standard test conditions 中文意思是什麼
standard test conditions
解釋
標準測試條件- standard : n 1 標準,水準,規格,模範。2 旗;軍旗,隊旗;【徽章】標幟,標記;旗標,象徵。3 【植物;植物學】...
- test : n 1 檢驗,檢查;考查;測驗;考試;考驗。2 檢驗用品;試金石;【化學】試藥;(判斷的)標準。3 【化...
- conditions : (旅遊合同中)條件或服務項目
-
Standard test method for determining anaerobic biodegradation of plastic materials under high - solids anaerobic - digestion conditions
在強溶解液真空降解條件下測定塑性材料的真空生物降解的標準試驗方法 -
Standard test method for resistance to deformation under static loading for structural wood laminating adhesives used under exterior wet use exposure conditions
室外潮濕條件下結構木材用膠粘劑在靜負荷下抗變形性的標準試驗方法 -
Standard test method for determining the leakage tendencies of automotive wheel bearing grease under accelerated conditions
在加速條件下測定汽車輪軸承潤滑脂滲漏傾向的標準試驗方法 -
Standard test method for corrosion of cast aluminum alloys in engine coolants under heat - rejecting conditions
在排熱條件下發動機冷卻劑對鑄造鋁合金腐蝕性的標準試驗方法 -
Standard test method for stability of water - in - oil emulsions under low to ambient temperature cycling conditions
在低溫至室溫循環條件下油包水乳劑穩定性的標準試驗方法 -
Standard practice for determination of volatile organic compounds excluding formaldehyde emissions from wood - based panels using small environmental chambers under defined test conditions
在限定的試驗條件下使用小型環境室測定由木基板散發的揮發性有機化合物 -
Standard test method for estimating the long - term change in the thermal resistance of unfaced rigid closed cell plastic foams by slicing and scaling under controlled laboratory conditions
受控實驗室條件下用限幅和定標法評定無面剛性閉室塑料泡沫的熱阻抗長期變化的標準試驗方法 -
It compares and analyses the equipment test voltage emendated to standard atmosphere conditions with the equipment nominal withstanding voltage. and then it concluded that : the emendation value educed by " humidity ratio " integrated emendation method is basically equal or close to the equipment nominal withstanding voltage ; but the values by two traditional emendation methods are mostly higher. it also proves that, " humidity ratio " integrated emendation method is more perfect than any other methods, and it can reflect the influence degree of atmospheric parameters on electrical equipment outer insulation discharge voltage actually
文中選擇「比濕」綜合校正法和兩種傳統校正法,分別對西高所為羊八井、拉薩、羊湖110kv變電所設備所做的人工氣候室模擬試驗數據及雲南中試所做的zs - 110工頻放電電壓試驗數據進行校正計算,將試驗電壓的校正值與試驗設備的標稱耐受電壓水平進行比較分析;認為: 「比濕」綜合校正法的校正值與設備耐受電壓水平基本相等或接近,而兩傳統校正法的校正值大多高於設備耐受電壓水平;進一步證明, 「比濕」綜合校正法是目前諸多校正法中較為完善的,能真實地反映大氣參數對電氣設備外絕緣放電電壓的影響程度的校正法,在高海拔電力工程設計中應推廣應用。 -
Standard test method for measurement of thermal stability of aviation turbine fuels under turbulent flow conditions hirets method 1, 2
在快速流動條件下測定飛行器渦輪機燃料的熱穩定性的標準試驗方法 -
Standard test methods for determination of transfer efficiency under general production conditions for spray application of paints
在一般生產條件下,塗料噴塗傳送效率測定的標準試驗方法 -
Standard test method for determining aerobic biodegradation of plastic materials under controlled composting conditions
在受控合成條件下測定塑料材料需氧的生物降解的標準試驗方法 -
Standard test method for direct shear test of soils under consolidated drained conditions
在固定排水條件下土壤直接剪切試驗的標準試驗方法 -
Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin under impulse conditions
在脈沖條件下石油成因的絕緣油的電介質擊穿電壓的標準試驗方法 -
Recp standard test method for determination of unvegetated rolled erosion control product ability to protect sand from hydraulically - induced shear stresses under bench - scale conditions
利用臺式標稱液力感應剪應力測定無塗層軋制防沖刷製品 -
Performance test methods for reciprocating internal combustion engine - standard ambient conditions and declarations of power, fuel consumption and lubricating oil consumption
內燃機臺架性能試驗方法標準環境狀況及功率燃油消耗和機油消耗的標定 -
Standard test method for resistance of protective clothing materials to permeation by liquids or gases under conditions of continuous contact
連續接觸條件下防護服材料耐液體或氣體滲透的標準試驗方法 -
Standard test method for determining anaerobic biodegradation potential of organic chemicals under methanogenic conditions
在甲烷條件下有機化學藥品厭氧生物降解潛力測定的標準試驗方法 -
Standard test method for resistance of protective clothing materials to permeation by liquids or gases under conditions of intermittent contact
間斷接觸條件下防護服裝材料耐液體或氣體滲透性的標準試驗方法 -
Standard test method for determining biodegradability of materials exposed to municipal solid waste composting conditions by compost respirometry
用混合物吸收計測定暴露于城區固體廢物銷毀條件用生物降解能力標準測試方法 -
Standard test method for determination of corrosion and fouling tendency of cooling water under heat transfer conditions
在傳熱條件下測定冷卻水的腐蝕和污染傾向的標準試驗方法
分享友人