spray valve 中文意思是什麼

spray valve 解釋
噴閥
  • spray : n 1 浪花，水花，水霧；霧狀物。2 【醫學】噴霧（液）。3 噴霧器；消毒器。vt 噴，噴射；使起浪花；噴霧...
  • valve : n 1 【機械工程】閥，活門，舌門；汽門。2 【解剖學；動物學】瓣，瓣膜；（貝）殼瓣；【植物；植物學】...
  1. This paper deriving the theory work inflection point in the static stage characteristics curve of small measurement range linear dimension measurement. by the way of high pressure and back pressure pneumatic measure and designed the parameter of the mainly and measure spray head, which are the key component in the spray head - baffle pneumatic sensor. the different groups for the main - spray head and the measure spray head, will effect the dynamic and static stage characteristic parameter. the author have done contrast experiment and optimization design to test and verify the theory derivation whereby made the rang of show valve of pneumatic measure system measure range up to 40 u m, the sensitivity up to 100mv / u m, resolution up to 0. 05 p m, the uncertainly of measure is less than 0. o2 u m, satisfaction of requirement of groups the carboy hatch thickness size precise measure of soft shims

    對高壓背壓式氣動測量用於小量程線性尺寸測量的靜態特性曲線的理論工作拐點進行了推導，對氣動測量系統中的噴嘴-擋板型氣動傳感器中的關鍵部件? ?主噴嘴和測量噴嘴的參數進行了理論設計，對主噴嘴和測量噴嘴的不同組合，將影響測量系統靜、動態特性指標的噴嘴參數進行了對比實驗和優化設計，並通過實驗驗證了理論推導，從而使氣動測量系統量程的示值范圍達到40 m ，靈敏度達到100mv m ，解析度達到0 . 05 m ，測量不確定度小於0 . 2 m ，滿足了壓縮機缸蓋軟體墊片厚度尺寸精密測量分組的要求。
  2. General specification for the control valve of automatic spray on hydraulic supports

    液壓支架用自動噴霧控制閥.通用技術條件
  3. In this dissertation, we mainly report on a laser - produced plasma ( lpp ) source with liquid aerosol spray target. for sufficiently high backing pressure and low temperature, the valve reservoir gas of the light source can undergo a gas - to - liquid transition

    液體微滴噴射靶激光等離子體（ lpp ）光源是一種具有較高的軟x射線轉換效率且能夠長期連續運行的低碎屑光源。
  4. Special water - saving valve, special shower head with strong spray power, using while bathing can put an end to waste

    專用節水閥、專用花灑，噴射力強，隨開隨用杜絕浪費。
  5. Solenoid valve 2, 3, 4, 5 links ; pneumatic control valve 2, 3, 5 links ; application of a variety of fluid valve ; manual valves 3, 4 links ; mechanical valve 3, 5 links ; pressure valve ; ambient 2 - way valve ; spray valves

    電磁閥2 3 4 5通氣控閥2 3 5通多種流體適用閥手動閥3 4通機械閥3 5通增壓閥集塵器2通閥噴塗用閥
  6. Fixed firefighting systems - components for sprinkler and water spray systems - part 2 : wet alarm valve assemblies

    固定消防系統.灑水器和噴水系統用元件.第2部分:濕式報警閥組件
  7. The results showed that the range of target finishing temperature can be provided and kept on in an energy - saving manner with lower frequency of spray nozzle opening if opening reversely but closing forwardly the cooling valve for inter - stand spray during water cooling

    對兩種截然不同的機架間噴水冷卻閥門開啟邏輯做了計算分析，結果表明，逆向開啟機架間噴水冷卻閥門，順向關閉閥門，能以較少的噴嘴開啟數達到終軋溫度目標范圍，並且可以節約能耗。
  8. The secondary combustion, which has better controllability, and plays the most pivotal role on the overall performance of a strutjet, so the paper detailedly studied and analyzed the mechanism of fuel ' s atomization, the mechanism of fuel ' s spray burning, vital spray burning models and the combustion ' s controllability, combined with the author ' s practical investigation in the rbcc lab, finally, the author got a most simple and feasible method to control the spraying burning of liquid kerosene - - to set up an adjusting valve in the fuel pipeline

    文中重點對燃油的霧化機理、燃油的噴霧燃燒機理、主要的燃燒模型和燃燒過程的可控性，展開了詳細地分析研究，並結合在rbcc實驗室的實際研究，獲得了對燃油噴霧燃燒進行調節的最簡單、可行的方法，即在燃油管路上設置流量調節閥。於是燃燒組織問題轉化為對該調節閥的開度如何施加適當控制的問題。
  9. The research indicated that, if the secondary combustion chamber was looked on as a controlled object, with the adjusting valve as a input, the pressure and the temperature of a selected point on the inside wall of the combustion chamber as outputs, then such controlled system would be a strongly non - linear, time varying system with number of random disturbances, which resulted in huge difficulty to build an analyzed mathematics model for the spray burning of the liquid fuel, so that classic control methods were all invalid

    研究表明，若將rbcc發動機的二次燃燒室視為一個控制對象，同時以燃燒室內壁面取定點處的壓強、溫度和調節閥的開度為輸入輸出變量，則該系統將是輸入?輸出特性非線性很強、隨機干擾嚴重的復雜時變系統。這導致建立燃油噴霧燃燒具體模型的很大困難，從而宣告了經典控制方案的失效。
  10. Loading tension force for supply and takingup unit, openning purge valve ( spray valve and gun valve ) and starting the cleaning buttom

    加載供線及收線系統張緊力，打開清洗閥（噴洗閥及槍閥） ，啟動清洗按鍵。
  11. Fixed firefighting systems - components for sprinkler and water spray systems - wet alarm valve assemblies

    固定滅火系統.噴灑器和噴水系統元部件.報警濕閥組件
  12. Fixed firefighting systems - components for sprinkler and water spray systems - part 2 : wet alarm valve assemblies ; german version en 12259 - 2 : 1999 a2 : 2005

    固定滅火系統.噴頭和噴水系統元部件.第2部分:報警濕閥
  13. Fixed firefighting systems - components for sprinkler and water spray systems - part 2 : wet alarm valve assemblies includes amendment a1 : 2001 ; german version en 12259 - 2 : 1999 a1 : 2001

    固定滅火系統.噴頭和噴水系統元部件.第2部分:報警濕
  14. Clean fuel spray nozzle and deposit on the valve, improve economical performance of fuel, eliminate shake and non - acceleration of engine, coordinate with advanced equipment to use

    清洗噴油嘴、氣門積炭，提高燃油經濟性，消除引擎喘抖，加速不良，需配備設備使用。
  15. 2 ) a simplified sprinkler system which is composed of water source, pipeline pump, pipes, current of water display, nozzle, contral valve, is suitable for our country. and its water is supplied by gravity tank or gravity tank or hydrant system or city 3 ) spray intensity of simplified sprinkler system is 3 l / min. m2, protection area of them is 50m2

    3 ）簡易自動噴水滅火系統的噴水強度為3 / min . m2 、保護面積為50m2 、噴頭的安裝間距為3 . 7m等參數。 4 ）簡易自動噴水滅火系統最大設計動作噴頭數為四隻，供水時間宜為30min等。
分享友人
分享到 Line

分享到臉書