spherical joint 中文意思是什麼

spherical joint 解釋
球節
  • spherical : adj 球的；球面的；球形的，圓的；天體的；天空的。 a spherical bush 【機械工程】球面襯。 a spherica...
  • joint : n 1 接合，榫接合處，接合點。2 【解剖學】關節。3 【植物；植物學】節。4 【電學】接頭。5 【建築】接...
  1. 1. 1 2 14 npt transition joint connects with spherical cone

    1 . - 14npt與球錐連接過渡接頭
  2. Tube - plate - spherical joints is a special type of joint when gusset plate connections to slotted tubes is applying in large span structures

    管板球節點是管板節點應用於大跨結構的加強形式。
  3. Gusset plate connections to slotted tubes is one type of the composite joint configurations in tubular structures. it can meets in practice. this connection take place of tubular joints and welded hollow spherical joints in some special situation

    管板節點是管結構中一種混合節點形式，在實際工程中發揮了在特殊場合代替相貫節點、焊接空心球節點的作用。
  4. Spherical plain radial bearings, joint type, inch design

    連接型關節徑向軸承，英制
  5. During the analysis, three non - dimensional parameters is considered : the ratio of outer diameter of hollow spherical joint to the thick of spherical ; the ratio of outer diameter of hollow spherical joint to the thick of steel plate ; the ratio

    分析時考慮了三個無量綱參數，空心球外徑d與壁厚t的比值;空心球外徑d與鋼板厚tp的比值;連接鋼管外徑與空心球外徑之比。
  6. Investigation of rolling spherical joint

    灰色理論的工業設計評價演算法研究
  7. If the error of structural parameters of the spherical - wrist and the error of movement variables of every joint were comparatively big, there will produce rather big deviation in searching the posture error of end executor by the use of existed method

    如果球腕的結構參數誤差與各關節的運動變量誤差比較大，則應用現有的方法求取末端執行器的位姿誤差會產生較大的偏差。
  8. The robot of intervene come forth spherical joint and embranchment. in the paper, maximal angle of the robot of spherical joint when the robot is walking is given. when the span between two embranchments supers to each embranchment of diameter, the intervene ca n ' t happen

    針對這兩種情況給出了機器人在行走時不發生干涉的最大轉角45 ，兩個分支不發生干涉的條件是兩個分支中心線之間的距離大於每個分支的直徑。
  9. 3. spherical joint 13 place may be welded with lead pressure tube

    3 .球形接頭13處可與引壓管焊接
  10. 6. spherical joint 13 place may be welded with lead pressure tube

    6 .球形接頭13處可與引壓管焊接
  11. Overhead lines with nominal voltages exceeding 1 kv - methods and equipment for the installation of conductors - part 3 : cable couples with spherical joint

    額定電壓超過1kv的架空線.導體安裝的方法和設備.第3
分享友人
分享到 Line

分享到臉書