standard signal amplifier 中文意思是什麼
standard signal amplifier
解釋
標準信號放大器-
Become a kind of new electronics circuit - current - mode circuit. it is replacing the traditional design method of the voltage - mode in the high frequency high - speed signal processing realm 。 this thesis mainly discussed the modified second - generation current conveyors based on the current - mode kinds of new cuicuit components, they are stronger modified standard current - mode parts in fuctions on this foundation. mainly including the modified differential difference current conveyor ( mddccii ) 、 the fully balanced second generation current conveyor ( fbccii ) 、 ( full balances ) four - terminal floating nullor ( fbftfn ) and the current differencing buffered amplifier ( cdba ), they are all function very strong standard current - mode parts, they all can provide some circuit functions of better than general operation amplifier, because they have the voltage importation and the current importation, therefore use it since can carry out the voltage - mode signal processing circuit expediently, can also carry out the current - mode signal processing circuit expediently, and have to increase the benefit bandwidth to accumulate more widely than the voltage - mode, but have their advantages more according to the current - mode filter of the modified current conveyor, because it constitutes in brief, the filter wave function is stronger and they are better than in general use operation amplifier of many advantages, be easy to composing for example 、 high speed 、 frequency bandwidth 、 the power supply voltage requests low 、 consume small, the impedance is different from etc. advantages, otherwise they have biggish dynamic range, and flexible circuit synthesize, so they are the best active parts
從第二代電流傳輸器ccii入手，重點研究了以下幾種改進型的第二代電流傳輸器:改進的差動差分電流傳輸器mddccii 、全平衡第二代電流傳輸器fbccii 、多輸出四端浮地零器ftfn 、全平衡四端浮地零器fbftfn 、電流差分緩沖放大器cdba的電路結構及其模型。然後在此基礎上系統地研究了基於這幾種改進型的第二代電流傳輸器的濾波器的設計方法，主要方法和結果如下:利用mddccii設計了差分式連續時間電流模式低通、帶通濾波器;電流模式跳耦結構考爾低通濾波器;利用fbccii設計了帶通二階節濾波器及電流模式雙二階通用濾波器;設計了基於多輸出端ftfn的電流模式二階通用濾波器電路;通過數字化開關選擇的基於fbftfn的電流模式通用濾波器;設計了基於最少個數電流緩沖放大器（兩個cdba ）的多功能通用電流模式濾波器及其在非理想因素情況下分析。設計濾波器的主要方法是採用級聯設計、運算模擬（信號流圖法）和反饋設計（跳耦法） 。 -
A new and particularly application friendly product is a sensor - measure - ment amplifier combination, which provides a ready to fit measuring unit with standard signal output
新型的利於應用的產品是傳感測量放大器結合的產品，它提供了標準信號輸出的待安裝測量單元 -
Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too
本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。
分享友人