒材型材和零件
  9. : copper - beryllium alloy strip, foil and parts solution treated, cold rolled : full hard and precipitation treated

    銅鈹合金帶材箔及零件
  10. : copper - beryllium alloy strip, foil and parts solution treated, cold rolled : quarter hard and precipitation treated

    銅鈹合金帶材箔及零件
  11. Specification for castings of aluminium - silicon - magnesium alloy, chill cast solution treated and precipitation treated to an overaged condition

    冷鑄用鋁-硅-鎂合金鑄件規范
  12. The microstructures and properties of 2014 aluminium alloy, which is treated by different solution ageing technologies and used for racing bicycle ' s chain bar, were analysed by means of electron probe, mm2000 abrasion tester and so on

    摘要通過採用不同的鋁合金固溶、時效處理工藝，利用電子探針、 mm2000磨損試驗機等測試手段，對賽車鏈輪用2014鋁合金的組織性能進行了分析研究。
分享友人
分享到 Line

分享到臉書