spin-coating 中文意思是什麼

spin-coating 解釋
旋塗
  • spin : vt （spun 〈古語〉 span; spun;spinning）1 紡。2 使（陀螺等）旋轉；使（車輪）打空轉〈在冰上，沙中...
  • coating : n. 1. 被覆，表皮，塗層；包覆物；（食品上的）面衣，糖衣；塗料。2. 上衣料；細呢，花呢。
  1. Preparation process of aerogel films for icf target by sol - gel spin - coating method

    靶用氣凝膠薄膜工藝研究
  2. Best concentration of ions is 1. 5mol / l and dispersant pvp monomer 0. 8mol / l. spin - coating speed, which affected the quality of limn2o4 film greatly, was also studied. it demonstrated that smooth limn2o4 film without cracks could formed under 2000 rotates / min with the solution cion = 1. 5mol / l, cpvp = 0. 8mol / l, what ’ s more, fewest spin - coating times were needed at that speed

    實驗結果表明:採用離子總濃度溶液為1 . 5mol / l ，聚乙烯吡咯烷酮單元濃度為0 . 8mol / l的溶液旋轉塗覆時，轉速在2000轉/分鐘時最佳，所得到的濕limn204薄膜平整光滑均勻，加熱后無龜裂現象。
  3. Then the gel film can be prepared by dip - coating or spin - coating technique on the surface of glass and followed by drying in the ethanol vapor

    使用浸漬提拉法或旋轉塗敷法，並通過放在乙醇蒸汽中乾燥，可在玻璃表面得到均勻的凝膠膜。
  4. And then, zno thin films were synthesize on quartz and silicon substrates by sol - gel dip - coating and spin - coating. the properties of the films and the effects of growth parameters on the quality of zno films were studied using x - ray diffraction, optical absorption, photoluminescence techniques, etc. to modify the energy gap of the zno, mg2 + was added in the sol - gel solution, and mgxzn1 - xo films were prepared by the same method as that for zno films

    利用溶膠凝膠法成功地在石英玻璃和單晶矽片等襯底上制備出了c軸擇優取向的zno薄膜，並利用x射線衍射儀、紫外-可見光光譜儀、熒光光譜儀等對zno薄膜的結構和性能進行了測試、分析，並研究了熱處理參數等條件對zno薄膜性能的影響。
  5. Based on the infrared anomalous dispersion of compact alumina film, the character of alumina sols and the processing for fabricating compact alumina film were studied by using sol - gel method, combining dip - dropping, spin - coating method and electrophoretic deposition techniques

    本文基於緻密氧化鋁膜的紅外反常色散特性，結合溶膠-凝膠技術，採用浸漬提拉法、旋覆法和電泳沉積工藝，對氧化鋁溶膠的性質和緻密氧化鋁膜的制備工藝進行了研究。
  6. The general analysis of dip - dropping, spin - coating method and electrophoretic deposition techniques shows that the compaction degree of alumina film fabricated by the former two methods are higher than those prepared by the last one. besides, spin - coating method is the most efficient and fast way to raise film thickness

    綜合分析提拉法、旋覆法和電泳沉積工藝，採用前兩種工藝制備的氧化鋁膜的緻密性優于末者，並且三者中旋覆法最能快捷有效地提高膜厚。
  7. To make cds / k4nb6o17 powder on the base of the k4nb6o17 powder which by the courses of ion exchanging, amine intercalation, sulfuration etc. to obtain cds / k4nb6o17 thin film through the same course of making cds / k4nb6o17 powder on the base of k4nb3o17 thin film on the quartz which made by the spin coating and after heat treatment. to make experiments with additives ( na2so3, 0. 1mol / l ) of photocatalytically decomposing water into h2 and o2 to evaluate the photocatalytic activities of the catalyst knb6o17 powder, cds / k4nb6o17 powder, k4nb6o17 film, cds / k4nb6o17 film. the crystalline structures of the midst powder and film productions were investigated by using the x - ray diffraction ( xrd )

    本課題的主要內容是：高溫固相反應合成具有層狀結構的k _ 4nb _ 6o _ （ 17 ）晶體材料，然後以此為母體材料，通過離子交換、層間胺插入、硫化處理等過程制備出cds / h _ 4nb _ 6o _ （ 17 ）粉末形式的光催化材料；通過旋轉塗覆法在石英玻璃基片上制備了k _ 4nb _ 6o _ （ 17 ）薄膜，採用一定的熱處理制度后對薄膜分別進行離子交換、層間胺插入、硫化處理等處理過程制備了cds / h _ 4nb _ 6o _ （ 17 ）薄膜形式的光催化材料。
  8. In this paper, organic small molecules and polymer films were prepared via electrostatic self - assembled method and spin - coating method. the characteristics of films are examined by uv - vis, pl, xps, raman and so on. and some theories are investigated with respect to organic molecules and polyionic deposition on solid surface and the photoelectric characteristics of organic ultrothin films

    採用紫外-可見光吸收光譜、熒光光譜、 x射線光電子能譜、拉曼光譜及低角度x射線衍射光譜等技術手段對有機材料及薄膜進行表徵和性能測試，分析了有機分子、聚離子在固體表面成膜性能以及有機超薄膜結構的光電特性等。
  9. Sensitivity to nh3 of tetra - tert - butyl - 5, 10, 15, 20 - tetraazaporphyrin lead spin - coating film

