spectral treatment 中文意思是什麼
spectral treatment
解釋
譜處理-
The uv - visible spectral evolution with particle radium was explained by exciton - coupling theory, it suggested that the change of crystal polymorphs was induced by nanofication - treatment. photoinduced discharge experiments showed a trend that the higher photosensitivity was corresponding to the smaller particle radium ( eg
利用激子偶合理論成功地解釋了納米化對酞菁氧鈦的uv - vis吸收光譜的影響，證明納米化改變了酞菁氧鈦的晶型。 -
Meso - tetra ( 4 - acyloxyphenyl ) pophyrin was prepared by usual procedure from acyl chloride and meso - tetra ( 4 - hydroxyphenyl ) porphyrin in benzene and obtained in 86. 4 % yield. treatment of the free base with zinc chloride in dimethyl formamide ( dmf ) - dichloromethane ( ch2cl2 ) yielded corresponding zinc porphyrin complex. the spectral data ( uv - visjr / h - nmr ) and elemental analysis are in agreement with the assigned structures
在合成工作基礎上，採用紫外可見光譜（ uv - vis ） 、紅外光聲光譜（ ftir - pas ） 、核磁共振氫譜（ ~ 1hnmr ） 、元素分析、摩爾電導等手段研究了卟啉及金屬卟啉材料的組成及結構。 -
In the light of field features in desertification areas, the data quality and band combination of different bands are assessed, the indicators, principles and methods for data assessment and band option are put forward to, and optional band combination for desertification monitoring is determined primarily. the data pre - treatment model for desertification monitoring is developed after studying the pre - treatment algorithm of restoration and rebuilding of hyperspectral resolution data. the spectral features and variation rules of different objects in experimental areas are understood and analyzed
針對荒漠化地區的地物特徵，對高光譜數據不同波段的數據質量、波段組合進行定性和定量的評價，提出用於數據評價、波段選擇的指標、原則和方法；初步確定一個適用於荒漠化監測的優化波段組合，建立適合於荒漠化監測的數據預處理模式；初步分析、掌握研究區內各類地物的光譜特性及變異規律；針對荒漠化地區特點對多種分類方法進行探討分析；建立荒漠化監測主要評價因子的定量反演模型。 -
According to structural characteristics of multi - phased alloy steels and the properties of ultrasonic propagation, microstructures characterization with different heat treatment processes ( normalizing, quenching / annealing, quenching plus low tempering, quenching plus high tempering ) for three steels ( 40cr, 38crmoal, gcrlssimn ) was studied experimentally by using ultrasonic methods. ultrasonic velocity, relative attenuation coefficient, and power spectral analyses were researched on the same samples respectively, on the basis of theory and experiment, the sensitivity and other characterizations of the three methods used to distinguish different microstructures were compared
根據具有多種相結構合金鋼不同熱處理轉變產物的組織特點，以及超聲波在其中的傳播規律，利用超聲波速度、相對衰減系數以及功率譜分析三種方法，對三種鋼（ 40cr 、 38crmoal及gcr15simn ）不同熱處理（正火、淬火退火、淬火+低溫回火及淬火+高溫回火）轉變產物的顯微組織進行了超聲表徵研究。 -
Because of the good sensibility, ultrasonic narrow band signal analysis technique with 1mhz central frequency was chosen to differentiate the heat treatment samples above - mentioned. there are obvious differences among heat treatment products in principal frequency, spectral peak ' s quantity, amplitude and distribution. that is to say, the technique of ultrasonic narrow band power spectral can be applied to characterize the microstructures of multi - phased alloy steels
利用窄帶信號頻譜分析技術靈敏度高的突出優點，選取中心頻率為1mhz的窄帶超聲信號，對上述不同熱處理試樣進行超聲功率譜分析，發現不同熱處理產物在功率譜主頻率、譜峰特徵（幅度、數量、分佈）等方面，都存在不同程度的差異。
分享友人