    四叔丁基四氮雜卟啉鉛旋塗膜的氨敏特性
  10. At last tcnq and snpc films as well as poly ( metheyl methacrylate ) ( pmma ) films doped by tcnq and snpc were prepared by spin coating method. the influence of different spin speeds on the sensitivity of organic film was studied

    最後本文採用旋塗法制備tcnq和酞菁錫兩種材料的敏感薄膜，並用這兩種材料對pmma （聚甲基丙烯酸甲酯）進行了摻雜，運用sem觀察了薄膜表面形貌。
  11. Lppp thin films were prepared by spin coating from a solution of lppp in toluene and alq was formed by vapor deposition. different configuration devices with lppp single - layer, lppp micocavity and lppp / alq heterojunction were fabricated

    利用lppp甲苯溶液旋塗制備lppp薄膜，真空蒸鍍法制備alq膜和電極，分別製作了lppp單層無腔、 lppp單層微腔、增強型lppp / alq異質結結構的有機電致發光器。
  12. ( 2 ) zno thin films were prepared on glass substrates by sol - gel spin - coating method. the optical properties and surface morphologies of the films were investigated using photoluminescence ( pl ), optical transmission spectra, and atomic force microscope ( afm ), respectively

    （ 2 ）利用sol - gel旋塗法在普通蓋玻片上生長了zno薄膜，用光學透射譜、光致發光譜和原子力顯微術研究了zno薄膜的光學性質和表面形貌。
  13. Results showed that the factors include : solvent and concentration of limn204 precursor solution, spin - coating speed, heating speed, sintering temperature and time etc. in the end, techniques of sintering under vacuum conditions were studied

    主要有以下幾方面:溶液中離子總濃度以及分散劑濃度對成膜質量的影響;旋轉塗覆時轉速、熱處理的升溫速度、燒結溫度、燒結時間對薄膜晶型結構及性能的影響。
  14. The result showed that the spin coating method was better relatively. the obvious blue shift of pl was found in spectra of the ps / pmma composite prepared with spin coating. compared to the spectra from original ps sample, the luminescence quenching was greatly decreased for ps / pmma composite due to the prevention to ps layer with coated with pmma film and modification of dielectrical penetrability of the medium in quantum threads by the pmma

    實驗結果表明，用旋塗法實現的pmma固化后再與多孔硅復合而制得的樣品的結果最好，它與原始的多孔硅樣品相比發光峰發生了藍移而且發光強度下降很小，我們認為pmma層有限的厚度和pmma對多孔硅表面的保護使復合后發光強度下降很小，而且制備的多孔硅pmma復合體系的發光強度幾乎不隨時間而下降。
  15. Firstly, choose an appropriate solution system to make a steady solution, and then limn2o4 film precursor was prepared on stainless steel by spin coating method with the solution

    在前驅體溶液體系選擇過程中，確定了最佳前驅體溶液體系組成;在最佳的前驅體溶液組成體系下，採用旋轉塗覆法在不銹鋼基體上制備前驅體濕膜。
  16. In this thesis, we investigated a pseudoisocyanine dye ( pic - br ) j - aggregates at a mica / air interface prepared by vertical spin - coating method

    在本論文中，我們研究一種異花氰染料（ pic - br ）使用垂直離心覆層的方法，在雲母空氣界面制備的j -聚集體。
  17. Lithograghy and its relative techniques play a very important role in mems fabrication processes, spin coating and baking are an indispensable working procedure before and after the lithography process. oven and hotplate are often employed in order to enhance adhesion between the film and the substrate, stabilize sensitivity of film and improve the abrasion resistance when the film touches a mask in contact exposure

    均膠和烘乾是光刻工藝中不可缺少的一道工序，為增加膠層與矽片表面粘附能力，提高在接觸式曝光中膠層與掩模版接觸時的耐磨性能及穩定膠層的感光靈敏度，通常採用烘箱或熱板等加熱設備對光刻膠進行乾燥。
  18. The different kinds of pyroelectric sensors were prepared on the porous silicon dioxide, plastic film and bulk silicon substrates respectively. the nanocomposite pclttp ( vdf - trfe ) film was deposited by spin - coating used as the sensing film, and ni - cr film was chosen as upper electrode and absorb layer

    分別在多孔氧化硅、 pet塑料和硅襯底上，制備納米陶瓷/ p （ vdf - trfe ）復合敏感膜的熱釋電單元傳感器。
  19. The spin coating is followed by a baking step to remove the solvent and, in some cases, to complete the polymerization

    接著以烘烤除去溶劑，有時候可以順便完成聚合反應。
  20. Thin films with thickness of 0. 31m and 0. 36m respectively on si substrate, have been successfully prepared by a sol - gel spin coating method. cubic nanocrystals can be obtained at relatively low sintering temperature with an average grain size of about 47 nm and 51 nm respectively. the aluminia - doped scsz thins film are the same dense as the scsz thin films. however, there are a small amount of pinholes found in the microstructure of the titania - doped scsz films

    0 . 70固體電解質納米晶薄膜。燒結實驗結果表明，兩種薄膜均在650以上開始晶化，溫度越高，晶化越完全，在800可完全晶化所得納米晶顆粒呈純的螢石結構立方相鋁和鈦摻雜的納米晶顆粒的平均大小分別為47和51nm 。
分享友人
分享到 Line

分享到臉書